Philips MCM277/98 User manual

MCM 277
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
MW antenna
Quick Start Guide
User Manual
AUX
PDISPLAY TIMER SLEEP
CLOCK
RDS/NEWS
DBBDSC
PROG
REPEAT
SHUFFLE MUTE
OPEN/CLOSE
Remote control with
1 x CR2025 battery
Quick start guide User manual
Stand
140mm (5.51")
Mounting kit
(1x template, 2 x screws)
Prepare
Install
Enjoy
Step A
Step
Step
B
C
FM wire antenna
MCM277 QSG_98-Eng 2008.1.4, 14:561

2
Install
Mounting stand onto the set
1
2
3
Put MCM277 on a flat and firm surface, rear side facing up
As shown, align the stand to the slots at set’s bottom, 4FRONT facing
down
Push the stand down into the slots
PRESS
FRONT
FRONT
PRESS
Rear connections
3
Connect the cable of the left speaker to LEFT (red and black) and the cable
of the right speaker to RIGHT (red and black)
Extend the wire antenna and fit it to FM ANTENNA
a. Assemble the loop antenna
b. Fit the plug of the loop antenna to AM ANTENNA
Connect the AC power cord to the wall socket
4
1
AM
ANTENNA
Helpful hints:
- For wall mounting, please refer to the User Manual, Appendix: How to mount
your MCM277 onto Walls. You may need assistance from the qualified service
personnel.
MW loop
antenna
Speaker
(left)
Speaker
(right)
FM wire
antenna
AC power cord
MCM277 QSG_98-Eng 2008.1.4, 14:562

Prepare
Setting the clock
1
2
3
4
5
In the standby mode, press and hold DISPLAY/CLOCK on the remote control
➜24 HR or 12 HR appears for the initial clock setting. To select 12-hour clock or
24-hour clock,
a. Press VOL +/- once or more
b. Press DISPLAY/CLOCK to confirm
➜ The hours digits start flashing
Hold down or press VOL +/- repeatedly to set the hours
Press DISPLAY/CLOCK to confirm
Hold down or press VOL +/- repeatedly to set the minutes
Press DISPLAY/CLOCK to confirm
Enjoy
1
2
3
4
5
Playing discs
With this system, you can play all pre-recorded audio CDs (CDDA), all finalized audio CD-Rs
and CD-RWs, MP3/WMA-CDs (CD-Rs/CD-RWs with MP3/WMA files)
Press SOURCE once or more to select CD (or CD on the remote control)
Press CD OPEN•CLOSEçto open the CD compartment
Insert a disc with the printed side facing up. Press CD OPEN•CLOSEçagain
to close the compartment
Press ÉÅ to start playback
To stop playback, press STOPÇ
Notes for remote control:
– First, select the source you wish to
control by pressing one of the source
select keys on the remote control (DISC
or TUNER, for example).
–Then select the desired function
(2;,
4 , ¢ for example).
IMPORTANT!
– Remove the protective plastic
tab before using the remote
control
Remove the plastic protective sheet
MCM277 QSG_98-Eng 2008.1.4, 14:563

Tuning to radio stations
1
2
3
1
2
3
Check you have unfolded the control panel
Insert the USB device’s USB plug into the socket on the set ‘s foldable control panel
Press SOURCE once or more to select USB (or USB on the remote control)
PDCC-JW-0801
CRoyal Philips Electronics N.V. 2008
All rights reserved.
http://www.philips.com
Detailed playback features and additional functions are described in the accompanied
owner's manual.
Press SOURCE once or more to select TUNER (or TUNER on the remote control)
Press and hold PROG until AUTO appears
➜ flashes. Available stations are programmed: RDS stations followed by FM stations,
MW stations
Press the 3/ 4buttons once or more until the desired preset station is
displayed
Playing a USB mass storage device
With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1),
USB flash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to
work with this Hi-Fi system).
4
Play the USB’s audio files as you do with the albums/tracks on a CD
Enjoy
5
Press STANDBY-ON y to switch off the set
MCM277 QSG_98-Eng 2008.1.4, 14:564