PEERLESS LCT Series Guide

Max Load Capacity: 25 lbs (11kg)
3215 W. North Ave. • Melrose Park, IL 60160 • [phone] or [phone] • Fax: [phone] • www.peerlessmounts.com
ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06
Installation and Assembly:
LCT Series LCD Arm
Model: LCT-102, LCT-103, LCT-104, LCT-102-KIT
Note: Read entire instruction sheet before you start installation and assembly.
• Donot begin toinstall your Peerlessproduct until youhave read andunderstood the instructionsand warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
callPeerlesscustomer service at 1-800-729-0307.
• Make sure that the desk will safely support the combined load of the equipment and all attached hardware and
components.
• Neverexceed theMaximum Load Capacityof25 lb (11kg).
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screwsfirmly,butdo not overtighten.Overtighteningcandamage the items,greatlyreducing their holding
power.
• Special precaution on the overall balancing of the arm assembly must be taken when adjusting the swing angle of the
crosswings. (Please refer to section IV -Adjustment Details.)
• During the installation, beware of the arm body recoil when attaching or detaching the LCD monitor to the LCDArm.
When changing LCD panels in the LCDArm, please always re-adjust the gas strut to a lowest force level to control
the recoil of the arm body.The LCD arm gas strut has been adjusted with the reserved force to load the original LCD
panel, and the LCDArm body will be recoiled when detaching the LCD panel directly without adjusting the gas strut.
• Do not attempt to disassemble, service or modify the product yourself.
• Use only a slightly damp cloth to clean theArm surface. Never use flammable solvents like alcohol, beneze, thinner,
etc.
WARNING
Forcustomer care call(800)729-0307 or [phone].

2 of 13 ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06
Type 1 - Desk Clamp
(ACC 916 - Sold Separately)

3 of 13 ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06
Type 2 - Desk Bolt
(ACC 915 - Sold Separately)

4 of 13 ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06
Type 3 - Desk Stand
(ACC 917 - Sold Separately)
FRONTOFSTAND
NOTE: Screensshould be balancedand face the
frontof thestand

5 of 13 ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06

6 of 13 ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06

7 of 13 ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06

8 of 13 ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06

9 of 13 ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06

10 of 13 ISSUED: 05-25-05 SHEET #: 090-9104-4 02-24-06