Philips HP2710/71 User manual

FEATURES
FULL TWO YEAR WARRANTY
Philips Electronics North America Corporation warrants each new Philips
Product, Model HP2710 (except foil and trimmers), against defects in materials
or workmanship for a period of two years from the date of purchase, and
agrees to repair or replace any defective product without charge.
IMPORTANT: This warranty does not cover damage resulting from accident, mis-
use or abuse, lack of reasonable care, the affixing of any attachment not provided
with the product or loss of parts or subjecting the product to any but the specified
batteries.* Use of unauthorized replacement parts will void this warranty.
PHILIPS ELECTRONICS NORTH AMERICA CORPORATION WILL NOT PAY FOR
WARRANTY SERVICE PERFORMED BY A NON-AUTHORIZED REPAIR SERVICE
AND WILL NOT REIMBURSE THE CONSUMER FOR DAMAGE RESULTING FROM
WARRANTY SERVICE PERFORMED BY A NON-AUTHORIZED REPAIR SERVICE.
NO RESPONSIBILITY IS ASSUMED FOR ANY SPECIAL, INCIDENTAL OR CON-
SEQUENTIAL DAMAGES.
In order to obtain warranty service, simply take or ship the product postage
prepaid to the nearest Authorized Norelco Service Location. It is suggested that
for your protection you return shipments of product by insured mail, insurance
prepaid. Damage occurring during shipment is not covered by this warranty.
NOTE: No other warranty, written or oral, is authorized by Philips Electronics
North America Corporation.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above exclusion and
limitations may not apply to you.
*Read enclosed instructions carefully.
Manufactured for:
Norelco Consumer Products Company
A Division of Philips Electronics North America Corporation
1010 Washington Blvd.
Stamford, CT 06912-0015
MADE IN AUSTRIA.
Norelco is a Registered Trademark of
Philips Electronics North America Corporation.
Total Body is a Trademark of
Philips Electronics North America Corporation.
PHILIPS and Philips Shield are Registered Trademarks of
Koninklijke Philips Electronics N.V.
© 2000 Philips Electronics North America Corporation. All Rights Reserved.
HP2710 Cordless
Wet • Dry Razor
60-Day Money-Back Guarantee
If you are not fully satisfied with your Philips Lady Shave Razor,
Philips will refund you the full purchase price.
The razor must be shipped prepaid by insured mail, insurance
prepaid, and have the sales receipt, indicating purchase price
and the date of purchase, enclosed. The razor must be post-
marked no later than 60 days after the date of purchase. Philips
reserves the right to verify the purchase price of the razor and limit
refunds not to exceed suggested retail price. Send dated sales
receipt, your complete name and address as indicated below, and
the razor, prepaid to:
Norelco Consumer Products Company
A Division of
Philips Electronics North America Corporation
P.O. Box 1116
Skokie, IL 60076
Please allow 4-6 weeks for delivery of check.
Please Print!
NAME:
ADDRESS:
CITY:
STATE: ZIP:
TELEPHONE NO.: ( )
REASON FOR RETURNING:
Area Code
Give your new Razor a chance!
Like many new products, your Philips Lady Shave
may take a little getting used to. If you are using a
battery razor for the first time, or if you’ve been using
a different brand, your skin may need time to adapt.
Give yourself a little time to practice and determine
the best stroking motions for the best shave.
Use it exclusively for 3 to 4 weeks, or a bit longer
for sensitive skin. If you alternate shaving
or other hair removal methods during this
adjustment period, it may make it more difficult
to adapt to the Philips shaving system.
At first you may not get as close a shave as you
expect, or your skin may become slightly irritated.
This is normal as your skin adjusts. After this adjust-
ment period, you’ll find that you can remove hair with-
out irritating your skin, for a close, smooth shave.
The Philips Lady Shave Razor... the choice for close,
smooth shaving results.
IMPORTANT
leak, remove them carefully. Do not allow
bare skin to touch leaking fluid.
