Philips S9712 User manual

S99xx/S97xx

1

123

1
12
3
2
1 2 3
4 5

1
2
2
3
3
4
4
5
1 2
34

4
3
8
12
1
4
2
5
67
3

456
2 31
7
8 9 10

S99XX, S97XX
ENGLISH 12
DANSK 39
ΕΛΛΗΝΙΚΑ 66
SUOMI 99
NORSK 125
SVENSKA 151

12
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benet from the support that Philips
offers, register your product at www.philips.com/
welcome.
Please read this user manual, as it contains
information about the features of this shaver as
well as some tips to make shaving easier and more
enjoyable.
General description (Fig. 1)
1 Comb for beard styler attachment
2 Click-on beard styler attachment
3 Click-on trimmer attachment
4 Click-on shaving unit
5 On/off button
6 Socket for small plug
7 Exclamation mark
8 Replacement reminder
9 Travel lock symbol
10 Cleaning reminder
11 Charge symbol
12 Battery charge percentage
13 Personal settings
14 + and - buttons for personal settings
15 Replacement symbol
16 SmartClean system
17 Cap of SmartClean system
18 On/off button
19 Cleaning symbol
20 Drying symbol
21 Progress bar
22 Ready symbol
23 Charge symbol
24 Cleaning cartridge for SmartClean system
ENGLISH

25 Adapter
26 Small plug
27 Retaining ring holder
28 Pouch
Important
Read this user manual carefully before you use the
shaver and the SmartClean system. Save this user
manual for future reference.
Danger
- Keep the adapter dry.
Warning
- The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug, as
this causes a hazardous situation.
- The shaver and the SmartClean system are not
intended for use by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of these appliances by
a person responsible for their safety.
- Children should be supervised to ensure that they
do not play with the shaver and the SmartClean
system.
- Always unplug the shaver before you clean it
under the tap.
Caution
- Never immerse the SmartClean system in water
nor rinse it under the tap.
- Never use water hotter than 80°C to rinse
the shaver.
ENGLISH 13

- Do not use the shaver, SmartClean system,
adapter or any other part if it is damaged,
as this may cause injury. Always replace a damaged
adapter or part with one of the original type.
- Only use the SmartClean system with the original
cleaning cartridge.
- Always place the SmartClean system on a stable,
level and horizontal surface to prevent leakage.
- Always make sure that the cartridge compartment
is closed before you use the SmartClean system
to clean or charge the shaver.
- When the SmartClean system is ready for use,
do not move it to prevent leakage of cleaning uid.
- The SmartClean system thoroughly cleans but
does not disinfect your shaver, therefore do not
share the shaver with others.
- Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as petrol
or acetone to clean the appliance.
- Water may leak from the socket at the bottom
of the shaver when you rinse it.This is normal
and not dangerous because all electronics are
enclosed in a sealed power unit inside the shaver.
Compliance with standards
- This shaver is waterproof and complies with the
internationally approved safety regulations. It is
suitable for use in the bath or shower and for
cleaning under the tap. For safety reasons, the
shaver can therefore only be used cordlessly.
- The shaver and the SmartClean system comply
with all applicable standards and regulations
regarding exposure to electromagnetic elds.
General
- The adapter is equipped with an automatic
voltage selector and is suitable for mains voltages
ranging from 100 to 240 volts.
ENGLISH14

- The adapter transforms 100-240 volts to a safe
low voltage of less than 24 volts.
- Maximum noise level: Lc = 69dB(A)
The display
Note: Before you use the shaver for the rst time,
remove the protective foil from the display.
- S99XX/S97XX
Personal settings
The appliance has a feature that allows you to
personalise your settings.You can choose between
three settings depending on your personal shaving
needs: comfort, dynamic or efciency.
- When you press the - or + buttons, the bar lights
up white continuously.
Charging
- Charging takes approx. 1 hour.
Note: This appliance can only be used cordlessly.
- When the shaver is charging, the battery charge
percentage and the battery symbol ash white.
You hear a sound when you connect the shaver to
the mains.
- The remaining battery capacity is indicated by the
battery charge percentage shown on the display.
- Quick charge: When the battery symbol ashes
white more quickly than normal, the shaver
contains enough charge for one shave.
ENGLISH 15

