Philips MCD708/98 User manual

MCD 708
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
1
Quick Start Guide
Quick start guide
2
User Manual
Composite video and audio
cables
(yellow, white, red)
Remote control with two
AAA batteries
FM and MW antennas User manual
Control Cable
MCD708 QUG_Eng 2005.10.21, 10:031

Tips
–See the User Manual for otherTV
connection options.
–For connecting to a Progressive Scan
TV, refer to the user manual for proper
connections and detailed setup.
1
2
4
3
Setting up the TV
1
2
Press SOURCE (DISC on the remote) to select disc source.
Turn on the TV and set it to the correct Video In channel.
5
Connect the speaker cables.
Connect the MW and FM antennas.
Connect the control cable.
Connect the composite video and audio cables to a TV.
Connect the power cords of the system and TV.
SUB WOOFER
LINE OUT
O
OFER
1
3
4
5
12
2
AC power
FM antenna
MW antenna
Speaker
(right)
Speaker
(left)
MCD708 QUG_Eng 2005.10.21, 10:032

Setting the clock
1
2
3
4
In standby mode, press and hold CLOCK on the remote.
When the hour digits flash, turn VOLUME-/+ on the system or press VOLUME+/- on the
remote to set the hours.
Press CLOCK again and the minute digits flash.Then turn VOLUME-/+ on the system or
press VOLUME+/- on the remote to set the minutes.
Press CLOCK again to confirm the time setting.
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connected TV does not support
progressive signals or the cables are not connected accordingly, see the user
manual for proper progressive scan setup or deactivate the progressive scan
feature as below:
1) Turn off your TV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM on the remote to exit the system menu and then DISC to exit
progressive scan.
Tip
See chapters "Getting Started" and "System Menu Options" in the
User Manual for detailed descriptions.
DIVX(R) VOD
MCD708 QUG_Eng 2005.10.21, 10:033

Playing a disc
Programming and tuning to radio stations
1
2
3
Press SOURCE (TUNER on the remote) to select tuner source.
Press PROG on the remote for more than two seconds to program all available stations in
order of waveband.
Press PRESET+/- (CH +/- (¡/ ™)on the remote) until the desired preset station is
displayed.
PDCC-JS/JW-0535
2005 CKoninklijie Philips Electronics
N.V. All rights reserved.
http://www.philips.com
Tip
Detailed playback features and
additional functions are described in the
accompany owner's manual.
Notes for remote control:
–First, select the source you wish to control by
pressing one of the source select keys on the remote
control (DISC orTUNER, for example).
–Then select the desired function ( 2; , í , ë for
example).
1
2
3
Press OPEN •CLOSEç(çon the remote) to open the disc tray and load in a disc,
then press the same button again to close the disc tray.
➜Make sure the label side of the disc is facing up.
Playback will start automatically. If not pressÉÅ.
To stop playback, press PRESET-/9(9on the remote).
OPEN•CLOSE
MCD708 QUG_Eng 2005.10.21, 10:034