Pearl D-1500TGL User manual

PEARL DRUM THRONE
D-1500TGL/D-1500RGL
Congratulations on your purchase!
To get optimum performance from your Drum Throne,
please read this Instruction Manual before playing.
Instruction Manual
Seat
Gas-Lift Post
Gas-Lift Post
Seat
Height Adjustment Lever
Height Adjustment Lever
D-1500TGL
D-1500RGL

Never touch the Release
Button of the Gas-Lift Post.
Doing so may cause it to
extend rapidly and could result
in personal injury (Fig 3).
Always ensure the Protective
Cap is installed onto the
Gas-Lift Post after removing
the Seat (Fig 3).
CAUTION
Hold the Seat with both hands and insert the Seat
Bracket onto Gas-lift Post. Tighten Wing-Bolt on the
Seat Bracket to secure the seat (Fig.2).
Remove the Tape and Protective Cap located at the top
of the Gas-Lift Post (Fig.1).
Mounting the Seat
Raising the Seat: While sitting on the Throne, gently lift
your body-weight off the seat while remaining in contact
with the seat. Next, pull the Height Adjustment Lever to
raise the seat to the desired height, then release it to hold
the adjustment (Fig 4.).
Lowering the Seat: Sitting on the seat, pull the Height
Adjustment Lever while putting your weight on the seat
cushion to push it downward. Once the desired height
is achieved, release the Height Adjustment Lever to
hold the adjustment (Fig4.).
Height Adjustment
NOTE
・The Protective Cap must be removed from the Gas-Lift Post
before attaching the seat top. Failure to do so will prevent
the height-adjustment function from working correctly.
・Keep the Protective Cap for Throne transportation. To
transport the Throne, adjust the seat height to the lowest
setting. (See Height Adjustment.) Next, remove the seat
cushion and stow. Then reinstall the Protective Cap onto
the top of the Gas-lift Post, use tape to hold it in place and
to secure the setting.
NOTE
・Routinely check the Wing-Bolt to ensure it remains tight for
increased stability during use and transport.
NOTE
・Routinely check the Allen Screws using a 5mm wrench to
ensure they are tight for tripod stability.
・The Gas-Lift Post comes pre-lubed for smooth function and
adjustment.
1.
2.
Allen Screw
Allen Screw
Height
Adjustment
Lever
Gas-Lift Post
Release
Button
Seat Bracket
Wing-Bolt
Fig.1
Fig.2
Fig.3
Fig.4
Gas-Lift Post
Tape
Protective Cap

http://www.pearldrum.com
Products and specifications are subject to change without notice.
Printed in China
-20-04-
Use extreme caution when setting your Throne on
uneven or slanted floors to prevent the Throne
from tipping and causing possible injury to the
user.
The Drum Throne is intended for seating while
playing drums only! Do not use it as a ladder,
footstool, or in any manner other than its intended
use.
Make sure all screws and bolts are tight and
secure before use.
When folding the tripod legs, be careful not to
pinch your fingers between the legs and the stand.
To prevent injury to your fingers when handling
tubular hardware, never insert your fingers into
the tubes.
CAUTION