Perfect Prime MW0002 User manual

1
Microwave Leakage Detector Manual : MW0002
www.perfectprime.com for product register and warranty
Customer Service: [e-mail]

2
Introduction
It is important to check for any possible microwave leakage from
various sources such as mobile phones, computer and microwave
ovens etc, since excessive leakage may lead to severe health
problems (e.g. Cancers). Microwave not just only affects the weak
like expectant mothers, but also harm a healthy adult.
This Microwave Leakage Detector can be utilized for verifying any
leakage from any sources within a few minutes, workers and even
normal citizens can both benefit from this product.
Features
“Beeping” sounds ring out and red LED glows if
leakage volume is within the dangerous zones
Easy operation with few buttons
Do not require calibration
High sensitivity
Reliable due to high accuracy
Specifications
Detect Range : 2,450 MHz
LCD digital screen
Measurement Rage : 0 to 9.99 mW/cm2
Beep warning level : 5.0 mW/cm2
Accuracy : +/- 1 db
Power : 9V Battery
Battery Life : Approx. 1 year

3
Safety precaution and consideration
Electronic sensors and microprocessors used in
the product belong to precision electronic
device. Therefore:
--> product must be kept away from water,
fire, inflammable oil and gas or sites
with strong electromagnetic
interference,
--> to prevent influence on/damage to the
device.
Do not dismantle and remodel the product
without authorization.
Please use damp cloth or weak soap to clean
the enclosure of the device; do not use
abradant, isopropanol or solvent to clean.
Battery
Slide open the battery cover at the back, Insert
a 9V battery and close up the cover
Measurement
Press the “Power” button to turn on
Press the “Light / ZERO” button to turn on the
backlight LED for convenience
Press the “Light/ZERO” button for 3 seconds
to reset the meter to initial zero reading
Place the detector about 2 inches from the
source, the detector will detect microwave
energy and display the result on the LCD

4
If the detected level is high than the warning
level, red LED will flash and beeper will ring out
Maximum reading function
Press the “MAX” button can HOLD the
maximum reading of detected microwave
during the process
Press again can release the maximum reading
and back to normal usage mode
Automatic power off
The detector will power off automatically after
10 minutes
Disclaimer : The detector provides easy and quick checking of
microwave from appliances or other sources. If in doubt of any
possible microwave leakage, please do not hesitate to contact the
original supplier or qualified technicians to iron out the problems.