petgugu PF2 User manual

PF2 Intelligent Pet
Feeder Manual
Please read this manual carefully
and keep it properly before using the product.

Federal Communications Commission
(FCC) Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generate, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user5s authority to operate this
equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment must be installed and operated in
accordance with provided instructions and the antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm
from all persons and must not be collocated or operating in conjunction with
any other antenna or transmitter.

Contents
Use Safety Instructions
List of Parts
Product Introduction
Product Use
Product Placement Instructions
Key Description
Indicator Description
Connect to App
Maintenance
Basic Parameters
FAQ
Maintenance Record
Services And Support
1
2
2
4
6
7
8
9
9
13
14
15
15

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1 1.
12.
13.
14.
1
All accessories of this device are not edible.
Please install and use this device strictly according to the
instructions.
This device is not recommended for pets within three months.
Please use this device indoors in a dry environment.
Please keep this device horizontally during use, and do not tilt or
overturn it.
Please store the power cord properly, so as to avoid electricity
leakage caused by pet biting.
Please do not put items other than pet food into food storage
bucket, which will result in abnormal use of device.
To prevent pets from throwing down the device, it is
recommended to place the device in the corner or against the
wall.
Please do not touch the pet food outlet when the device delivers
the food.
The host of this device is prohibited from soaking in water.
It is forbidden to place heavy objects in the food bowl, so as not
to affect the weighing function.
If children use this device, please make sure to use it under the
guidance of adults.
Please do not use any non-special accessories. Our company is
only responsible for the performance and safety of the accessories
provided officially.
No one except for maintenance personnel shall disassemble and
repair the device to avoid accidental injury.
* Please observe the following terms and conditions to avoid that
the product cannot be used normally or have any other accidental
loss.
Use Safety Instructions

List of Parts
Host Adapter Drying Box ManualFood Bowl
2
Product Introduction
Microphone
Pet Food Outlet Light Speaker
Wi-Fi Indicator
Work Indicator
Fill Light
PF2 Intelligent Pet
Feeder Manual
Pleasereadthis manual carefully
andkeepit properly before using the product.

Camera
Food Output Key
Wi-Fi Networking
Key
Uncovering Key
Food Bowl
Food Bucket
Locking Key
Upper Cover
3
Drying Box
Food Storage Bucket
Silica Gel Impeller
Unlocking Key
Impeller Cover
Weighing Platform

4
Power Interface Type-c Input
Interface
Wire-Wrap Board
Product Use
Connect the power adapter1.
Take out the power adapter and plug
it into the power interface at the bottom
of the host.
Install the host2.
①. Please place the host on a
horizontal surface.
②. Put the food bowl on the
weighing platform of the host.
(As shown below)

5
Open the upper cover3.
Pull up the cover opening key and
lift it up.
Put in the drying box4.
①.Lay the upper cover flat, rotate the
unlocking key clockwise by 60°,
and put in the drying box.
②. Rotate the arrow symbol [ ] of
unlocking key, and align it to the
locking symbol [ ] to complete
the locking.
Add pet food5.
Add the pet food. (Pay attention to
the size of pet food)
Cover the upper cover6.
Lift the upper cover key and close
it downward.

6
Manual feeding7.
Click the food output key to output
the food; deliver one piece of food
at a time.
Note: External connection of
mobile power supply
Can be connected with external
mobile power supply to prevent
device from being unusable
during power failure.
Insert the Type-c output interface
of the mobile power supply into the
Type-c input interface at the bottom
of the host.
Product Placement Instructions
Placement reminder:
1.
2.
3.
There should be no foreign bodies (such as food, etc.) stuck at the
bottom or edge of the food bowl.
The device should be placed on a stable and hard horizontal plane
and there should be a distance of more than 3cm kept from other
objects (such as walls, etc.).
Please clamp the power cord of the device into the bottom groove,
and the bottom cannot be stranded with foreign bodies;

Key Description
Wi-Fi Networking Key
Food Output Key
Food Output Key:
Single click the food output key: ① deliver one piece of food;
② End the continuous food output
(continuous food output state).
Double click the food output key: enter the continuous food output mode.
≥ 3 cm
≥ 3 cm
≥ 3 cm
7
Tips:
In order to avoid the interference of sensor
and prevent the accuracy of data reported
from being affected, the above points
should be considered when the device is
placed.

Wi-Fi Networking Key:
Long press it for 5s, and the Wi-Fi indicator flashes in blue, and then enter
the Wi-Fi networking state.
Open/Close The Child Lock:
Press the food output key and Wi-Fi networking key for 3s at the same
time to open/close the child lock.
Work indicator:
White flashing: When the power supply is turned on, it flashes until it is
initialized successfully and then goes out.
White always on: 1. The feeder is delivering the food and then goes out
after delivering the food;
2. The camera is working. Red flashing: abnormal food
output.
Red flashing in a slow speed: insufficient surplus food in the bucket.
* It is off after 3min of abnormal prompt, and then press the food output key to wake
up the indicator.
Wi-Fi indicator:
Blue flash: enter the networking state and wait for Wi-Fi connection.
Blue is always bright: Wi-Fi connection is successful.
* Connection failure or disconnection for 3min without re-connection, indicator goes
out.
8
Indicator Description
Wi-Fi Indicator
Work Indicator

