Penton UK Ltd PCL5/T User manual

Penton UK Ltd
Unit 2 Teville Industrials | Dominion Way | Worthing | West Sussex | BN14 8NW
T: [phone] | F: [phone] | E: [email protected]
www.pentonuk.co.uk ISSUE MAY 2010
INSTALLATION
INSTRUCTIONS
ROUND PLASTIC
CEILING
Loudspeaker
f
STEP 2
Remove the metal grille from the front of the loudspeaker by
pushing all the rotary compression clamps down towards the
grille.
unit:mm
f
STEP 5
On mounting the speaker replace the snap fit grille.
f
STEP 3
Once the grille has been removed connect the 100 volt line
input cable to the required tapping via the terminal block
shown in the circuit diagram.
f
STEP 4
The loudspeaker is ready to be pushed up into the cutout
prepared earlier. Ensure that all compression clamps are fully
extended to allow for the ceiling thickness. Once the
loudspeaker is in position use a cross headed screwdriver
and turning it in a clockwise motion you will observe that the
clamps will pull down and lock the loudspeaker into position.
f
STEP 1
Cut a hole in the ceiling 168mm diameter.
Compression
Clamp
Front View with grille removed
Circuit Diagram
Side View
168 Dia (cutout)
80
203
100V COMMON
6W
3W
1.5W
0.75W
0.25W
PCL5/T