Philips Ladyshave HP6302/01 User manual

Ladyshave
HP6302/
01

2

3
shaving foil
on/off switch
battery cap
brush

4

ENGLISH 6
12
18
HP6302/01

Introduction
◗With your new Philips Ladyshave you can
quickly, easily and comfortably remove
unwanted hair from dry or wet skin.
◗The Ladyshave can be operated on batteries.
Important
◗Do not use warmer water than shower
temperature 35ºC
Preparing the appliance use
The Ladyshave runs on two R6 AA 1.5 volt
batteries.
We strongly advise you to use Philips LR6
PowerLife batteries.They supply sufficient energy
for approx. 45 minutes of shaving.
1Make sure that your hands and the
appliance are dry when you insert the
batteries.
C2Pull the upper part of the Ladyshave off
the lower part.
C3Insert the batteries into the battery
compartment.
Make sure you place the batteries in accordance
with the + and - indications.
4Reattach the lower part of the appliance
to the upper part.
ENGLISH6

◗To avoid damage due to battery leakage:
BDo not expose the Ladyshave to direct sunlight.
BDo not expose the appliance to temperatures
higher than 35cC.
BRemove the batteries if the appliance is not going
to be used for a month or more.
BDo not leave empty batteries in the appliance.
Using the appliance
C1Switch the Ladyshave on.
2Place the shaving head on the skin and
move it slowly against the direction of the
hair growth.
C◗The Ladyshave is suitable for shaving the
underarms.
C◗The Ladyshave is suitable for shaving the bikini
line.
C◗The Ladyshave is suitable for shaving the legs.
ENGLISH 7

Cleaning the appliance
Clean the Ladyshave every time you have used it.
Do not use any corrosive detergents, scouring
pads or cloths, petrol, acetone etc. to clean the
appliance.
1Switch the appliance off.
C2Remove the shaving foil.
Do not exert any pressure on the shaving foil to
avoid damage.
3Gently shake the shaving foil to remove
hairs.
4Brush the shaving foil.
C5Remove the cutter block.
6Gently shake the Ladyshave to remove
hairs from the hair chamber.
C7Brush the hair chamber.
C8Reassemble the appliance and put the
protection cap on the appliance to store it.
The cap fits with a click.
ENGLISH8

Maintenance and replacement
C1Lubricate the shaving foil with a drop of
sewing machine oil twice a year.
If you use the Ladyshave twice a week or more,
we advise you to replace the shaving foil and
cutter block every one to two years.
◗The shaving foil may only be replaced with an
original Philips shaving foil (type HP2910).
◗The cutter block may only be replaced with
an original Philips cutter block (type HP2911).
The environment
Do not throw batteries away with the normal
household waste, but hand them in at an official
collection point.You can also take the batteries to
a Philips Service Centre, which will dispose of
them in an environmentally safe way.
Troubleshooting guide
1Reduced shaving performance
BCause 1:The shaving head is dirty.
◗Remove the shaving head
◗Clean the cutter block
◗Rinse both under the tap
◗Take care that no hair stuck under the
trimmer!
ENGLISH 9
OIL

10 ENGLISH
BCause 2:Too low rpms (The shaver sound weak)
◗change the batteries
◗clean the shaving head
◗oil the shaving head with some drops of oil
2Stronger skin irritation than normally
BCause 1: Shaving foil is worn out or damaged
◗Replace the shaving foil
3Appliance is not working
BCause 1: Batteries are empty
◗change the batteries
BCause 2: Batteries are not correct in the battery
compartment
◗Put them into the battery compartment
according to the pictograms in the
compartment
BCause 3: Battery compartment is not closed
properly
◗Close it until you hear a click
4Appliance has been falling into water while
it was open
◗let it dry with open battery compartment