9
Connect to App
Download and install App
iOS Android
petgugu
1
2
Method 1: Scan the QR code and
download and install the App
according to the prompts
Method 2: Open the mobile app
store, search for "petgugu",
download and install it.
Tips
1. After installation, please complete the registration, login and networking
as instructed by mobile App page.
2. Please confirm that the network Wi-Fi is 2.4 G band network before
networking.
Maintenance
I. Maintenance Precautions
Please do not put the device in a place where the sun shines
directly, so as not to accelerate the yellowing and aging of the
device.
Please disconnect the power supply, clean the whole device,
and ensure that the bottom power interface is dry.
Please clean food storage bucket and food bowl in large
containers such as sinks.
Clean food storage bucket, mixing impeller, food bowl, etc.
Please rinse them with warm water within 40℃. (Please do
not soak them in hot water for cleaning)
1.
2.
3.
4.

10
Please do not use gasoline, kerosene, polishing powder,
bleach and other chemical reagents to clean the device.
For daily maintenance, wipe and clean the surface stains of
device or power cord with a soft cloth that once has been
rinsed with warm water. (Please remove the power supply first.)
In case the device not used for a long time, please clean and dry
it, put all parts into the packaging box in the original packaging
sequence, and place it in a dry place for proper storage.
5.
6.
7.
II. Replacement of drying box
1.
2.
It is recommended to replace the drying box once every 30 days
under normal use.
For the sake of pet health, please replace the drying box
according to the climate change and the service condition of
the drying box.
* The drying box should not be placed in water or washed with water directly.
III. Cleaning guidance
1. Unlock the food storage
bucket
Push the food bucket locking keys
of the left and right upward to the
unlocking state at the same time.
2. Take out the food storage
bucket
Take off the upper cover, grab
the wall of the food storage
bucket and take it out upwards.

11
* Clean it and put it back one by one after drying
(except for food storage bucket, mixing impeller, silica gel impeller, impeller cover and
food bowl, other parts cannot be washed directly, and it is recommended to wipe the
cleaning equipment with a soft cloth which once has been rinsed with warm water).
IV. Installation guidance
3. Take out the impeller cover
Empty the food storage bucket, turn it upside down, rotate the impeller
cover clockwise to the unlocking symbol [ ], align it to the arrow symbol
of the food storage bucket [ ], and then take it out upward.
1. Install impeller cover
①.Press the impeller cover unlocking
symbol [ ], and align it to the arrow
symbol of food storage bucket [ ],
and then press down.

②.Rotate the impeller cover locking
symbol [ ] counterclockwise and
align it to the arrow symbol of food
storage bucket [ ] to complete the
locking.
12
2. Install food storage bucket
Place the food storage bucket on the host. If the food storage bucket
cannot go down:
①Please push the food bowl locking keys on both sides up to the unlocking
state at the same time.
②Please rotate the mixing impeller in the food storage bucket until the
food storage bucket is completely put down.

13
3. Lock the food storage bucket
At the same time, push the food bowl
locking keys on both sides down to the
locking state to complete the locking.
Basic Parameters
Product Name
Model
Intelligent Pet Feeder
PF2
Product Net Weight 4.3kg
Input Parameters
Rated Power
10.4W
Working Temperature 0°C~50°C
Working Humidity 10%-90%RH
Product Size 345.7×208.7×366.6mm
Power Cord Length 1.5m/1.8m
Applicable Standard GB4706.1-2005
Product Capacity
Main Material
3.5L
Ceramics (food bowl), ABS (body)
PC (food storage bucket)
5.2V 2.0A

14
FAQ
1.There is no response from the device after the power supply is
connected?
Check whether both ends of the power adapter are connected normally
and not loose, and power on normally.
2.How to shut down the device when it is not used for a long time?
The device has no shutdown key. When it is not used for a long time, unplug
the power supply.
3.APP networking connection fails, and the device could not
connect to the network?
Please make sure that the mobile phone is connected to the network
Wi-Fi in the 2.4G band and the device is in the Wi-Fi signal range.
4.The device has no voice prompt
Please check whether the APP side has turned off the voice prompt or
reduced the volume of the prompt tone to 0.
5.External mobile power supply for device
If the device is connected with adapter and mobile power supply at the
same time, the priority is given to adapter to supply the power to the device
(the device does not support the reverse charging for mobile power supply);
After power failure, the device automatically switches to the mobile power
supply for power supply. In this state, the device only retains the functions
of regular food output and voice broadcast.
6.About food bowl cleaning
In order to protect pet’s diet health, it is recommended that users clean the
food bowl once a week.

15
Website: www.petgugu.com
Maintenance Record
Name of Maintenance Center:
Maintenance Center Tel:
Delivery Date:
Cause of Failure:
Failure Situation in Repair:
Certificate of Change or Refund:
Signature of Maintenance Personnel:
Stamp of Maintenance Center:
Services And Support
Email: US: [e-mail]
JP: [email protected]
EU: [e-mail]

Scannen Sie den QR-Code, um das Online-Handbuch auf Deutsch zu erhalten.
Scannez le QR code pour obtenir le manuel en ligne en français.
Scansiona il codice QR per ottenere il manuale online in italiano.
Escanee el código QR para obtener el manual en línea en español.
コードをスキャンして、日本語のオンライン マニュアルを取得します。