Battery fully charged
Note: This appliance can only be used cordlessly.
Note: When the battery is full, the display switches
off automatically after 30 minutes. When you press
the on/off button during or after charging, you hear a
sound to indicate that the shaver is still connected to
the mains.
- When the battery is fully charged, the battery
charge percentage lights up white continuously.
Battery low
- When the battery is almost empty, the battery
symbol starts to ash orange and you hear a sound.
Remaining battery capacity
- The remaining battery capacity is indicated by the
battery charge percentage shown on the display.
Cleaning reminder
For optimal shaving performance, we advise you to
clean the shaver after every use.
- When you switch off the shaver, the cleaning
reminder ashes to remind you to clean the
shaver.
Travel lock
You can lock the shaver when you are going to
travel.The travel lock prevents the shaver from being
switched on by accident.
ENGLISH16

Activating the travel lock
1 Press the on/off button for 3 seconds to enter
the travel lock mode.
,While you activate the travel lock, the travel lock
symbol lights up white continuously.When the
travel lock is activated, the shaver produces a
sound and the travel lock symbol ashes.
Deactivating the travel lock
1 Press the on/off button for 3 seconds.
,The travel lock symbol ashes and then lights up
continuously.
The shaver is now ready for use again.
Note: You can also deactivate the travel lock by
connecting the appliance to the mains.
Replacing shaving heads
For maximum shaving performance, we advise you
to replace the shaving heads every two years.
- The appliance is equipped with a replacement
reminder which reminds you to replace the
shaving heads.The replacement reminder lights up
white continuously and the arrows ash white.
You hear a beep to indicate you have to replace
the shaving heads.
Note: After replacing the shaving heads, you need
to reset the shaver by pressing the on/off button for
7 seconds.
ENGLISH 17

Exclamation mark
Blocked shaving heads
- If the shaving heads are blocked, the exclamation
mark lights up orange continuously.The
replacement reminder and the cleaning reminder
ash white alternately and you hear a sound. In
this case, the motor cannot run because the
shaving heads are soiled or damaged.
- When this happens, you have to clean the shaving
heads or replace them.
Overheating
- If the appliance overheats during charging, the
exclamation mark ashes orange.
- When this happens, the shaver automatically
switches off. Charging continues once the
appliance is back to the normal temperature.
Charging
Charging takes approx. 1 hour.
A fully charged shaver has a shaving time of up to
50 minutes.
Note: You cannot use the appliance while charging.
Note: When the battery is fully charged, the display
shows the actual remaining battery charge percentage.
Charge the shaver before you use it for the rst
time and when the display indicates that the battery
is almost empty .
Charging with the adapter
1 Make sure the appliance is switched off.
ENGLISH18

2 Insert the small plug into the appliance (1) and
put the adapter in the wall socket (2).
Charging in the SmartClean system
1 Put the small plug in the SmartClean system.
2 Put the adapter in the wall socket.
3 Hold the shaver upside down above the holder.
Make sure the front of the shaver points
towards the SmartClean system.
4 Place the shaver in the holder (1), tilt the
shaver backwards (2) and press down the top
cap to connect the shaver (‘click’) (3).
Note: The battery symbol lights up to indicate the
appliance is charging.
Using the shaver
Shaving
Skin adaptation period
Your rst shaves may not bring you the result you
expect and your skin may even become slightly
irritated.This is normal.Your skin and beard need
time to adapt to any new shaving system.
We advise you to shave regularly (at least 3 times a
week) with this shaver for a period of 3 weeks
to allow your skin to adapt to the new shaver.
Tip: To ensure the best result, we advise you to pre-trim
your beard if you have not shaved for 3 days or longer.
ENGLISH 19

Note: This appliance can only be used cordlessly.
1 Press the on/off button once to switch on the
shaver.
Tip: Select your personal settings (see chapter
‘The display’).
,The display lights up for a few seconds.
2 Move the shaving heads over your skin in
circular movements.
- Do not make straight movements.
3 Press the on/off button once to switch off the
shaver.
,The display lights up for a few seconds and then
shows the remaining battery charge.
Wet shaving
You can also use this shaver on a wet face with
shaving foam or shaving gel.
To shave with shaving foam or shaving gel, follow the
steps below:
1 Apply some water to your skin.
2 Apply shaving foam or shaving gel to your skin.
3 Rinse the shaving unit under the tap to ensure
that the shaving unit glides smoothly over your
skin.
4 Press the on/off button once to switch on the
shaver.
ENGLISH20