Pearl Roselyn User manual

ROSELYN
All fittings must be installed by a competent
person, in accordance with current IEE wiring
regulations. If in doubt, consult a qualified
electrician.
Switch off the electrical supply at the mains
BEFORE installation and maintenance.
Suitable for Bathroom Zones 2, 3 and non
bathroom/ dry areas. See diagram below.
DO NOT connect to a plug and socket outlet.
NOT suitable for above baths (Zone 1) nor for
installation saunas, steam rooms or shower
cubicles.
Rated IP44 and suitable for indoor use only.
Do not fix to damp or conductive surfaces.
Never cover the mirror.
Site well away from curtains and fabrics.
lifewithpearl.com
Roselyn User Manual
Voltage / Tension: ~ 120V
Frequency / Fréquence: 60 Hz
Wattage / Puissance en watts: 24 W
Lamp / Lampe: 12v DC LED Light Strip
WARNING:
MIRROR SPECIFICATIONS
MIRRORS
Zone
2
Zone
2
Zone
2
Zone
1
Zone
2
Zone
3
60cm radius
225cm 75cm
60cm 60cm

Switch off the electrical supply at the mains before beginning.
Carefully read through the warnings and precautions on the rear on
this instruction manual.
Inspect the product immediately upon receipt for transit damage,
missing parts or manufacturing faults.
Handle the product with care and protect against knocks to all sides
and edges of the glass.
Fixings supplied are for use in solid walls, hollow or stud walls will
require specialist fixings available from your hardware supplier.
Make sure that you have all the tools you need to complete the job
(See below).
Ensure there are no hidden pipes or cables in the wall before drilling.
If drilling holes in ceramic tiles use a piece of masking tape on the tile
to stop the drill bit from slipping.
INTRODUCTION
BEFORE YOU BEGIN
TOOLS REQUIRED
HOW TO USE MAINTENANCE
To turn the LED light off and on simply tap
on the square located on the lower front of
the mirror.
The LED lights can be adjusted between
three colour temperatures, 3000k, 4000k
and 6000k. To toggle between them, press
and hold the on/off button.
Electric Drill Safety Glasses
Thank you for purchasing an authentic Pearl® LED mirror. Crafted from
high quality materials each component is carefully inspected before
leaving the factory.
Please read the instructions carefully to prevent malfuntion or damages.
Philips Screwdriver
Level Tape Measure
Pencil
Measure the distance between the
two ends, this mirror can be hung
horizontal or vertical.
Slide the mirror down onto the
bracket, check if secure. Attach
mounting peg to strab as needed.
A: Connect the wires properly to
their corresponding colour.
B: Lift the mirror above the bracket.
A: Insert wall plugs
B: Insert screws into mounting bracket
Using a pencil and a level, mark the
desired position on the wall with the
mounting bracket.
A: Drill the holes for the mounting
bracket.
B: Seperate lid and unscrew
Clean using a soft dry cloth only
when turned off. Never use cleaning
agents or abrasive materials. Do not
allow moisture to come into contact
with the lamps.
6
5
B
A
4
B
A
Ø 6mm
B
A
3
y
H
2
y
1