Philips Daisy Deluxe Dry User manual

Daisy Deluxe Dry FC6065, FC6064

2

3

4

ENGLISH 6
POLSKI 12
ROMÂNĂ 19
РУССКИЙ 25
ČESKY 33
MAGYAR 39
SLOVENSKY 45
УКРАЇНСЬКІЙ 51
HRVATSKI 58
EESTI 64
LATVISKI 70
LIETUVIŠKAI 76
SLOVENŠČINA 82
FC6065, FC6064
5

Important
◗Read these instructions for use carefully and
look at the illustrations before you start using
the appliance.
◗Always switch the vacuum cleaner off after
use.
◗Never suck up water (or any other liquid).
Never suck up ashes until they are cold.
◗Do not let water enter the vacuum cleaner or
the wall holder. Never immerse the vacuum
cleaner or the wall holder in water.
◗The charger plug feels warm.This is normal.
◗Only charge the vacuum cleaner with the
charger supplied.
◗Do not use the appliance if it is damaged.Take
it to an authorised Philips service centre for
repair.
Preparing the appliance for use
C◗Wind and store excess mains cord in the wall
holder.
C◗Screw the wall holder to the wall with the
screws supplied with the appliance.
◗You can also place the vacuum cleaner and
the wall holder flat on a table during charging.
ENGLISH6

C◗The crevice tool can be attached to the wall
holder by pushing it into the appropriate
fastening slot.
Charging the appliance
1Make sure that the slide switch of the
vacuum cleaner is in off position (0) during
charging.The appliance will not charge if
the slide switch is in another position.
2Insert the charger plug into the wall
socket.
C3Put the vacuum cleaner on the holder.
C◗The indicator light will come on to indicate
that the appliance is charging.
The indicator light will stay on as long as the
appliance is connected to the wall holder and the
plug is in the wall socket.
The indicator light does not give any information
about the charge level of the built-in batteries.
Charge the appliance for at least 16 hours before
you use it for the first time.
Recharge the appliance as soon as the motor
power decreases noticeably.
4Leave the charger plug in the wall socket.
Always place the vacuum cleaner back
ENGLISH 7

onto the holder (also when the built-in
batteries are fully charged).
Vacuum cleaning
C1Set the slide switch to position I for
normal suction power. Set it to position II
for turbo suction power.
Connecting accessories
C1Use the crevice tool to vacuum clean
hard-to-reach places.
Emptying the dust compartment
C1Press the break button and open the
vacuum cleaner over a dustbin.
C2Remove the filter from the dust
compartment.
3Clean the filter and empty the dust
compartment.
ENGLISH8

◗Clean the filter with a brush or with a normal
vacuum cleaner if it is very dirty.
Replacing the filter
C1Remove the filter frame from the dust
compartment.
C2Gently turn the filter clockwise to detach
it from the frame.
C3Remove the old filter and replace it with a
new filter.
C4Push the tip of the filter inwards.
Cleaning the appliance
◗You can clean the appliance with a damp
cloth. Remove the mains plug from the wall
socket before cleaning the wall holder.
ENGLISH 9

Do not let water enter the vacuum cleaner or the
wall holder. Never immerse the vacuum cleaner
or the wall holder in water.
◗If necessary, clean the dust compartment and
the filter with cold or lukewarm water.
The dust compartment may NOT be cleaned in a
dishwasher.
Never use the vacuum cleaner when the filter
and/or the dust compartment is/are still wet.
Ordering filters
Replace the filter if it can no longer be cleaned
properly (usually after having been cleaned 50
times).
New (replacement) filters are available under
type no. FC8035. Contact your Philips dealer.
If you have any difficulties obtaining filters or other
accessories for this appliance, please contact the
Philips Customer Care Centre in your country or
consult the worldwide guarantee leaflet.
Environment
NiCd/NiMH batteries can be harmful to the
environment and may explode if exposed to high
temperatures or fire.
ENGLISH10