Philips 8FF3FPB Quick start guide

PhotoFrame Firmware Upgrade Instructions
Applicable models 8FF3FPB, 8FF3FP
W
Firmware version 058
Release date October 20, 2008
Release notes -
Preloaded baby photo is deletable
!Important notice before updating
The firmware upgrade process will remove all photos currently stored on PhotoFrame.
Please make sure all photos on PhotoFrame are properly backed up before updating. !
Please follow the steps below to upgrade the PhotoFrame firmware.
1Format SD (Secure Digital) card
2Copy all files from the ‘Firmware’ folder into the root folder of the SD card
(The root folder is the ‘highest’ folder in hierarchy, for example F:\)
3Make sure PhotoFrame is powered Off
4Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5Push the Power button to power on the PhotoFrame
6The firmware upgrade will start automatically
!
Warning: Upgrade takes about 1 minute.
During the upgrade do not disconnect power, remove the memory or make new
connections. Otherwise this may harm your PhotoFrame. !
7When "Please reboot system!" shows, firmware upgrade has finished
8Remove the memory from the PhotoFrame
9Power Off the PhotoFrame and Power On afterwards by pushing the Power button
10 The upgrade has completed
You can check the new firmware version via Setup →Status →Firmware.