Philips DDNP1501 User manual

features
installation steps
To reduce the risk of fire or electric shock, do not expose
this device to rain or moisture. Do not energise unless the
front cover is in place. This device must be earthed.
Installation, programming and maintenance must be
carried out by qualified personnel.
0.24A Single Phase Supply
15V DC Regulated Output
Output is Short Circuit Proof
Enclosure is DIN Rail Mount with Circuit Breaker Profile
Simple Installation - DIN Rail mount facilitates installation.
All connection terminals are accessible without disassembly
Warning –This is a class A product. In a domestic environment
this product may cause radio interference in which case the user
may be required to take adequate measures.
Read Instructions –We recommend that you read this
Instruction Manual prior to commencement of installation.
Power Sources –This device should only be operated from the
type of supply specified on the front cover. This device must be
earthed.
Output –The load on this device should not exceed the specified
capacity of 1.5A. This device should be fed via a HRC fuse or
MCB.
Mounting Location –Install in a dry, well-ventilated location.
Controllers may emit some mechanical noise. Take this into
account when deciding the mounting location.
Data Cable –Use screened, stranded RS485 data cable with
three twisted pairs. Segregate from mains cables by 300mm
minimum. Connect devices in a ‘daisy chain’. A data cable that is
connected to an energised device is live. Do not cut or terminate
live data cables.
1. Mount the device on a DIN rail inside an approved enclosure.
2. Connect a single phase 0.25A feed to the control circuit supply terminals. This device must be earthed.
3. Connect the two power conductors of data cables to the device. There are two common methods of doing this:
a) Method 1: Use a 2 core cable to connect between the DDNP1501 and the data cable connector on a device that is
connected to the network. Parallel connect the GND and +12V terminals on the DDNP1501 to the GND and +12V
terminals on the network device.
b) Method 2: Loop the network cable to the DDNP1501 and connect the Green pair to GND terminal and Orange pair to
+12V terminal. Ensure that the other conductors are looped through using a suitable terminal block.
………
DDNP1501
15v DC network power supply
Installation Manual

Electrical Diagram
product specifications
DDNP1501 Instruction Manual Rev H.doc Specifications subject to change without notice
Dynalite manufactured by WMGD Pty Ltd (ABN 33 097 246 921) Unit 6, 691 Gardeners Road Mascot NSW 2020 Australia Tel: [phone] Fax: [phone]
E-Mail: [email protected] Web: Philips.com/dynalite
Supply: 110 - 240V AC 50/60Hz Single Phase at 0.24A
Load Outputs: 15 Volt DC @ 1.5 Amps (@230V supply), 15 Volt DC @ 1.0 Amps (@110V supply)
Electrical Design: Switchmode
Protection: Self resetting overload protection. Short circuit proof, Automatic thermal shutdown
Supply Terminals: Line, Neutral, Earth, 1 x 2.5mm2 max conductor size
User Controls: LED power indicator on front panel
Output Terminals: 0V, +15V, 1 x 2.5mm2 max conductor size, Loop terminals provided for DyNet Shield, D−, D+
Compliance: CE, C-Tick
Operating Environment: 0º to 50ºC ambient temperature, 0% to 95% RH non condensing
Construction: Polycarbonate DIN rail enclosure, 6 units wide
Dimensions: H 93mm x W 105mm x D 75mm
Weight: Packed weight 0.2kg