
3. Installation
A depth of at least 46mm is required to mount the speaker. Measure the depth of the area where you are
to mount the speaker, and ensure that the speaker does not obstruct any other components of the car.
Option 1: Mount on door (front or rear) B
You can mount the speakers on the front/rear door of your car. a
Note
•Make sure that nothing obstructs around the mounting location of the door.
A hole for mounting may already be cut out of the inner panel of the door (front or rear). In this case, you need to
•
modify the board only.
Ensure that the speaker terminals, frame or magnet do not interfere with any inner parts, such as the window
•
mechanism in the door (when you open or close the window), etc. Also ensure that the speaker grille does not touch
anyinnerttings,suchasthewindowcranks,doorhandles,armrestsetc.
1 Turnoffthecarignitionkey.
If the power is on, the click noise generated by the connection may damage the speakers.•
2Cut out the mounting template from the packing box.
3Paste the template on the location selected for mounting the speaker.
4Mark the cut-off hole and the 4 bolt holes. b
5Cut out the marked area and drill the bolt holes. c
6Remove the grille net. d
7 Stripthespeakerwiresandconnectthemtotheamplier. e
Black wire: connect to “-“ (negative) terminal•
Black (white lined): connect to “+“ (positive) terminal•
Note
Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may degrade sound quality.
•
Two4-ohmspeakers,wiredinstereo,presenta8ohmloadtoeachchanneloftheamplier.Mosttwochannel
•
ampliersworkwellinthisconguration.However,iftwo4-ohmspeakers,wiredinparalleltoabridgedtwo-channel
amplier,presenta2-ohmmonoloadtotheamplier.Most2-channelampliersdonotsupport2-ohmmono
operation!Amplierdamagemayresult!
8Mount on the speaker as shown below. f
9Press and insert the edges of the grille net. g
Tip
Thespeakergrillecanbemountedwithoutthegrillenet,ifyoulike.
•
Option 2: Mount on rear tray C
You can also mount the speakers into the surface of the rear tray.
Follow the steps in section “Option 1: Mount in door” to mount the speakers into the rear tray: