Philips AJT3300 Product information sheet

Question?
Contact
Philips
Question?
Contact
Philips
AJT3300
The batteries (not supplied) can only back up clock and alarm
settings when AC power is disconnected. Press repeatedly to select Bluetooth, FM tuner,AUX mode,
or switch to standby mode.
SOURCE
Specications are subject to change without notice.
2014 © WOOX Innovations Limited. All rights reserved.
This product was brought to the market by WOOX
Innovations Limited or one of its afliates, further referred
to in this document as WOOX Innovations, and is the
manufacturer of the product. WOOX Innovations is the
warrantor in relation to the product with which this
booklet was packaged. Philips and the Philips Shield Emblem
are registered trademarks of Koninklijke Philips N.V.
AJT3300_79_Short User Manual_V2.0
EN
1 Important
Safety
Know these safety symbols
This ‘bolt of lightning’ indicates uninsulated material within your unit may cause
an electrical shock. For the safety of everyone in your household, please do not
remove product covering.
The ‘exclamation point’ calls attention to features for which you should read the
enclosed literature closely to prevent operating and maintenance problems.
WARNING: To reduce the risk of re or electric shock, this apparatus should not be
exposed to rain or moisture and objects lled with liquids, such as vases, should not
be placed on this apparatus.
CAUTION:To prevent electric shock, match wide blade of plug to wide slot, fully
insert.
Warning
•Never remove the casing of this clock radio.
•Never lubricate any part of this clock radio.
•Never place this clock radio on other electrical equipment.
•Keep this clock radio away from direct sunlight, naked ames or heat.
•Make sure that you always have easy access to the power cord, plug or
adaptor to disconnect the clock radio from the power.
• Make sure that there is enough free space around the product for ventilation.
To download the full user manual, visit www.philips.com/support.
Short User Manual
• Battery usage CAUTION – To prevent battery leakage which may result in
bodily injury, property damage,or damage to the clock radio:
• Install the batteries correctly, + and - as marked on the clock radio.
• Do not mix batteries (old and new or carbon and alkaline, etc.).
• Remove the batteries when the clock radio is not used for a long time.
• The batteries shall not be exposed to excessive heat such as sunshine, re
or the like.
• Use only power supplies listed in the user manual.
• The clock radio shall not be exposed to dripping or splashing.
• Do not place any sources of danger on the clock radio (e.g. liquid lled objects,
lighted candles).
• Where the plug of the Direct Plug-in Adapter is used as the disconnect device,
the disconnect device shall remain readily operable.
2 Notice
Any changes or modications made to this device that are not expressly approved
by WOOX Innovations may void the user’s authority to operate the equipment.
Disposal of your old product and batteries
Your product is designed and manufactured with high quality materials and
components, which can be recycled and reused.
Never dispose of your product with other household waste. Please inform yourself
about the local rules on the separate collection of electrical and electronic products
and batteries.The correct disposal of these products helps prevent potentially
negative consequences on the environment and human health.
Your product contains batteries, which cannot be disposed of with normal
household waste.
Please inform yourself about the local rules on separate collection of batteries.The
correct disposal of batteries helps prevent potentially negative consequences on the
environment and human health.
Please visit www.recycle.philips.com for additional information on a recycling center
in your area.
Environmental information
All unnecessary packaging has been omitted. We have tried to make the packaging
easy to separate into three materials: cardboard (box), polystyrene foam (buffer)
and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused if disassembled
by a specialized company. Please observe the local regulations regarding the disposal
of packaging materials, exhausted batteries and old equipment.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by WOOX Innovations is under
license.
Note
•The type plate is located on the bottom of the apparatus.
Class II equipment symbol:
CLASS II apparatus with double insulation, and no protective earth provided.
Play audio from Bluetooth-enabled devices
1 Press SOURCE repeatedly to select Bluetooth mode.
2 On your device, enable Bluetooth function and search for Bluetooth devices.
3 Select [AJT3300] on your device to start pairing and connection. If necessary, enter default password “0000”.
4 Play audio on the Bluetooth device.
• To disconnect Bluetooth connection, press and hold for 3 seconds.
• To pause or resume play, press PLAY/PAUSE.
After Bluetooth connection, you can control your incoming
phone call with this product.
Button Function
Press to answer an incoming call.
During a call, press to end the current call.
Press and hold to reject an incoming call.
Note
•Music play pauses when there is an incoming call.
Tune to FM radio stations
Tip:
For better reception, fully extend and adjust the position of the antenna.
Note:
• You can store a maximum of 10 preset radio stations.
• To overwrite a pre-stored radio station, store another one with its
sequence number.
Select a preset radio station
Note:
You can only set time in standby mode.
Store radio stations in memory
www.philips.com/support
AJT3300_79_SUM_V2.0.indd 1 8/7/2014 3:00:53 PM

Charge your mobile devices
1 Connect the clock radio with your mobile
device.
• For Android-powered mobile device with
a micro USB socket: use the supplied cable
to connect the product with the mobile
device;
• For Apple device with a lightning or 30-pin
connector: use the charging cable of the
Apple device (not supplied) to connect the
product with the mobile device.
2 Connect the clock radio to AC power.
» The mobile device begins to charge.
Specications
Amplier
Total Output Power 2W
Tuner (FM)
Tuning Range 87.5-108 MHz
Tuning Grid 100 KHz
Sensitivity
- Mono, 26 dB S/N Ratio
- Stereo, 46 dB S/N Ratio
<22 dBf
<51.5 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >50 dBA
Bluetooth
Bluetooth version V3.0
Supported proles HFP, A2DP, AVRCP
Range 10 m (Free space)
General information
AC power (power adapter) Brand name: Philips;
Model: CS12F055180FAF;
Input: 100-240 V~, 50/60 Hz, 500 mA;
Output: 5.5 V 1.8 A
USB Port 5 V 1 A
Operation Power Consumption 10 W
Standby Power Consumption <1 W
Dimensions:
- Main Unit (W x H x D) 112 x 101 x 125 mm
Weight:
- Main Unit 0.5 kg
Note:
Make sure that you have set the clock correctly.
When alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing nine minutes later.
1 Press AL1/AL2 to view alarm settings.
2 Press AL1/AL2 again to activate or deactivate the alarm timer.
» If the alarm timer is activated, [AL1] or [AL2] is displayed.
• To stop the ringing alarm, press the corresponding AL1 or AL2.
Note:
When alarm sounds, volume increases gradually. You cannot adjust the alarm
volume manually.
Press SLEEP repeatedly to select a period (in minutes). After the set period,
the product switches to standby mode automatically.
• To deactivate the sleep timer, press SLEEP repeatedly until [OFF] (off) is
displayed.
AJT3300_79_SUM_V2.0.indd 2 8/7/2014 3:00:57 PM