PIONEER PET Feng Shui Fountain User manual

PIONEER PET®
FUNG SHUI FOUNTAIN
pčnearpet
Innovation - Slyle Health
INSTRUCTIONS PERTAINING TO RISK OF FIRE,
ELECTRICAL SHOCK OR HARM TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using electrical appliances, basic precautions should always
be followed, including the following:
Read the instructions thoroughly before using appliance.
To reduce the risk of injury, close supervision is necessary when an appliance is
used near children.
Only use attachments recommended or sold by the manufacturer.
Do not use outdoors. FOR INDOOR USE ONLY.
Do not unplug by pulling on the power cord. To unplug, grasp the plug, not the
power cord.
Do not operate any appliance with a damaged cord or plug, or after the appliance
malfunctions or is dropped or damaged in any manner.
For portable appliance-To reduce the risk of electrical shock, do not place or
store where it can fall or be pulled into atub or sink.
Always unplug any appliance when not in use, before putting on or taking off
parts, and before cleaning. Never pull power cord to remove from outlet.
SAVE THESE INSTRUCTIONS

SECIIONLOPE)SKAIIVNNG ÜNSTRUCTIONS
FOR YOURPIONEER PET FUNG SHUIFOUNTAIN
DO NOT RUN DRY FOR INDOOR USE ONLY
As with any electrical device, check the electrical cord for any tears or damage
before use.
TOP BOWL
1. Rinse the filter thoroughly under cool water
before placing into the motor/filter housing
area. Rinsing will remove a majority of the
loose charcoal dust
pets.
LOWER BOWL
which is harmless to
Fig1
2. Remove the top bowl. (Figure 1) Set top
bowl off to the side.
3. After rinsing, insert the charcoal filter. The
filter will fit into the slots on each side of the
motor housing area. The white side of the
filter should be facing out toward the front of
the lower fountain bowl. (Figure 2)
FILTER WHITE SIDE
Fig2
4. Put the top bowl in place.(Figure 3)
5. Place fountain in desired location. The use
of a protective mat is suggested to protect
your floor from splashes or drips which may
occur during use by your pet.
TOP BOWL
LOWER BOWL
6. Fill the unit with water. This includes both
the lower and top bowls of the fountain.
Fig3
7. Before you plug in the fountain, make sure
the cord and your hands are dry. Plug in the
fountain.
8. Please allow 1to 2 minutes
start pumping once plugged in.
for pump to MINIMUM WATER
9. Add water as needed. Water level should
always be maintained above the minimum
water lines indicated on the inside of the lower
bowl. (Figure 4) Fig4

SECTION II. CLEA G: ANDMAINTENANCE
INSTRUCTKONJFOR YOUR
PIONEERPET°FUNG SHUI FOUNTAIN
The Fountain Must Be Cleaned Regularly. Cleaning Frequency Depends
Upon Number of Pets Using the Fountain and Quality of Your Water
FILTERS:
Filters should be changed approximately every two to four weeks.
FOR REPLACEMENT FILTER PURCHASE PART #3003 UNIVERSAL
REPLACEMENT FILTER (3PACK) ON LINE AT
www.PIONEERPET.COM
TOP BOWL
FOUNTAIN:
Disassemble and clean the fountain
approximately every one to two weeks using
the following steps:
LOWER BOWL
Fig5
1. Unplug the fountain.
2. Remove the top bowl (Figure 5), pull out
and dispose of the filter. POWER CORD RUBBER CORD INSERT
3. Pour out remaining water from the lower
fountain bowl. P
Fig6
4. Remove rubber cord insert and set
aside. (Figure 6)
5.Remove power cord and motor and set
aside.(Figure 7) MOTOR
6. Wash lower bowl and top bowl with a
warm water and mild soap solution, Rinse
well. Fig7
7. Dry all fountain components with a
clean towel.