8. Do not attempt to recharge alkaline, heavy
duty, or regular batteries in a nickel-cadmi-
um battery charger.
9. Dispose of used batteries properly. Do not
wrap in metal or aluminum foil. Wrap in
newspaper before discarding. Do not incin-
erate. Batteries may explode if overheated.
It is suggested that you contact local town/
city officials to determine proper battery
redemption site(s) in your area.
10. Razor is water-safe and can be used in the
bath or shower. Do not submerge in water
for extended period of time.
SAVE THESE
INSTRUCTIONS
When using a battery-operated appliance,
basic precautions should always be followed,
including the following: Read All Instructions
Before Using This Appliance.
1. Close supervision is necessary when this
razor is used by, on, or near children or
invalids.
2. Use this razor for its intended household
use as described in this manual. Do not
use attachments not recommended by
Philips Electronics North America
Corporation.
3. Never operate this razor if it is not working
properly or if it has been dropped or dam-
aged. Return the razor to an Authorized
Norelco Service Location for examination
and repair.
4. Never drop or insert any object into any
opening.
5. Do not operate where aerosol (spray) prod-
ucts are being used or where oxygen is
being administered.
6. Always check foil before use. Do not
use this razor with a damaged or broken
foil or trimmer, as injury may occur.
7. If razor will not be used on a regular basis,
remove batteries to prevent possible dam-
age due to chemical leakage. If batteries do
IMPORTANT SAFETY
INSTRUCTIONS
Removable Angled
Shaving Head Total Body Shaving
System:
Two Trimmers for
longer hairs
Fully Submersible
Cordless-Operates on 2
“AA” 1.5V alkaline or
carbon zinc batteries
(not included)
Protective Cap for
Shaving Head
Cleaning Brush
Foil for legs and
underarms
Easy Slide On/Off
Switch
If you need
help, answers
or service,
please call us
at 1-800-243-7884
Or visit our Website at
www.philipsonline.com

1. Prepareunderarmsand
othersensitiveareas for
wetor dry shaving(see
BEFOREUSINGYOURNEW
PHILIPSRAZOR section).
2. Turn Razor on.
3. Lift your arm until skin
under arm stretches
slightly.
■For shaving other sensi-
tive areas, stretch skin
taut with your fingers.
4. Hold Razor so that
Shaving Head is in full
contact with the skin.
Shave with gentle
strokes, using light
pressure (Fig. 6).
■Pressing too hard may
■Before using, check foil
for wear or damage. If
foil shows signs of wear
or damage, do not use
shaver as injury may
occur. Do not use until
foil has been replaced.
■For wet shaving, you
may wish to prepare
your skin with soap or
shaving cream before
shaving.
■For dry shaving, be cer-
tain that your skin is
clean. If you have sensi-
tive skin, you may wish
to apply talcum powder
before and/or after
shaving.
■When shaving your
legs, underarms or biki-
ni line, it is not neces-
sary to press hard to get
a close shave. Pressing
too hard may cause skin
irritation, and razor will
not function properly. In
addition, do not use
deodorant or alcohol
based lotions immedi-
ately before or after
shaving. You may, how-
ever, want to use talcum
powder.
■Clean Razor regularly
following MAINTE-
NANCE instructions.
■Do not submerge Razor
in water for extended
periods of time.
■To keep Razor water-
resistant, keep the rub-
ber sealing ring in bat-
tery compartment clean
and dry. Occasionally
you may want to apply a
thin coating of petrole-
um jelly to ring to keep
it from drying out.
1. BEFORE USING YOUR NEW PHILIPS RAZOR
After each use, Razor
should be quickly cleaned
by rinsing under running
water or dipping and shak-
ing gently in water.
■Never immerse Razor in
water while battery
compartment is open.
IMPORTANT: DO NOT
keep Razor submerged in
water for a long period of
time.
■For assistance or the
Authorized Norelco
Service Location near-
est you, call toll free:
■Or visit our Website at
www.philipsonline.com.
Authorized Norelco Service
Location information is
available 24 hours a day, 7
days a week.
