Perlesmith PSDS2 User manual

Installation Instructions
V1.0
PSDS2
Thank you for choosing our product! We strive to provide the best quality
and services for our customers. Would you kindly share your experience
on Amazon if you are satisfied? Should you have any issues, please don't
hesitate to contact us.
Telephone：[phone] Mon-Fri 10am - 6pm (PST) (USA)
Email：[email protected] (US/CA/DE/UK/FR/IT/ES/JP/AU)

14
7
10
11
2
58
3
6
9
x 2
x 2 x 2
x 2 x 2
x 3 x 3
x 4
x 1
x 8
x 3 x 2
Component Checklist
STEP 1
Glass shelf
Connector
Bolt Concrete Anchor Washer Connector
Rubber pad Screw Screw
Glass bracket Wall Brackets End cap
Find the stud by the stud finder
and mark the center.
1A : MOUNT WALL PLATE ON SINGLE STUD
3
Use wall plate ③ to mark three mounting hole
locations.
21
3

9
11
3
3
1B : MOUNT WALL PLATE ON CONCRETE
Drill pilot holes using a 1/8 in. (3.2 mm)
diameter drill bit.
Secure the wall mount with
the lag bolt.
4
3
1/8 in.
Ø3.2 mm
2.2in. (55mm)
Level
Drill 3 pilot holes into concrete
wall.
Use wall bracket holes to mark 3 mounting locations.
Use level to ensure proper alignment. if needed. 2
1
Secure 3 wall anchors into drilled holes
with hammer.
3Secure wall bracket to concrete wall
using screws by phillips screwdriver.
4
1/8”
(3.2mm)
2 3/8”
(60mm)
3/8”
(10mm)
2 3/8”
(60mm)
10
11
9
10
3

STEP 2
THESE SCREWS MUST
BE TIGHTENED.
4
4
6
7
1
Secure the screws and the connector
STEP 3
Attach the glass brackets to the wall brackets.
Put glass bracket above wall bracket and let
the glass bracket slide down.
STEP 4
Attach the end caps Paste the rubber pad 6 onto the glass
bracket
STEP 5
STEP 6
Secure the screws and attach the glass shelf to the glass Brackets.