1x Control handle
1x Silicone diaphragm with stem
1x White Valve
1x Pump body
2x Reusable bases
(1x 125ml/4oz and 1x 260ml/9oz)
1x Stand (same as )
1x Let-down Massage Cushion™
Bottle
parts
ISIS iQUNO™ parts
d
e
f
g
h
k
l
n
o
h
j
a
c
Pump parts
i
m
1x Funnel cover (same as )
1x Battery pack
1x Wall plug lead
1x Dome cap
1x Newborn Teat (0m+)
2x Screw rings
1x Travel cover
2x Sealing discs
f
h
i
j
k
l
m
n
o
b
Main parts in detail
NEVER STERILISE OR IMMERSE IN WATER!
Control handle
NEVER STERILISE OR IMMERSE IN WATER!
Battery pack
3
Control button
Light
Power cable
Only the following batteries are compatible
with the ISIS iQUNO™ Battery Pack:
Duracell Ultra M3, Duracell Plus, Energiser
Ultra Plus, Duracell Accu (NiMH),
Ansmann (NiMH). For Duracell Acc (NiMH)
& Ansmann (NiMH) use / charge in
accordance with manufacturers
guidelines. Dispose of batteries as per
manufacturers instructions.
Power socket
Control handle
• Avoid contact with antibacterial detergents/cleaners
as they can damage the plastic. Combinations of
detergents, cleaning products, sterilising solution,
softened water and temperature fluctuations may,
under certain circumstances, cause the plastic to
crack. If this occurs, do not use. The pump body and
breast milk containers are dishwasher safe but food
colourings may discolour them. Follow guidelines
in ‘How to clean and sterilise your ISIS iQUNO™’
on pages 5-6.
Cracking or
discolouration
of pump parts
• Contact the AVENT Customer Services for
replacements (see back cover for contact details).
Lost or
broken parts
• Ensure the pump is correctly assembled and switched
on with the power indicator illuminated ‘GREEN’.
• Make sure the lead between the electrical wall
socket or battery pack and the pump is correctly
connected.
Pump not
responding
• 3 flashes, delay, 3 flashes etc – if the pump stops
working and the power light is flashing RED the
pump has detected a vacuum fault. Disconnect the
power and check the control handle and diaphragm
for obstructions or damage.
• Continuous RED pulsing flash – Low battery warning.
You should consider replacing the batteries.
Pump light
flashing RED
• The pump must be switched off via the control
button in order to separate these parts. If the
batteries go flat mid-pumping, you may experience
difficulty. Replace the batteries or connect the pump
to the mains. Turn the pump on by holding down the
control button for 2 seconds – the light will turn
GREEN. Now turn it off by holding the button for
2 seconds – the light will go off. You can now
disconnect the pump from the power supply and
should be able to separate the parts.
Difficulties
separating the
control handle from
the pump body
20
a
b
c
d
e
f
g
2