Philips HP4883/00 User manual

JetSet Control ION
HP4883, HP4882

2

3
1

4

HP4883, HP4882
ENGLISH 6
 12
 19
 25
 31
 37
 43
 50
 56
 62
 69
 75
 83
 90
 96
 102

6
Introduction
The Philips JetSet Control ION has been specially designed to meet your
personal needs, giving you frizz-free, beautiful and shiny hair.The ioniser
inside the hairdryer emits negatively charged ions that surround your hair.
Negative ions reduce the build-up of static electricity and help to keep
your hair in good condition, making it frizz-free and smooth.
Next to the Ion function, this hairdryer offers you a variety of heat and
speed settings. In addition, this hairdryer has a Jet position for an ultra-
strong airow and a Set position for a cool shot. This gives you optimal
styling freedom and optimal control over your hairstyle.
You can visit our website at www.philips.com/beauty for more
information about this product or any other Philips beauty product.
General Description (Fig. 1)
AAir inlet grille
B Temperature slide switch
C Airow slide switch
D JetSET switch
E Ion slide switch
FHanging loop
GVolume diffuser (HP4883 only)
HConcentrator
IIon indicator light
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the cord or the appliance itself is damaged.
If the mains cord is damaged, it must be replaced by Philips, a
service centre authorised by Philips or similarly qualied persons in
order to avoid a hazard.
,
,
,
ENGLISH

Keep this appliance away from water! Do not use this product near
or over water contained in baths, washbasins, sinks etc.When used
in a bathroom, unplug the appliance after use since the proximity of
water presents a risk, even when the hairdryer is switched off.
For additional protection, we advise you to install a residual current
device (RCD) with a rated residual operating current not
exceeding 30mA in the electrical circuit supplying the bathroom.
Ask your installer for advice.
Keep the appliance out of the reach of children.
Never block the air grilles.
If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grilles to make sure they
are not blocked by uff, hair, etc.
Always switch the appliance off before putting it down, even if it is
only for a moment.
Always unplug the appliance after use.
Do not wind the mains cord round the appliance.
You may notice a characteristic odour when using this hairdryer.
This is caused by the ions that are generated and it is not harmful
to the human body.
Do not probe the ion generator with metal objects.
Noiselevel: Lc = 84 dB(A)

Drying
1 Put the plug in the wall socket.
2 Switch the appliance on by selecting the desired airow setting:
Set the slide switch to airow setting II for ultra-quick drying.
Set the slide switch to airow setting I for drying short hair or styling
your hair.
You can also use the Jet position of the JetSet switch for an extra-
powerful airow. (Fig. 2)
,
,
,
,
,
,
,
,
,
,
,
-
-
,
ENGLISH 7

3 Set the temperature slide switch to the Quick-Dry, Caring or
Fixation setting.
6
The Quick-Dry setting enables you to dry shower-wet hair very
quickly. (Fig. 3)
It is recommended to use the Quick-Dry setting only on shower-wet hair
and to select the Caring setting when the hair is almost dry in order to
reduce the risk of overdrying.
5
The Caring setting gently dries the hair at a caring temperature.
(Fig. 4)
4
The Fixation setting xes the style you have created. (Fig. 5)
For long-lasting styling results, set the switch to the Fixation setting and
direct the cool airow at your hair to x your style.
You can also use the Set position of the JetSet switch to x your
style. (Fig. 6)
4 Switch the Ion function on or off by means of the Ion on/off switch.
The ion function reduces frizz and static electricity and is particularly
suitable for dry and almost-dry hair.
5 Dry your hair by making brushing movements with the hairdryer at
a small distance from the hair. (Fig. 7)


The concentrator enables you to direct the airow straight at the brush
or comb with which you are styling your hair.
1 Connect the concentrator by simply snapping it onto the appliance.
Disconnect it by pulling it off. (Fig. 8)
,
,
,
,
ENGLISH8

2 Switch the appliance on by setting the airow slide to position I or
II.
3 While you are drying your hair with the concentrator, you can use
a brush or comb to style your hair. (Fig. 9)
Volume diffuser (HP4883 only)
The volume diffuser has been specially developed to gently dry both
straight and curly or wavy hair.
The volume diffuser emits a gentle airow and allows you to give
your style volume and bounce. (Fig. 10)
1 Connect the diffuser by simply snapping it onto the appliance and
align the arrows on the diffuser and the barrel. Disconnect it by
pulling it off. (Fig. 11)
To add volume at the roots, insert the pins into your hair in such a
way that they touch your scalp. (Fig. 12)
2 Make rotating movements with the appliance to distribute the
warm air evenly through your hair. (Fig. 13)

When you are styling curly or wavy hair, hold the diffuser at a
distance of 10-15 cm from your head to let the hair dry gradually.
(Fig. 14)
In the meantime you can style your hair with your free hand or with a
comb.
You can also scrunch locks of hair in your hand to model the curls
and waves while drying. This will prevent the curls from sagging or
becoming frizzy.

To dry long hair, you can spread out locks of hair on top of the
diffuser. (Fig. 15)
Alternatively, you can comb the hair downwards with the pins of
the diffuser while drying. (Fig. 16)
,
,
,
-
-
,
,
ENGLISH 9


Always unplug the appliance before cleaning it.
Never rinse the appliance with water.
Open the inlet grille to remove hairs and dust.
Clean the appliance with a dry cloth.
Clean the attachments with a moist cloth or by rinsing them under
the tap.
Remove the attachments from the appliance before cleaning them.
Storage
Always unplug the appliance before storing it.
Put the appliance in a safe place and let it cool down.
Do not wind the mains cord round the appliance.
The appliance can be stored by hanging it from its hanging loop.

Do not throw the appliance away with the normal household waste
at the end of its life, but hand it in at an ofcial collection point for
recycling. By doing this you will help to preserve the environment.
(Fig. 17)

If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care
Centre in your country (you will nd its phone number in the worldwide
guarantee leaet). If there is no Customer Care Centre in your country,
turn to your local Philips dealer or contact the Service Department of
Philips Domestic Appliances and Personal Care BV.
,
,
,
,
,
,
,
ENGLISH10