Philips S1000 User manual

S1000

2
1
7
8
3
4
5
10
9
6

empty page before TOC

English 6
Français (Canada) 22

English
Contents
Introduction_______________________________________________________ 6
General description (Fig. 1)_______________________________________ 6
Important safety information_____________________________________ 7
Charging___________________________________________________________ 9
Charging indications______________________________________________ 10
Using the appliance______________________________________________ 11
Shaving____________________________________________________________ 11
Trimming__________________________________________________________ 12
Cleaning and maintenance_______________________________________ 13
Replacement______________________________________________________ 16
Storage____________________________________________________________ 18
Ordering accessories_____________________________________________ 18
Recycling__________________________________________________________ 18
Removing the rechargeable shaver battery_____________________ 19
Warranty and support____________________________________________ 21
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
General description (Fig. 1)
1 Protective cap
2 Shaving unit
3 Shaving unit release button
4 On/off button
5 Charging light
6 Trimmer release slide switch
7 Pop-up trimmer
8 Socket for small plug
9 Supply unit
10 Small plug
6English

Important safety information
Read this important information carefully before
you use the appliance and save it for future
reference.
Danger
- Keep the supply unit dry.
Warning
- To charge the battery, only use the detachable
supply unit (HQ8505) provided with the
appliance.
- The supply unit contains a transformer. Do not
cut off the supply unit to replace it with another
plug, as this causes a hazardous situation.
- This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by
children without supervision.
- Always unplug the shaver before you clean it
under the tap.
- Always check the appliance before you use it.
Do not use the appliance if it is damaged, as
this may cause injury. Always replace a
damaged part with one of the original type.
- Do not open the appliance to replace the
rechargeable battery.
7
English

Caution
- This appliance contains batteries that are non-
replaceable.
- Never immerse the charging stand in water and
do not rinse it under the tap.
- Never immerse the shaver in water. Do not use
the shaver in the bath or in the shower.
- Never use water hotter than 60°C to rinse the
shaver.
- Only use this appliance for its intended purpose
as shown in the user manual.
- For hygienic reasons, the appliance should only
be used by one person.
- Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the
appliance.
- Water may drip from the socket at the bottom
of the shaver when you rinse it. This is normal
and not dangerous because all electronics are
enclosed in a sealed power unit inside the
shaver.
- Do not use the supply unit in or near wall
sockets that contain an electric air freshener to
prevent irreparable damage to the supply unit.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
8English

General
- This shaver can be safely cleaned under the
tap.
- The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.
- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
Charging
Note: You can also use the shaver while it is
plugged-in and charging.
Charge the shaver before you use it for the first
time and when the display indicates that the
battery is almost empty.
When you charge the appliance for the first time or
after a long period of non-use, let it charge until
the charging light lights up continuously.
Charging takes approx. : 8 hours (S1232 only) or 1
hour (S1332 only). A fully charged shaver has a
shaving time of up to 40 minutes (S1232 only) or 45
minutes (S1332 only).
S1332 only
Note: Before first usage charge the appliance for 3
hours without interruption and until the battery
charging indication shows that the battery is full.
This is needed to make maximum use of the
battery capacity. All future charges will take 1 hour.
Charging with the supply unit
21
1Put the small plug in the appliance.
2Put the supply unit in the wall socket.
- The charging light shows the charging status of
the appliance.
9
English

3After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.
Charging indications
Battery fully charged
When the battery is fully charged, the charging
light lights up white continuously.
Note: After approx. 30 minutes, the charging light
goes out to save energy.
Battery low
- When the battery is almost empty (when there
are only 5 or fewer shaving minutes left), the
charging light flashes orange.
- When you switch off the appliance, the charging
light continues to flash orange for a few
seconds.
Charging
When the shaver is charging, the charging light
flashes white.
Quick charge (S1332 only)
When you start charging the empty battery, the
charging light flashes white quickly. After approx. 5
minutes the charging light flashes white slowly. The
shaver now contains enough energy for a
5-minute shave.
10 English

Using the appliance
Note: This appliance can be used without cord or
when it is connected to the wall socket.
Shaving tips and tricks
- Make circular movements during use. Circular
movements provide better shaving results than
straight movements.
- Your skin may need 2 or 3 weeks to get
accustomed to the Philips shaving system.
Switching the appliance on and off
1To switch on the appliance, press the on/off
button once.
2To switch off the appliance, press the on/off
button once.
Shaving
Dry shaving
Note: For the best results on skin comfort, pre-
trim your beard if you have not shaved for 3
days or longer.
1Switch on the appliance.
11
English

2Move the shaving heads over your skin in
circular movements to catch all hairs growing in
different directions.
3Stretch your skin with your free hand so the
blades can lift and cut hair. Gently press the
shaver onto you skin so the floating heads can
follow the contours of your face.
Note: Do not press too hard as too much
pressure can cause shaving heads to pinch the
skin.
4Switch off and clean the appliance after each
use.
5Put the protective cap on the appliance to
protect the shaving heads during storage and
travel.
- For the best results on skin comfort, pre-trim
your beard if you have not shaved for 3 days or
longer.
Trimming
Trimming with pop-up trimmer
You can use the trimmer to groom your sideburns
and moustache.
1Push the trimmer release slide downwards to
open the trimmer.
2Switch on the appliance.
3Hold the trimmer perpendicular to the skin and
move the appliance downwards while you exert
gentle pressure.
4Switch off and clean the trimmer after each use.
12 English