SECTION III. REASSEMBLINGAND
RESTARTING YOUR FOUNTAIN AFTER CLEANING
1. Thread the power cord through the power
cord riser. (Figure 8)
POWER CORD
2. Turn the flow rate of the motor to the
second lowest position. (Figure 9) Fig8
3. Insert the motor into the motor guides
located at the bottom of the lower bowl.
Press the motor down to allow the suction
cups to attach to the bowl. (Figure 10) FLOW RATE LEVER
4. Insert the rubber plug into the power cord
riser with aperture toward back side. (Figure
11) Fig9
5. Insert the cord into the channel located
under the lower bowl. (Figure 12)
6. Insert the filter after rinsing. (Please
replace any filter over four weeks old).
MOTOR
7. Install the top bowl.
Fig10
8. Place the fountain in desired location. The
use of a protective mat is suggested to
protect your floor from splashes or drips
which may occur during use by your pet. POWER CORD RUBBER PLUG
9. Fill the unit with water. This includes both
the lower and top bowls of the fountain.
10. Before you plug in the fountain, make
sure the cord and your hands are dry. Plug in
the fountain. Fig11
11. Add water as needed. Water level should
always be maintained above the minimum
water lines indicated on the inside of the
lower bowl. Fig12

SECTION IV. MOTOR MAINTENANCE
Cleaning the motor is essential to the longevity of
the fountain as well as the cleanliness of the water.
1. Unplug the fountain.
2.Remove the top bowl from the lower bowl.
3. Gently lift the motor out of the lower bowl. Suction cups on the bottom of the
motor will hold it in place. A small amount of force
may be necessary.
COVER PLATE
4. Once the motor is out of the fountain, with your
thumb and forefinger, gently squeeze on either side
of the intake plate, and pull off. It may be necessary
to insert a fingernail into the seam of the inlet plate to
pry it off. (Figure 13)
Fig13
5. Next you will need to remove the stator by placing
your finger nail under the small lip located on the
narrow side of tear drop shaped stator and pull out.
(Figure 14)
STATOR
6. Once the stator is removed you can also remove
the impeller (3-white-bladed propeller) which is held
in place magnetically. To remove the impeller, use a
fingernail to get under ablade and lift out. (Figure 15)
IMPELLER
7. Once the motor is disassembled you can clean the
parts with warm soapy water. Use a cotton swab to
get into the motor cavity and remove any build-up.
For added disinfection and hard water removal, clean
the motor with white vinegar.
Fig14
8. Rinse well.
9. Once the parts are clean you can reassemble the
motor for use by replacing the impeller, stator and
cover plate.
Note: After reinserting the impeller give it a couple of
spins with your finger to help ensure it is properly in
position. Put pump in some water by itself and plug
in to make sure it is functioning before reassembling
the fountain.
Fig15
PLEASE WATCH OUR PUMP
MAINTENANCE VIDEO ON
www.YOUTUBE.COM- SEARCHING FOR
"PIONEER PET RAINDROP FOUNTAIN
PUMP MAINTENANCE 101".

SECTION V. MANUFACTURER'S SAFETY
INSTRUCTIONS
INSTRUCTIONS PERTAINING TO RISK OF FIRE,
ELECTRICAL SHOCK OR HARM TO PERSONS
Do not allow pets or children to chew on or swallow any fountain parts. If you are
concerned about the power cord, purchase a cord conduit or cord cover at any
home improvement or hardware store.
Do not attempt repairs on the motor yourself.
If the plug of this device gets wet, turn off the electricity to that outlet. Do not
attempt to unplug.
To avoid the possibility of the plug or outlet getting wet, the outlet should always
be above the level of the fountain.
Examine this appliance after installation. It should not be plugged in if there is
water on the cord or plug.
Do not operate any appliance if it has a damaged cord or plug, or if it is
malfunctioning or has been damaged.
If an extension cord is necessary, a cord with a proper rating should be used.
FOR INDOOR USE ONLY
SECTION VI. TIPS ON USE
When being introduced to the PIONEER PET° Fung Shui Fountain, your pet may
be cautious of this new source of water. After beginning operation of the
fountain, allow your pet to adjust at his or her own pace. Some pets take a few
days or sometimes a litle longer to begin use.
Your pet may prefer that the fountain be placed away from their normal feeding
area. Try plugging it in somewhere else, like the laundry room, bathroom or
another corner of the kitchen.
In some cases, let the fountain sit unplugged until your pet starts to drink. Later,
you can plug the fountain in so that the water maintains its freshness.
SECTION VII. WARRANTY
Motor and Fountain Parts
The motor assembly and fountain parts are warranted to be free of defects in
material and workmanship for one (1) year from the date of purchase.However,if
proper pump maintenance is not followed per Section IV of this instruction
manual and if the product is being taken out of the country in which it was
purchased the warranty will be voided. Retain your dated sales receipt as proof
of purchase.For more information regarding product warranty or technical
support submit email to: [e-mail] or call: 1-866-317-6278.