6. PRODUCT
ASSISTANCE
7
8
OIL
6
9
11
10
12
13
2
3
4
5
1
■Your new Philips Razor
requires 2 “AA” 1.5 volt
alkaline or carbon zinc
batteries.
■Be sure hands and
Razor are dry before
inserting or replacing
batteries.
1. Be certain Razor is in
Off position.
2. Hold Razor upside down
and remove Battery
Compartment cover by
grasping cover on both
sides. Slide cover away
from Razor body (Fig. 1).
3. Insert batteries as
shown, making sure the
(+) and (-) markings on
ends of batteries match
those on inside of com-
partment (Fig. 2).
4. Replace Battery Com-
partment cover by slid-
ing cover back onto
Razor body (Fig. 3).
2. INSTALLING OR CHANGING BATTERIES
1. Preparelegs forwet or dry
shaving (see BEFORE
USING YOUR NEW
PHILIPS RAZOR).
2. Turn Razor on (Fig. 4).
3. Hold Razor so that
Shaving Head is in full
contact with your skin.
Shave with smooth,
steady strokes, against
the direction of hair
growth (Fig. 5).
■Pressing too hard may
cause skin irritation.
■Practice is best for opti-
mum results.
4. Turn Razor Off.
3. SHAVING LEGS
cause skin irritation,
and Razor will not func-
tion properly.
5. Do not use deodorant or
alcohol based lotions
immediately before or
after shaving. You may,
however, want to use
talcum powder.
6. Turn Razor Off (Fig. 7).
4. SHAVING
UNDERARMS
4. SHAVING
UNDERARMS (CONT.) IMPORTANT
■It is recommended that
you replace your shav-
ing foil once a year.
■Switch Razor Off before
cleaning.
■Never clean, remove, or
replace Shaving Head
while motor is on.
■Do not apply pressure
or touch Shaving Head
with hard objects as this
may dent or damage foil
or trimmers. If damage
occurs, replace foil.
■Check foil regularly.
■Replace foil once a year.
5. MAINTENANCE/CLEANING INSTRUCTIONS
A. AFTER EACH USE B. ONCE A MONTH-
CLEANING SHAV-
ING HEAD
IMPORTANT: DO NOT
apply pressure to Shaving
Foil.
1. To remove Foil Guard,
simultaneously press in
small buttons on both
sides of Razor on
Angled Shaving Head
while pulling head up
and out (Fig. 9). Rinse
under water to remove
hairs (Fig. 10).
■Hold Shaving Foil by
plastic housing only -
Shaving Foil is very
delicate and should
not be handled. If foil
becomes worn or
damaged, replace it.
2. Remove Cutter Block as
shown (Fig. 11). Hairs
can be removed from
Cutter Block by using a
soft brush, by lightly
blowing out hairs, or
running under water
(Fig. 12).
NOTE: Avoid using brush
on Cutter Block as this may
cause damage.
■Body of Razor and
Shaving Head, including
Shaving Foil, may be
rinsed under running
water to remove hairs
(Fig. 13).
3. Be sure all parts are dry
before reassembling.
NOTE: Razor will not
operate if batteries are
inserted incorrectly.
■If Razor will not be used
on a regular basis,
remove batteries.
■Never use a razor with a
damaged or broken foil.
■For best shaving perfor-
mance, it is suggested
to lightly oil Shaving
Head regularly by
spreading a drop of
mineral oil over the foil
and trimmers (Fig. 8). If
this does not improve
the performance of your
razor, it may be time to
change foil.
■If Razor will not be used
on a regular basis,
remove batteries.
■Do not use cloth or
towel to dry Shaving
Foil or Cutter Block;
allow to air dry.
4. Replace Cutter Block
and Shaving Foil by
gently pressing back
into position on Shaving
Head.
■Hold Razor Head by
plastic housing only.
NOTE: Use cold or luke-
warm water. Never use
cleaners such as alcohol or
nail polish remover.
1-800-243-7884