Philips MCD196/93 User manual

CLOCK
MCD196
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
1
Quick Start Guide
Quick Start Guide
Composite Video Cable Remote control with
battery
MW antenna FM antenna
2
User Manual
User Manual
Remove the plastic
protective sheet
MCD196_98 QUG_Eng 13/2/07, 14:411

A
RIGHT LEFT
R LINE OUT L
+
–
SPEAKER 4Ω
RSP-134V
VIDEO OUT
VIDEO
SUB WOOFER
OUT
DIGITAL
OUT
S-VIDEO
3
2
1
4
1
FM
AERIAL
AM
AERIAL
Tip
See the User Manual for other TV
connection options.
Setting up the TV
1
2
4
3
Connect the speaker cables.
Connect the FM and MW antennas.
Connect the composite video cable to a TV.
Connect the power cords of the system and TV.
1
2
Press SOURCE (DISC on the remote) to select disc source.
Turn on the TV and set it to the correct Video In channel.
CLOCK
AUDIO OUT
L
R
B
ATo listen to the sound of this DVD Player
through your TV, use the audio cables (white/
red-not supplied) to connect LINE OUT
(L/R) jacks of the DVD Player to the
corresponding AUDIO IN jacks on the TV.
B To listen to the sound of your TV through
this DVD player, use a cinch cable (not
supplied) to connect AUX on the front
panel of the DVD player to the
corresponding AUDIO OUT jacks on the TV.
Speaker
(right) Speaker
(left)
MW antenna
FM antenna
AC power cord
TV
MCD196_98 QUG_Eng 13/2/07, 14:412

Setting the clock
1
2
3
4
In standby mode, press and hold DISPLAY/CLOCK SET on the system.
When the hour digits flash, pressí/ëon the front panel or on the remote to set the
hours.
Press DISPLAY/CLOCK SET again and the minute digits flash.Then press í/ëon the
front panel or on the remote to set the minutes.
Press DISPLAY/CLOCK SET again to confirm the time setting.
Setting system menu options
Tip
See chapters "Preparations" and "System Menu Options" in the User
Manual for detailed descriptions.
CLOCK
VOLUME
+
-
STANDBY-ON
PULLTO OPEN
MICRO THEATRE MCD196
DVD/WMA-MP3-CD COMPATIBLE
PRESET
SOURCE
TUNING
DBB
DSC
AUX
DISPLAY/CLOCK SET
iR
SET
PRESET
MCD196_98 QUG_Eng 13/2/07, 14:413

Playing a disc
Programming and tuning to radio stations
1
2
3
Press SOURCE (TUNER on the remote) to select tuner source.
Press PROG/ANGLE for more than two seconds to program all available stations in
order of waveband.
Press PRESETí/ëuntil the desired preset station is displayed.
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
PDCC-JH/ZC-0708
CRoyal Philips Electronics N.V. 2007
All rights reserved.
http://www.philips.com
1
2
3
Press OPEN•CLOSE 0to open the disc tray and load in a disc, then press the same
button again to close the disc tray.
➜Make sure the label side of the disc is facing up.
Playback will start automatically. If not pressÉÅ.
To stop playback, press 9.
MCD196_98 QUG_Eng 13/2/07, 14:414