Philips CE600BT User manual

www.philips.com/support
Register your product and get support at
2017 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is
sold under the responsibility of Gibson Innovations
Ltd.,and Gibson Innovations Ltd. is the warrantor in
relation to this product
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used
under license.
CE600BT_12_QSG_SafetySheet_V2.0
Quick start guide
Quick start guide
www.philips.com/support
Always there to help you
Registeryour product and get support at
Question?
Contact
Philips
Safety
Read and understand all instructions before you use the device. If
damage is caused by failure to follow instructions, the warranty does
not apply.
• The device is designed for negative ground (earth) 12 V DC
operation only.
• Risk of car accidents! Never watch video or operate this system
while driving.
• To ensure safe driving, adjust the volume to a safe and
comfortable level.
• Improper fuses can cause damage or re. When you need to
change the fuse, consult a professional.
• Use only the supplied mounting hardware for a safe and secure
installation.
• To avoid short circuits, do not expose the device, remote control
or remote control batteries to rain or water.
• The device shall not be exposed to dripping or splashing.
• Do not place any sources of danger on the device (e.g. liquid
lled objects, lighted candles).
• Never insert objects into the ventilation slots or other openings
on the device.
• Risk of damage to the screen! Never touch, push, rub or strike
the screen with any object.
• Clean the device with soft, damp cloth. Never use substances
such as alcohol, chemicals or household cleaners on the device.
• Always install this system in the car dashboard. Other locations
can be dangerous as the rear of the system heats up during use.
• To avoid short-circuit: before you connect, make sure that the
ignition is o.
• Make sure that you connect the yellow and red power supply
leads after all other leads are connected.
• Make sure that all loose leads are insulated with electrical tape.
• Make sure that the leads do not get caught under screws iron
parts that will move (e.g. seat rail).
• Make sure that all ground (earth) leads are run to a common
ground (earth) point.
• Use only the supplied mounting hardware for a safe and secure
installation.
• When you connect other devices to this system, make sure that
the rating of the car circuit is higher than the total fuse value of
all the connected devices.
• Never connect speaker wires to the metal body or chassis of the car.
• Never connect speaker wires with stripes to one another.
Compliance
This product complies with the requirement of the 1999/5/EC directive.
Declaration of conformity
Hereby, Gibson Innovations declares that this product is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. You can nd the Declaration of
Conformity on www.p4c.philips.com.
Care of the environment
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, and old
equipment.
Disposal of your old product
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
This symbol on a product means that the product is covered by
European Directive 2012/19/EU. Inform yourself about the local
separate collection system for electrical and electronic products.
Follow local rules and never dispose of the product with normal
household waste. Correct disposal of old products helps prevent
negative consequences for the environment and human health.
Trademark notice
The Bluetooth® word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any use
of such marks by Gibson Innovations Limited is under license. Other
trademarks and trade names are those of their respective owners.
Windows Media and the Windows logo are trademarks,
or registered trademarks of Microsoft Corporation in the
United States and/or other countries.
Copyright
2017 © Gibson Innovations Limited. All rights reserved.
Philips and the Philips Shield Emblem are registered trademarks of
Koninklijke Philips N.V. and are used under license.
Specications are subject to change without notice. Gibson
Innovations reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.
Product information
Power
• Power supply: 12 V DC (11 V - 16 V), negative ground
• Fuse: 15 A
Display
• Type: LCD Touch-sensitive screen
• Diagonal screen size (inch): 6.8
• Resolution: WVGA
Sound
• Suitable speaker impedance: 4 - 8
• Maximum power output: 50 W x 4 channels
• Continuous power output: 22 W x 4 channels (4 10% T.H.D.)
