Philips OST690 User manual

www.philips.com/welcome
OST690
Always there to help you
User Manual
Question?
Contact
Philips
Register your product and get support at

2EN
Contents
1 Important 3
2 Your Speaker System 4
Introduction 4
What's in the box 4
Overview of the system 5
3 Get started 6
Connect power 6
Turn on 7
Turn off 7
Switch to standby mode 7
4 Play 8
Play from a USB device 8
Play from Bluetooth-enabled device 9
Play from an external audio device 9
5 Listen to FM radio 10
Tune to FM radio stations 10
Store radio stations automatically 10
Store radio stations manually 10
Select a preset radio station 10
6 Other features 11
Charge your mobile phone 11
Adjust display brightness 11
Adjust volume 11
Enhance bass 11
7 Product information 12
Specications 12
Supported MP3 disc formats 12
USB playability information 12
8 Troubleshooting 13
About Bluetooth device 14
9 Notice 14

3EN
1 Important
• Read these instructions.
• Follow all instructions.
• Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
• Do not install near any heat sources such
as radiators, heat registers, stoves, or
otherapparatus(includingampliers)that
produce heat.
• Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the unit.
• Only use attachments or accessories
speciedbythemanufacturer.
• Unplug this unit during lightning storms or
when unused for long periods of time.
• Referallservicingtoqualiedservice
personnel. Servicing is required when the
unit has been damaged in any way.
• Battery usage CAUTION – To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
unit:
• Install all batteries correctly, + and - as
marked on the unit.
• Do not mix batteries (old and new or
carbonandalkaline,etc.).
• Remove batteries when the unit is not
used for a long time.
• Batteries (battery pack or batteries
installed)shallnotbeexposedtoexcessive
heatsuchassunshine,reorthelike.
• Tropical condition has been considered
and complied.
• The unit shall not be exposed to dripping
or splashing.
• Do not place any sources of danger on
theunit(e.g.liquidlledobjects,lighted
candles).
• Where the MAINS plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
Warning
•Never remove the casing of this unit.
•Never place this unit on other electrical equipment.

4EN
2 Your Speaker
System
Introduction
With this speaker system, you can:
• listen to FM radio;
• enjoy audio from Bluetooth-enabled
devices, USB device, and other external
audio devices; and
• charge your mobile phone with the
supplied USB cable.
The system offers you Dynamic Bass Boost
(DBB)toenrichsound.
What's in the box
Check and identify the contents of the package:
• Main unit
• AC power cord
• USB cable for charging
• Short user manual
• Safety&noticeleaet

5EN
Overview of the system
a Source selector
• Select a source: BLUETOOTH, FM, or
USB.
b LED indicator
c ON/OFF
• Turn the system on or off.
d
• Connect a USB storage device.
• Charge a mobile phone with the
supplied USB cable.
e AUDIO IN
• Connect an external audio device.
f Slider
• Stabilize the mobile phone while
charging.
g VOLUME
• Adjust volume.
h - TUNING +
• Tune to FM radio stations manually.
a
b
c
d
e
l
m
n
k
h
i
j
g
f
r
q
p
o
MODE PROG
SEARCH
-
PRESET
-
PROGPRESET +
SEARCH +
ALBALB
i DBB
• Turn dynamic bass enhancement on
or off.
j Display panel
k FM antenna
• Improve FM radio reception.
l ALB/PRESET -/+
• Select a preset radio station.
• Skip to the previous or next album.
• Adjust display brightness.
m MODE
• Selectarepeatorshufemode.
• Activate brightness adjustment.
n / SEARCH+/-
• Skip to the previous or next track.
• Tune to FM radio stations automatically.
• Search within a track.
o PROG
• Program the play sequence of tracks.
• Program FM radio stations.

6EN
p
• Open or close the compartment.
q
• Start or pause play.
r
• Stop play.
• Erase a program.
3 Get started
Always follow the instructions in this chapter in
sequence.
Connect power
The system can be powered by either AC
power or batteries.
Option 1: Battery power
Caution
•Batteries contain chemical substances, so they should
be disposed of properly.
Note
•Batteries are not supplied with the accessories.
1 Open the battery compartment.
2 Insert6batteries(type:R14/UM2/CCELL)
withcorrectpolarity(+/-)asindicated.
3 Close the battery compartment.

