Philips HQ6445/33 User manual

ENGLISH 4
FRANÇAIS 12
ESPAÑOL 20
PORTUGUÊS 28
42
50
HQ6445, HQ6415, HQ6405
á«Hô©dGá«Hô©dG

Warning
Please read these instructions before using the
appliance.
◗Only use the cord supplied.
C◗Make sure the appliance and the cord do not
get wet.
Connecting
Store and use the appliance at a temperature
between 5cC and 35cC.
The appliance is suitable for mains voltages
ranging from 100 to 240V.
C1Put the appliance plug in the shaver.
2Put the cord in the wall socket.
Shaving
1Switch the shaver on by sliding the on/off
button upwards (1).
C2Move the shaving heads quickly over your
skin, making both straight and circular
movements.
Shaving on a dry face gives the best results.
Your skin may need 2 or 3 weeks to get
accustomed to the Philips system.
3Switch the shaver off (0).
ENGLISH4

C4Put the protection cap on the shaver every
time you have used it, to prevent damage.
Replace the shaving heads (type HQ55) every
2 years for optimal shaving results.
Trimming
For grooming sideburns and moustache.
C1Open the trimmer by pushing the slide
upwards.
The trimmer can be activated while the motor is
running.
Cleaning
Regular cleaning guarantees better shaving
performance.
C◗For easy and optimal cleaning, the Philips
Action Clean (shaving head cleaner, type
HQ100) is available.Ask your Philips dealer
for information.
You can also clean the shaver in the following way:
Every week: shaving unit
1Switch the shaver off (0), remove the cord
from the wall socket and pull the appliance
plug out of the shaver.
ENGLISH 5

C2Clean the top of the appliance first, using
the brush supplied.
C3Press the release button and remove the
shaving unit.
C4Clean the inside of the shaving unit and the
hair chamber with the brush.
C5Put the shaving unit back onto the shaver.
Every two months: shaving heads
Replace the shaving heads (type HQ55) every
2 years for optimal shaving results.
1Switch the shaver off (0), remove the cord
from the wall socket and pull the appliance
plug out of the shaver.
ENGLISH6
2
1

C2Press the release button and remove the
shaving unit.
C3Turn the wheel anticlockwise and remove
the retaining frame.
C4Remove and clean the shaving heads
(cutters and guards) one by one.
Do not mix up the cutters and the guards.
This is essential since each cutter has been
ground with its corresponding guard for optimal
performance. If you accidentally mix the sets up, it
could take several weeks before optimal shaving
performance is restored.
C5Clean the cutter with the short-bristled
side of the brush.
Brush carefully in the direction of the arrow.
C6Brush the guard.
You can also clean the shaving unit with a
degreasing liquid (e.g. alcohol). If you do, lubricate
the central point of the guards with a drop of
sewing machine oil after cleaning.This prevents
wear of the shaving heads.
ENGLISH 7
2
1
1
2