• Pre-Amp output voltage: 2.0 V
• Sub-woofer output voltage: 2.0 V
• Aux-in level: 800 mV
Connectivity
• USB
- USB2.0 or USB1.1
• Bluetooth
- Proles: A2DP, AVRCP 1.5, HFP, HSP
- Version: 3.0
- Range: 8 m (free space)
• AV-IN
• Video output: Composite video out
• Preamp output
• Sub-woofer output
• Parking camera
Radio
• Frequency range - FM: 87.5 - 108.0 MHz (50 kHz per step)
• Frequency range - AM(MW): 522 - 1620 kHz (9 kHz per step)
USB
• Output for power charging: 1 A
• File format: FAT16, FAT32
- Directory nesting up to a maximum of 8 levels
- Number of albums/folders: maximum 99
- Number of tracks/titles: maximum 999
- File name in Unicode UTF8 (maximum length: 128 bytes)
• Supported formats
- Video:
AVI (video codec: MP4V/ Xvid MPEG-1, audio codec: WMA/
PCM/LPCM MPEG-Audio (MP1/MP2/MP3));
MPG (video codec: MPEG-1/MPEG-2, audio codec: LPCM,
MPEG-Audio (MP1/MP2/MP3));
DAT (video codec: MPEG-1/MPEG-2, audio codec: LPCM,
MPEG-Audio (MP1/MP2/MP3));
FLV (video codec: H.263, audio codec: LPCM/MP3));
MP4/MOV (video codec: Xvid, MP4V; audio codec: WMA/
LPCM, MPEG-Audio (MP1/MP2/MP3), uLaw/aLaw));
Resolution: 720 X 480/576(30fps)
- Audio:
MP3 (Bit rate: 16 kbps - 320 kbps; Sampling rate: 8 K - 48 KHz);
WMA (WMA7, WMA8, WMA9 (only CBR, VBR), Bit rate: 16 kbps
- 320 kbps; Sampling rate: 8 K - 48 KHz);
ID3 tag v2.0 or later
- Picture: JPEG, BMP
Warranty against Defects
In this warranty: We or us means Gibson Innovations ABN 531 651 059 75, and our contact details are set out at the end of this warranty;
You
means the purchaser or the original end-user of
the Goods; Supplier means the authorised distributor or retailer of the Goods that sold you the Goods in Australia, New Zealand or South Africa; and Goods means the product or equipment which was accompanied by this warranty and purchased in Australia, New Zealand or South Africa. If you require assistance with the operation of the product, its features or specications please contact
Australia New Zealand South Africa
DLG International Telephone: [phone] E-mail:
service@ dlgint.com.au
DLG International Telephone: [phone] Email: service@ dlgint.co.nz
Connoisseur Electronics (Pty) Ltd Telephone: [phone] Email: info@ connoisseur.co.za
Australia:
Our Goods come with guarantees that
cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the Goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. This is not a complete statement of your legal rights as a consumer.
New Zealand: Our Goods come with guarantees that cannot be excluded under the Consumer Guarantees Act 1993. This guarantee applies in addition to the conditions and guarantees implied by that legislation. Additional Warranty: In addition to the rights and remedies that you have under the Australian Consumer Law, Consumer Guarantees Act of New Zealand, South African Law, or any other applicable law, we provide the following warranty against defects: 1. If, during the rst 12 months from their date of
purchase from the Supplier (Warranty Period), the Goods prove defective by reason of improper workmanship or materials and none of your statutory rights or remedies apply, we will repair or replace the Goods without charge.
2.
We do not have to repair or replace the Goods under this Additional Warranty if the Goods have been used for a commercial purpose; misused, improperly or inappropriately installed, operated or repaired; abused; damaged; or not maintained in accordance with the manufacturer’s instructions.
3.
Even when we do not have to repair or replace the Goods, we may decide to do so anyway. In some cases, we may decide to substitute the Goods with a similar alternative product of our choosing. All such decisions are at our absolute discretion.
4. All such repaired, replaced or substituted Goods
continue to receive the benet of this Additional Warranty for the time remaining on the original Warranty Period.
5. This Additional Warranty is limited to repair,
replacement or substitution only. As far as the law permits, we will not be liable for any loss or damage caused to property or persons arising from any cause whatsoever.
