The Earphone
Turn on
In the shutdown state, press the power key for about 3 seconds, red
and blue lights start flashing alternately. Now the earphone is in the
boot up state and is ready for use.
The earphone and equipment pairing mode
Press the power-on key for about 5 seconds in the shutdown state
until the red and blue lights flash alternately, and a "connected"
prompt will be heard in the earphone after pairing.
Turn off
Press the power-on key for about 3 seconds in the power-on state
until the red light flashes 1 second, and the earphone will send out a
"power off" prompt voice in the earphone.
The Bluetooth pairing steps
Please control the distance between the Bluetooth earphone and
the device that needs to be connected within 1 meter, the closer
the better.
Please select the option name "PLAYGO N20" (some phones need
to enter "0000" as the matching password), Bluetooth earphone
will automatically connect with the phone, and the blue light will
blink every 5 seconds.
After the earphone is turned on, please confirm that you have
entered the earphone pairing mode, now the red and blue lights
blink alternately in the pairing mode.
A2
Warning: You must use the original USB charging cable to the
earphone, use of any other cable can damage the service life of the
earphone, the charger on other side must be 5V DC voltage, electric
current is 100 mA (5V/100 mA).
The earphone battery is equipped with a built-in non-removable
battery. Do not try and take the battery out of the earphone, so as not to
damage the earphone.
