Pima Electronic Systems HUNTER-PRO Configuration guide

Rev. A - Supplement to P/N 4410067 Rev. C (Dec-2002)
HUNTER-PRO Intruder Alarm
H/W Rev E & F/W v2.1
Installation and Programming
Manual supplement
New Hardware Revision: E
The new hardware has the following changes added to it:
1 A Terminal Block was added for Audio Out. This is for future use.
When connecting MIC-100 or VU-20, use the CONTROL and IN terminals as
described in the HUNTER-PRO Installation Manual.
The writing on the PCB was also changed. See the following table for reference to
earlier HUNTER-PRO revisions:
PCB Writing
Earlier Revisions Revision E
CONT CONTROL
AUD IN
2 A new Jumper was added to control a siren’s power source: JP6.
The following table describes the new jumper functionality:
Jumper
Position
Siren Power
Source
Notes
1-2 Unregulated When using HUNTER-PRO tones to drive a speaker
2-3 Battery When using Hunter Pro with self activating bell
NOTE:
These modes are ONLY applicable when JP5 position is: 2-3

2
New Firmware Version: 2.1
As this new H/W revision supports wireless expansion and zone doubling
(multiplying) features, the Parameters Memory (E
2
PROM) on board was upgraded.
Because of the above, when using the zone expander unit (EXP-1001) for zones 9-16,
the E
2
PROM on the expander should not be installed.
The EXP-PRO option, in the System Configuration menu, should be enabled (See
figure).
W IX M W i r less
-+ -
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
When using the COMAX Download application with this version, the 16 zones
indication is always on (Upper line on the screen). The system configuration
(Wireless, zone multiplying, EXP-PRO) screen should be used as a reference to the
actual number of installed zones in the system