5Close the pop-up trimmer (‘click’).
Cleaning and maintenance
Cleaning the shaver
Clean the shaver after every shave for optimal
shaving performance.
Caution: While rinsing shaving heads, water may
drip out of the base of shaver. This is a normal
occurrence. Internal electric parts are in a
waterproof compartment so the shaver will be
protected against water damage.
1Switch off the appliance and make sure it is
disconnected from the wall socket.
2Press the release button to open the shaving
unit.
3Rinse the shaving unit and hair chamber with
lukewarm water.
4Rinse the outside of the shaving unit with
lukewarm water.
13
English

Never dry the shaving unit with a towel or
tissue, as this may damage the shaving heads.
5Carefully shake off excess water and let the
shaver air dry.
6Close the shaving unit.
Cleaning the pop-up trimmer
Clean the pop-up trimmer after each use.
Never dry the trimmer teeth with a towel or
tissue, as this may damage the trimmer teeth.
1Switch off the appliance and make sure it is
disconnected from the wall socket.
2Push the trimmer release slide button down to
open the pop-up trimmer.
3Switch on the appliance and rinse the pop-up
trimmer with warm water.
4After cleaning, switch off the appliance.
5Carefully shake off excess water and let the
pop-up trimmer air dry.
6Close the pop-up trimmer (‘click’).
Tip: For optimal performance, lubricate the teeth
of the pop-up trimmer with a drop of mineral oil
every six months (oil not included).
Thorough cleaning
Clean the shaving heads thoroughly once a month
for optimal performance.
1Switch off the appliance and make sure it is
disconnected from the wall socket.
14 English

2Press the release button to open the shaving
unit. Pull the shaving unit off the appliance.
2
1
3Turn the lock anticlockwise (1) and remove the
retaining frame (2).
4Remove and clean one shaving head at a time.
Each shaving head consists of a cutter and a
guard.
Note: Do not clean more than one cutter and
guard at a time, since they are all matching sets.
If you accidentally mix up the cutters and
guards, it may take several weeks before
optimal shaving performance is restored.
5Remove the cutter from the shaving guard and
clean both parts under the tap.
6Put the cutter back into the guard.
15
English

7Put the shaving heads back into the shaving
unit.
1
2
8Put the retaining frame back into the shaving
unit (1) and turn the lock clockwise (2).
9Insert the lug of the shaving unit into the slot in
the top of the appliance. Then close the shaving
unit ('click').
Note: If the shaving unit does not close
smoothly, check if you have inserted the
shaving heads properly and if the retaining
frame is locked.
Replacement
Replacing the shaving heads
For maximum shaving performance, we advise you
to replace the shaving heads every two years.
Replace damaged shaving heads immediately.
Always replace the shaving heads with original
Philips shaving heads (see 'Ordering accessories').
1Switch off the appliance and make sure it is
disconnected from the wall socket.
16 English

2Press the shaving unit release button to open
the shaving unit. Pull the shaving unit off the
appliance.
2
1
3Turn the lock anticlockwise (1) and remove the
retaining frame (2). Place it aside in a safe place.
4Remove the shaving heads from the shaving
unit.
Discard the used shaving heads immediately to
avoid mixing them with the new shaving heads.
5Place new shaving heads in the shaving unit.
Note: Make sure that the shaving heads with
the projections fit exactly onto the hooks of the
shaving head holder when placing them. The
shaving heads supplied with the shaver either
have notches or projections. Both shaving
systems are the same.
17
English

1
2
6Put the retaining frame back into the shaving
unit (1) and turn the lock clockwise (2).
7Insert the hinge of the shaving unit into the slot
in the top of the shaver. Then close the shaving
unit.
Note: If the shaving unit does not close
smoothly, check if you have inserted the
shaving heads properly and if the retaining
frame is locked.
Storage
Put the protective cap on the shaver to prevent
damage.
Note: Always let the shaver dry completely before
storing.
Ordering accessories
To buy accessories or spare parts, visit
www.philips.com/parts-and-accessories or go to
your Philips dealer. You can also contact the
Philips Consumer Care Center in your country (see
the international warranty leaflet for contact
details).
Recycling
- Do not throw away the product with the normal
household waste at the end of its life, but hand
it in at an official collection point for recycling.
By doing this, you help to preserve the
environment.
18 English

- This product contains a built-in rechargeable
battery which shall not be disposed of with
normal household waste. Please take your
product to an official collection point or a
Philips service center to have a professional
remove the rechargeable battery.
- Follow your country’s rules for the separate
collection of electrical and electronic products
and rechargeable batteries. Correct disposal
helps prevent negative consequences for the
environment and human health.
Removing the rechargeable shaver battery
Only remove the rechargeable batteries
when you discard the appliance. Before you
remove the batteries, make sure that the
appliance is disconnected from the wall
socket and that the batteries are
completely empty.
Take any necessary safety precautions
when you handle tools to open the
appliance and when you dispose of the
rechargeable battery.
Be careful, the battery strips are sharp.
1Press the shaving unit release button to open
the shaving unit. Pull the shaving unit off the
shaver.
19
English

2Remove the screw in the back of the shaver.
3Remove the back panel by using a flathead
screwdriver.
2×
4Remove two screws and then remove the hair
chamber from the shaver.
5Lift out the front panel.
20 English