Philips SHC5100 User manual

EN User manual
SHC5100
www.philips.com/welcome
Register your product and get support at Indoor wireless headphones

BA
CD
a b
d e
c
F
G
E
H
21
CHANNEL
21
CHANNEL
CHANNEL
1 2
CHANNEL
1 2

3EN
English
Contents
1 What’s in the box 4
2 Get started 5
3 Product version table 6

4EN
1 What’s in the box
1) Headphone 2) Transmitter
3) AC/DC adaptor 4) Antenna tube
5) 2 x AAA rechargeable shortened sleeve NiMH batteries
(SBC HB550L)

5EN
English
2 Get started
Note
Before using the headphones for the rst time, charge the supplied •
batteries for at least 10 hours.
•Only use Philips rechargeable shortened sleeve NiMH batteries with your
headphones. Other types of rechargeable batteries cannot be charged
with this system.
•AAA alkaline batteries can be used to operate the headphones, but cannot be
charged with this system.
If the volume of the audio source is insufcient, the transmitter •
automatically turns off.
1Install/Replace supplied batteries (Fig. B).
2Install the antenna tube into the transmitter (Fig. C).
3Power on the transmitter (Fig. D).
Red LED is on when audio source is connected.»
Red LED blinks if no audio source is connected for two»
minutes.
Red LED is off if no audio source is connected for four»
minutes.
4 To charge the headphones, connect the charging cable with
the headphones (Fig. E).
Headphones: red LED is off during charge.»
Transmitter: green LED is on during charge and is off when»
headphones are fully charged.
5Power on the headphones and red LED is on (Fig. F).
6Connect the audio device with the transmitter (Fig. G).
Red LED is on when audio source is connected.»
Tip
If there is interference, tune the transmitter and the headphones to the •
same channel (Fig. H).