PEERLESS VPM 25-W Guide

ISSUED: 05-19-04 SHEET #: 081-9031-2 08-31-04
For customer service call 1-800-729-0307 or 708-865-8870.
Visit the Peerless Web Site at www.peerlessindustries.com
1 of 5
R
This product is intended for use with UL
Listed products and must be installed by a
qualified professional installer.
Read instruction sheet before you start installation and assembly.
Maximum Load Capacity:
50 lb (22.7 kg)
Models: VPM 25-W,
SVPM 25-W
DVD/DVR/VCR Mount for
Slimline®Standard Wall Mount
Installation and Assembly -
DVD/DVR/VCRMOUNT
SLIMLINEWALLMOUNT
Installing a Single DVD/DVR/VCR Mount .......................................................................................................... page4
Installing Multiple DVD/DVR/VCR Mounts......................................................................................................... page5
WIDTH (W) HEIGHT (H) MAXIMUM MINIMUM
13.25" - 17.25" 1.5" - 2.75" 17.25" x 2.50" 13.25" x 1.5"
(337 mm - 438 mm) (38 mm - 70 mm) (438 mm x 64 mm) (337 mm x 38 mm)
INSIDE DIMENSIONS MEDIA PLAYER DIMENSIONS

ISSUED: 05-19-04 SHEET #: 081-9031-2 08-31-04
For customer service call 1-800-729-0307 or 708-865-8870.
Visit the Peerless Web Site at www.peerlessindustries.com
2 of 5
F
E
D
H
I
A
C
G
B
VPM 25-W SVPM 25-W
Description Qty. Part Part
ADVD/DVR/DVR mount 1 081-0072 081-0073
Bhanger bracket 1 1245-271 1245-271
CM5 x .8 x 12 mm phillips screw/washer combo 4 520-1030 520-1030
D#10-24 x 1/2" carriage bolt 4 520-9523 520-9523
E#10-24 nylock nut 4 530-9341 530-9341
F#10 SAE washer 4 540-9400 540-9400
GM5 x 1" penta-pin™ tool driver 1 – 520-9249
H1.5" x 4.5" x .125" adhesive foam 2 599-1122 599-1122
I.375" x 12.75" x .125" adhesive foam 2 599-3802 599-3802
Parts List

ISSUED: 05-19-04 SHEET #: 081-9031-2 08-31-04
For customer service call 1-800-729-0307 or 708-865-8870.
Visit the Peerless Web Site at www.peerlessindustries.com
3 of 5
Peelandplace four piecesofadhesive foam (H, I) on the horizontalcrosssupport and vertical adjustersasshown
infigure 1.1 and1.2.
fig 1.1 fig 1.2
HORIZONTAL
CROSS
SUPPORT
VERTICALADJUSTER
H
I
Slidehanger bracket (B) ontoarm,underneaththe tray.AttachDVD/DVR/VCR mount (A) to hangerbracket(B)
using four M5 x 12 mm screw/washer combos (C) as shown below.
A
B
SLIMLINEWALL MOUNT
C

ISSUED: 05-19-04 SHEET #: 081-9031-2 08-31-04
For customer service call 1-800-729-0307 or 708-865-8870.
Visit the Peerless Web Site at www.peerlessindustries.com
4 of 5
Adjust size of DVD/DVR/VCR mount (A) to fit media player by loosening vertical and horizontal adjustment screws
whereshown in figure2.1 on both sides.Insert media playerandalign front ofplayerwith front ofTVon Slimline®
wallmount. Tighten vertical andhorizontaladjustmentscrews where shown infigure2.2on both sides untilplayer
securely fits in mount.
Note: TV and Slimline wall mount not shown in illustrations.
MEDIAPLAYER
fig 2.1
fig 2.2
Installing a Single DVD/DVR/VCR Mount
A
A
HORIZONTAL ADJUSTMENTSCREW
VERTICALADJUSTMENTSCREW
HORIZONTAL ADJUSTMENTSCREW
VERTICALADJUSTMENTSCREW

ISSUED: 05-19-04 SHEET #: 081-9031-2 08-31-04
For customer service call 1-800-729-0307 or 708-865-8870.
Visit the Peerless Web Site at www.peerlessindustries.com
5 of 5
If adhesive foam (H) is covering slots, trim foam (H) to expose slots. Insert four carriage bolts (D)into
slots of upper DVD mount (A). Loosely attach lower DVD mount (A) using four #10 SAE washers (F)
and #10-24 nylock nuts (E). This will allow access to the vertical adjustment screws of the upper mount
by being able to easily move the lower mount. Note: TV and TV mount not shown in illustrations.
Installing Multiple DVD/DVR/VCR Mounts
Adjust size of the upper DVD mount (A) to fit media player by loosening screws on both sides. Insert
mediaplayerand align front ofplayerwithfrontof TV on TV mount.Tightenverticalandhorizontal
adjustment screws where shown on both sides until player securely fits in mount.
Note: To access the vertical adjustment screws of the upper mount, slide the lower mount to the side.
Repeatforthe opposite side.
Centerlower DVD mount(A) and securely tightenfour nuts (E).Repeatbeginningof this steptoinstall
the media player into the lower DVD mount.
©2004PeerlessIndustries,Inc.Allrightsreserved.
PeerlessandSlimlineareregisteredtrademarksandPenta-PinisatrademarkofPeerlessIndustries,Inc.
Allotherbrandandproductnamesaretrademarksorregisteredtrademarksoftheirrespectiveowners.
UPPERMOUNT(A)
LOWERMOUNT(A)
H
VERTICAL
ADJUSTMENT
SCREW
DETAIL 1
E
D
F
• Do not stack more than three DVD/DVR/VCR Mounts
froma TV mount.
WARNING
• Stacked load cannot exceed 50 lb.
WARNING
UPPERMOUNT
LOWERMOUNT
MEDIAPLAYER
HORIZONTAL ADJUSTMENT
VERTICALADJUSTMENT