5 of 38 ISSUED: 12-11-08 SHEET #: 095-9287-2 06-02-09
(132 mm) above the desired screen center to locate
center points of the top mounting slots as shown in
level wall mount and mark center of four mounting
holes. NOTE: Be sure arms of wall mount (A) are
Insert anchors (D
mount (A
screws (C) as shown right. Make sure wall mount
1.3. NOTE: Flanges of adapter plate indicate top of
mount.
D
A
C
g.1.3
1
1
3
2
D
Drill holes and insert anchors (D).
Place plate (A) over anchors (D) and secure with screws (C).
Tighten all fasteners.
A
D
C
concrete
surface
Installation to Solid Concrete or Cinder Block
concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount
hammer drill to avoid breaking out the back of the hole when entering a void or cavity.
and components.
WARNING
CUTAWAY VIEW
INCORRECT CORRECT
wall
plate
wall
plate
plaster/
drywall
plaster/
drywall
concrete concrete
but do not overtighten
screws, greatly reducing their holding power.
directly
to load-bearing concrete.
concrete covered with plaster, drywall, or other
shown below. Be sure concrete anchors do not
pull away from concrete when tightening screws.
custom fasteners must be supplied by installer (not
evaluated by UL).
WARNING
