1D Wireless Barcode Scanner
User Manual
Version (Customized)
Power Off
(Note: Scan this barcode, scanner will make
a long beep, then power off)
Introduction
This barcode scanner provides a precise and complete
solution with easy-using、fast data-recording and saving
for computer information system. The scanner supplies
three scanning mode: Button-trigger mode、Auto-
continuous mode and Auto-flash mode ,and the default one
is Button-trigger mode
The blue light will bright when the scanner in non-
charging and standby. When you press the button to scan
bar code, the blue light will turn off. When it standby and
charged, the blue light change to red. When it charged and
you press the button to scan, the light show red, loose the
button, the light show purple
The scanner will turn off in 20s with a long beep if it not
work. If you want to use it again , just press the button, and
two beeps will be heard.
All parameter settings of the scanner can finished by
scan the setting barcodes, and saved in the storage memory,
and still keep settings after power off.
This is a easily user manual for this scanner, if you need
more details about how to use ,please get the manual from
distributors, or download from our official website
1、Scan Factory Default”“
Forced Pairing
One scanner pair with one receiver
Factory Default
2 Pull and plug receiver to PC
3、When blue indicator light of DATA in receiver flashing
continuously, to scan “Forced Pairing”, this step will
clear away the previous pairing, and finish the present
pairing, after pairing succeed, the scanner will make a
sound of “Beep”
、
Note: After pairing succeed, the blue indicator light
DATA in receiver will flash (about 1time/sec),
then open a text to scan needed barcode, in
this case blue light flash too, and the data can
be seen in the text.
of
Inventory Mode
Upload all data and cleared
(Note: Upload all data stored and clear them)
Upload all data and no cleared
（Note：Upload all data stored but do not clear them）
Upload one data and cleared
(Note: Upload one data stored and clear it)
Upload one data and no cleared
(Note: Upload one data stored but do not clear it)
Display the number of barcode to be uploaded
Clear
Data Saving Setting
Scanning Mode
Button Trigger Mode (Default)
Auto-Continuous Scanning Mode
Auto-Flashing Mode
Successful data upload indicate (two beeps)
（Note：There is two beeps after data uploaded succeed）
Sound On (Default)
Sound Off
Sound Louder
Sound Lower
Buzzer
Successful data upload indicate (one beep)
（Note:There is one beep after data uploaded succeed）
USA (Default)
Germany
France
Keyboard Mode
Language Choice
www.pegasustech.net
