Platinum Access Systems Cellink4G-Plus User manual

Cellink4G-Plus Quick Installation Instruction
1. Connect Antenna.
2. Connect T-Mobile/AT & T SIM card.
3. Connect Unit N.O to STRIKE on operator main board. Connect unit COM to GND on operator
main board.
4. Connect Power adapter output 15VDC, 2A to the unit power input.

5. Power up the power adapter.
6. The orange color light will blink in about 6 seconds.

7. The blue color light will blink in about 1 minute.

8. Search and download smartphone APP “Platinum Access” from Apple Store for iPhone, or from
Amazon APP Store for Android phones.
9. Follow instruction and install the Platinum Access APP in your smartphone.
10. Once you have installed the APP successfully, you will see the ACCESS icon on the phone screen.
11. Tap “ACCESS” icon to open the APP.

12. Tap SETTINGS at lower right hand corner to go to Settings page.
13. Tap “Enter Cell Module Phone#” go to Phone Entry Unit List page.
14. Tap “+” at the upper right hand corner to enter ID name & SIM card phone#.
15. Tap OK to go back to the Phone Entry Unit List page.
16. Tap “<” to go back to Settings page.
17. Tap “Set Master User” icon to set your phone to be the master unit.
18. Tap the SEND icon to send out the text command “set master pn xxxxxxxxxx” (The SIM Card#).
19. If Cellink4G-Plus unit is working, you will receive “Done, thank you!” text message in about 5-10
seconds. If you have received the “Done, thank you!” text message. You can go to the step 20.
Otherwise, you need to double check all wire connections to make sure all connections are good.
And both Orange LED and blue LED are blinking.
20. Go to Settings page again.

21. Tap ‘Enable Cloud” icon.
22. Tap the SEND icon to send out the “en cloud xxxxxxxxxx” text command.
23. If Cellink4G-Plus unit working, you will receive “Done, thank you!” text message in about 5-10
seconds
24. Go to the APP Home page.
25. Tap “OPEN” icon.
26. If Cellink4G-Plus unit working, you will receive “Done, thank you!” text message in about 5-10
seconds
27. Next go to Settings page you can tap the “Add Super User Phone#” icon to add up to 8 super
users.
28. You also can Tap “Add User Phone#” icon to add up to 2000 normal users.
29. Go to Setting page.
30. Tap “Set Date & Time” Icon to set the correct date and local current time.
31. You also can use the APP to set schedules at the Home page.
32. For the basic setup. You are done. If you want to use Platinum cloud to add users, setup
schedules, and setup permission for users. Please visit Platinum website
www.platinumasi.com/phones. And Tap “Platinum Cloud Link” Icon to register to setup your
account. Please note that ONLY T-Mobile SIM Card can user the cloud service. AT & T server is
not ready for the cloud service yet.