CHOOSE YOUR CABLES
01
INSTALL POWER SUPPLY INTO CHASSIS
02
CONNECT CABLES TO POWER SUPPLY
03
INSTALLATION GUIDE
The Revolt power supply comes as a cable free model, cables are purchased
separately. Make sure the cables are compatible with the Phanteks Revolt
power supply before proceeding.
Cables sold separately
Install the Revolt PSU in the computer chassis using the 4x PSU screws. Follow
the chassis instruction manual.
Connect all needed cables to the power supply according to the overview
below. The exact connector lay-out and quantity may be different depending
on the model.
Activate the 0 RPM mode with the Hybrid Fan button on the rear to go for
absolute silence when under low load. The Revolt will control the fan speed
intelligently based on load and temperature.
ULTIMATE SILENCE WITH HYBRID FAN CONTROL
05
CONNECT POWER CABLE
06
BE SAFE!
07
PCIE GEN5 GPU CONNECTOR
04
The Revolt is equipped with the PCIe Gen5 (12VHPWR) GPU connector. Make
sure it is fully seated and clicked in to prevent any damage to your system.
Note that a compatible GPU is required.
Connect the power cable to the power supply and a
grounded power outlet respectively. Make sure the power
supply is turned off ‘O’ before connecting it to a power outlet.
Hybrid Fan Mode is turned on when the button is in the
‘OUT’ position and turned off when pushed ‘IN’.
Switch the power button to the ‘I’ position to turn on
your system.
When making any changes to the hardware, be sure
that the power button is switched from the ‘I’ to the ‘O’
position so the power supply is turned off.
Phanteks will not take responsibility for any damages incurred due to incorrect installation or usage of this product.
PCIe GEN5
12VHPWR CABLE
Pre-connect all needed cables to the
PSU before installing it into the chassis.
See step 3
PRO TIP
PSU SCREW
INSTALL
4x
