Perfect Water Technologies Home Master Jr. Series User manual

Page 4
Home Master®Jr. Series Installation & Service Manual
Perfect Water Technologies,
Inc.
1-877-693-PURE Copyright
© 2021
Home Master®Jr. Series
Filter Change
Instructions
Perfect Water Technologies
Home Master Jr. Filter Change Schedule:
www.theperfectwater.com/which-filter-change-set-do-i-need.html
Page 1

Page 2
Home Master® Jr. Series Installation & Service Manual
Filter Change Instructions
NOTE: Do not filter hot water through your Home Master Jr.
Tools Required:
•Towel
•Unscented Bleach, H202 (or other non-toxic
cleaner)
1. Turn off water supply to filter.
2. Unscrew housing by hand. “Righty-tighty, lefty-loosey” If
the housing is stuck, try using a rubber gripper pad on each
end (available at no extra charge upon request). Also, try
soaking the housing in hot water. Worst case, you may send
the entire unit to us for servicing. Please call to inquire.
3. Remove used cartridge and discard. Remove O-ring from
sump and wipe groove and O-ring clean.
IMPORTANT: This step is important to ensure proper seal
of the filter. Ensure the O-ring is seated level in the groove.
If O-ring appears to be damaged or crimped it should be
replaced at this time.
Lubricate O-ring with a coating of clean silicone grease. Do
not use Vaseline or petroleum-based lubricant. Place O-ring
back in sump, and press firmly into groove using two
fingers, all the way around.
4. Rinse out housing and fill about 1/3 full with water. Add 2-3
tablespoons of bleach and scrub thoroughly with a CLEAN
brush or sponge. Rinse thoroughly and allow to air dry.
Home Master®Jr. Series Installation & Service Manual
5. Insert a new cartridge into the sump making sure that
it it slips down over the standpipe. If the
filter has an orientation arrow, make sure
it is pointing towards the inlet and outlet.
Usually this means that the arrow will be
pointing down when in service.
6. Screw the sump onto the cap and hand-tighten.
7. Turn on the water supply slowly, to allow housing to fill
with water.
8. Run water up to 20 minutes or until water runs clear
and is free from air bubbles.
9. Check for leaks before ending installation. If unit leaks,
replace with a new O-ring.
CONTACT US:
Phone: [phone]
Email: [email protected]
Live Chat: https://direct.lc.chat/6498911/
Page 3