7EN
Option 2:AC power
Warning
•Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or the underside of the system.
•Risk of electric shock! When you disconnect the AC
power, always pull the plug from the socket. Never pull
the cord.
Connect the AC power cord to:
• the AC~ MAINS socket on the back of the
system.
• the wall outlet.
Tip
•To save energy, turn off the system after use.
Turn on
Switch the power slide to the ON position.
» The system switches to the last selected
source.
» The LED indicator lights up.
Turn off
Switch the power slide to the OFF position.
» The LED indicator turns off.
Switch to standby mode
• In AC power supply mode, if there is no
operation for 3 hours, this product will
switch to standby mode automatically for
energy-saving.Aftertherst30-minute
inactivity, the display will start to show the
remaining time before entering standby
mode(from149:59to0:00).
• In DC power supply mode, if there is no
operation for 15 minutes, this product
will switch to standby mode automatically
forenergy-saving.Aftertherst5-minute
inactivity, the display will start to show the
remaining time before entering standby
mode(from9:59to0:00).
» You may press to cancel the
countdown and resume normal operation,
or continue charging.

8EN
4 Play
Play from a USB device
Note
•Make sure that your USB device contains playable audio
content.
1 Rotate the source selector to the USB
position.
2 Press to open the compartment.
3 Insert the USB device into the socket
inside the compartment.
» Play starts automatically. If not, press
.
Note
•The USB socket is not compatible with music playback
from your smartphone.
Control play
In USB mode, you can control play through the
following operations.
/ Selectanaudiole;
Press and hold to fast-forward
or fast-reverse the track during
playback, then release to resume
play.
ALB-/
ALB+
Skip to the previous or next MP3/
WMA album.
Start or pause play.
Stop play.
MODE [ ]: Play the current track
repeatedly.
[ ]: Play the current album
repeatedly.
[ ]: Play all tracks repeatedly.
[ ]: Play tracks randomly.
To return to normal play, press
MODE repeatedly until the repeat
orshufeiconsdisappear.
Program tracks
In USB mode, you can program the play
sequence of tracks. A maximum of 20 tracks
can be programmed.
1 Press to stop playback.
2 Press PROG to activate the programming
mode.
» [PROG] is displayed and [P01] begins
to blink.
3 For MP3/WMA tracks, press ALB -/ALB +
to select an album.
4 Press / to select a track number,
then press PROGtoconrm.
5 Repeat steps 3-4 to program more tracks.
6 Press to play the programmed tracks.
» During play, [PROG] (program)is
displayed.
• To erase the program, press twice.

9EN
Play from Bluetooth-enabled
device
Note
•The effective operating range between the system and
thepaireddeviceisapproximately10meters(30feet).
•Any obstacle between the system and the device can
reduce the operational range.
•Compatibility with all Bluetooth devices is not
guaranteed.
1 Rotate the source selector to the
BLUETOOTH position.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
that can be paired (refer to the user
manualofthedevice).
3 When [OST690] is displayed on your
device, select it to start pairing and
connection.
» After successful pairing and connection,
the system beeps twice.
4 Play audio on your device.
» Audio streams from your device to this
system.
To disconnect the Bluetooth-enabled device:
• Deactivate Bluetooth on your device; or
• Move the device beyond the
communication range.
To clear Bluetooth pairing history:
Press and PROG together for 3 seconds.
» The current Bluetooth connection is
disconnected.
» After successful clearing, [CLR](clear)
blinks for 5 seconds, then [-] scrolls on the
display.
Play from an external audio
device
You can also listen to an external audio device
such as an MP3 player through this system.
1 Press to open the compartment.
2 Connect an audio cable (3.5mm, not
supplied)to:
• the AUDIO IN socket inside the
compartment.
• the headphone socket on an external
device.
» The system switches to Audio-in mode
automatically.
3 Play audio on the external device (see the
usermanualofthedevice).

10EN
5 Listen to FM
radio
Tune to FM radio stations
Note
•For better reception, fully extend and adjust the
position of the FM antenna.
1 Rotate the source selector to the FM
position.
2 Press SEARCH +/-.
» The system tunes to a station with
strong reception automatically.
3 Repeat step 2 to tune to more stations.
To tune to a radio station manually:
Rotate the tuning knob slowly.
Store radio stations
automatically
In tuner mode, press and hold PROG for 2
seconds.
» The system stores all the available FM radio
stations.
» Therststoredradiostationisbroadcast
automatically.
Store radio stations manually
Note
•You can store a maximum of 20 FM radio stations.
1 Tune to an FM radio station.
2 Press PROG to activate the storing mode.
3 Press PRESET + or PRESET - to allocate a
number(1to20)tothisradiostation,then
press PROGtoconrm.
» The preset number and the frequency
of the preset station are displayed.
4 Repeat the above steps to store other
stations.
Note
•To remove a pre-stored FM radio station, store another
station in its place.
Select a preset radio station
In FM tuner mode, press PRESET + or PRESET
-to select a preset radio station.