6. In order to claim under this Additional Warranty
you must contact us within the Warranty Period:
Australia New Zealand South Africa DLG International Telephone: [phone] E-mail:
service@ dlgint.com.au
DLG International Telephone: [phone] Email: service@ dlgint.co.nz
Connoisseur Electronics (Pty) Ltd Telephone: [phone] Email: info@ connoisseur.co.za
You will be asked for details of the Goods, a description of the defect and your personal details. Upon accepting your claim, we shall assist you with either returning the Goods to the Supplier for replacement or to the most convenient Philips Authorized Service Centre for your Goods to be repaired. In some case we may require that you return to the Goods to us (at the address below) for repair, replacement or substitution. * All returned Goods must be accompanied
by satisfactory proof of purchase which clearly indicates the name and address of the Supplier, the date and place of purchase and identies product. It is best to provide a legible and unmodied receipt or sales invoice.
* You must bear any expense for return of the
Goods or otherwise associated with making your claim under this Additional Warranty.
7. This warranty is only valid and enforceable in
Australia, New Zealand and South Africa.
Contact us or the place of purchase for further details. Australia New Zealand South Africa
DLG International 88 Enterprise Ave Berwick 3086 Melbourne
DLG International Unit K 11 Echelon Place East Tamaki 2013
Connoisseur Electronics (Pty) Ltd The Mediterranean Conference Centre 72 Concorde Road East Bedfordview Gauteng 2007
Telephone: [phone]
Service: 1800 304 811 E-mail: service@ dlgint.com.au
Service: 0800 437 663 Email: service@ dlgint.co.nz
Service: 0860100551
E-mail: info@connoisseur. co.za
November 2016

Tap the icons to select functions:
• : Tune to FM/AM radio stations.
• : Play music/videos from the connected USB storage device.
• : Make/ answer phone calls from the connected mobile phone.
• : Stream music from the connected Bluetooth device.
• : Play music/videos from the external media player that is
connected through audio/video cables.
• :Select sound options.
• : Enter the settings menu.
Note
•The package does not include trim plate and mounting parts
such as *radio mounting brackets for the reason that they are
specic to car type. Before installation, consult the dealer or
professional installer for the right mounting kit.
Setup
Overview
Connect wires
ISO male connectors Connect to
a Green strip, black-edged
green strip
Rear left speaker
b White strip, black-edged white
strip
Front left speaker
c Gray strip, black-edged gray
strip
Front right speaker
d Purple strip, black-edged
purple strip
Rear right speaker
e Red strip Ignition key +12V DC when ON/
ACC
f Blue strip Motor/electric antenna relay
control lead
g Blue strip, white strip Amplier relay control lead
h Black strip Ground
i Yellow strip The +12V car battery which is
energized at all times
LR LRLR
a
bc
d e
fg
i
h
j
l
m
k
12367 45
Main unit Home screen
Mount into the dashboard
12
2
1
3
*
Radio mounting brackets
(not included)
Connectors and sockets
on rear panel
External sockets or connectors
aFor ISO male connectors As indicated above
bREAR OUT L (White socket)
REAR OUT R (Red socket)
Rear left speaker
Rear right speaker
cAV-IN L (White socket)
AV-IN R (Red socket)
VIDEO IN (Yellow socket)
Left audio output of the external
player
Right audio output of the external
player
Video output of the external player
dCAMERA IN (Yellow socket) Video output socket of an external
camera
eVIDEO OUT (Yellow socket) Video input of the external display
device
fRADIO ANT Radio antenna
gFRONT OUT L (White
socket)
FRONT OUT R (Red socket)
Front left speaker
Front right speaker
hIR OE (Black/brown wire) OE remote
iREVERSE (Purple wire) Reverse camera (B+)
jPARKING (Pink wire) Parking brake (-)
kUSB (Black socket) USB connector of the external USB
storage device
lMIC (Black socket) External microphone
mSUB-W OUT (Black
socket)
Sub-woofer
a
• Press to switch on.
• Press and hold to
switch o.
• Press to mute or
unmute.
b +/-
• Press to increase or
decrease the volume.
c
• Press to display the set
clock.
d RES
• Press to reset the
system.
e MIC
• Microphone
f Touch sicreen
g
• Press to enter the
Home screen.
Visit www.philips.com/support to download the latest user manual
and nd troubleshooting tips.
www.philips.com/support