Philips FWD18/98 User manual

1
Quick Start Guide
2
User Manual
Composite Video Cable
FWD18
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
Quick Start Guide
Remote control
(without batteries)
User Manual
AC power cord
Audio cable
FWD18 QUG_Eng 2008.5.20, 10:321

Tip
- See the User Manual for otherTV
connection options.
Setting up the TV
1
3
2
Connect the speaker cables.
Connect the composite video cable to a TV.
Connect the power supplies of the system and TV.
1
2
Press STANDBY-ON Bto switch on the set.
Press SOURCE (DISC on the remote) to select disc source.
Turn on the TV and set it to the correct Video In channel.
AC power cord
IN
Television
L
R
IN
Pr
Pb
Y
FM wire
antenna
Surround
speaker (right) Surround
speaker (left)
Speaker
(right)
3
3
1
2
FWD18 QUG_Eng 2008.5.20, 10:322

Setting the clock
1
2
3
4
In standby mode, press and hold CLOCK on the set.
When the hour digits flash, press VOLUME +/- on the front panel or VOL +/- on the
remote to set the hours.
Press CLOCK again and the minute digits flash.Then press VOLUME +/- on the front
panel or VOL +/- on the remote to set the minutes.
Press CLOCK again to confirm the time setting.
Setting system menu options
Tip
See chapters "Preparations" and "System Menu Options" in the User
Manual for detailed descriptions.
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
AUDIO OUT
DOWNNMIX
3D PROCESSING
NIGHT MODE
MIC SETUP
ECHO
FWD18 QUG_Eng 2008.5.20, 10:333

4
Playing a disc
Programming and tuning to radio stations
1
2
3
PDCC-LL-0820
CRoyal Philips Electronics N.V. 2008
All rights reserved.
http://www.philips.com
1
2
3
Press OPEN•CLOSE 0to open the disc door.
Insert a disc with the print side facing up and close the disc door.
Playback will start automatically. If not press ÉÅ.
To stop playback, press 9.
Press SOURCE (TUNER on the remote) to select tuner source.
Press and hold PROG for more than two seconds to program all
available stations in order of waveband.
Press ALBUM/PRESET+/- on the set orí/ëon the remote control until the desired
preset station is displayed.
1
2
3
Insert the USB device’s USB plug into the socket on the front panel of the main set.
Press SOURCE once or more (or USB/MP3 LINK on the remote control) to select USB .
Playing a USB mass storage device
With the system, you can use USB flash memory (USB 2.0 or USB1.1),
USB flash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to
work with this system).
Play the USB’s audio files as you do with the albums/tracks on a CD.
Tip
- The system only supports
audio files stored in the USB
device.
FWD18 QUG_Eng 2008.5.20, 10:334