Polar Refrigeration GL001 User manual

Barkoeler
Handleiding
Armoire réfrigérante
Mode d'emploi
Getränkekühlschrank
Bedienungsanleitung
Vetrina refrigerata bar
Manuale di istruzioni
Frigorífico de Barra Trasera
Manual de instrucciones
Bancada refrigerada
Manual de instruções
NL
FR
DE
IT
ES
PT
Back Bar Chiller
Instruction manual
Model • Modèle • Modell • Modello • Modelo • Malli:
GL001/GL002/GL003/GL004/GL006/GL007/GL008/GL009/
GL010/GL011/GL012/GL013/GL014/GL015/GL016/GL017

1
UK
Safety Tips
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components or service panels on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
• DO NOT immerse in water, or use steam/jet washers to clean the unit.
• DO NOT cover the appliance when it is operating.
• DO NOT store food in the appliance.
• DO NOT use electrical appliances inside the appliance.
• Always carry, store and handle the appliance in a vertical position.
• Never tilt the appliance more than 45° from the vertical.
• Not suitable for outdoor use.
• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of
local authorities.
• If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified
technician in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilites, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Product Description
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your POLAR product.
•GL001/GL007/GL011/GL015 - Single
Door Back Bar Chiller
•GL002/GL008/GL012/GL016 - Double
Door Back Bar Chiller
• GL003/GL010 - Double Door (Sliding) Back
Bar Chiller
•GL004/GL009/GL014/GL017 - Three
Door Back Bar Chiller
•GL006/GL013- Three Door Back Bar Chiller

2
UK
Telephone Helpline: 0845 146 2887 (United Kingdom)
Pack Contents
The following is included:
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Installation
1. Remove the appliance from the packaging and the protective film from all surfaces.
2. Avoid positioning the appliance in direct sunlight or damp areas.
3. When positioning the appliance, maintain a distance of 20cm (7 inches) between the appliance and
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
4. Insert the slide-out shelf/shelves at the desired levels and place the smaller shelf/shelves on the floor
of the appliance.
5. If necessary, adjust the screw feet of the appliance to make it level.
Operation
Control Panel
The control panel is located below the doors on the front of the
appliance.
Tu r n O n
1. Close the door of the appliance.
2. Connect the appliance to a mains power supply.
3. Turn the light switches On [I] or Off [O] as desired.
Note: If the unit has not been stored or moved in an upright position, let it stand upright
for approximately 12 hours before operation. If in doubt allow to stand.
Note: Before using the appliance for the first time, clean the shelves and interior with
soapy water.
Note: The Cooling Light is illuminated when the appliance is chilling the interior cabinet.
ALL MODELS
• POLAR Back Bar Chiller
•Key
• Instruction manual
Plus..
1 DOOR MODEL
• 2 adjustable shelves
2 DOOR MODEL
• 4 adjustable shelves
3 DOOR MODEL
• 6 adjustable shelves
Cooling Light Defrost Light

3
UK
Set the Operating Temperature
1. Press the button. The display will flash.
2. Press the or buttons to display the required temperature.
3. Press the button to store the temperature.
Manual Defrost
POLAR Back Bar Chillers feature an automatic defrost. However, should the appliance require an additional
defrost period press and hold the button for 6 seconds.
Automatic defrost cycles are every 6 hours and last 20 minutes (factory defaults).
To stop the Defrost press and hold the button for 6 seconds.
Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must carry out repairs if required.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance. The condenser is located at the
back of the appliance.
Note: If a manual defrost is started this resets the automatic defrost timer. During
defrost periods the Defrost light is illuminated.
Note: Use a soft brush or vacuum cleaner to clean the fins of the condenser, taking care
not to damage the fins.

4
UK
Telephone Helpline: 0845 146 2887 (United Kingdom)
Removing the Doors (Sliding Doors only)
When cleaning the appliance or replacing the lamp it may be necessary to remove the doors to improve
access.
To remove the doors:
1. Holding the sides of the first door, lift the door into the upper runner.
2. Pull the bottom of the door out and down simultaneously so the door clears the bottom runner.
3. Place the door to the side of the appliance.
4. Repeat for the remaining doors.
5. To replace the doors, slot them into the upper runner and then push the bottom of the door in and
down to slot it in to the bottom runner.
Note: The automatic door-closing system means that the doors are attached to the
appliance by a cord. Do not break or remove this cord.

5
UK
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to the Helpline.
Technical Specifications
Fault Probable Cause Action
The appliance is not
working The unit is not switched on Check the unit is plugged in correctly and switched on
Plug and lead are damaged Call POLAR agent or qualified Technician
Fuse in the plug has blown Replace the fuse
Power supply Check power supply
Internal wiring fault Call POLAR agent or qualified Technician
The appliance turns
on, but the
temperature is too
high/low
Condenser blocked with dust Clean Condenser
Doors are not shut properly Check doors are shut and seals are not damaged
Appliance is located near a heat
source or air flow to the
condenser is being interrupted
Move the appliance to a more suitable location
Ambient temperature is too
high Increase ventilation or move appliance to a cooler position
Insufficient airflow to the fans Remove any blockages to the fans
Appliance is overloaded Reduce the amount stored in the appliance
Factory default parameters
adjusted Call POLAR agent or qualified Technician
The appliance is
unusually loud The appliance is touching a neighbouring object Check installation position and change if necessary
The appliance has not been
installed in a level or stable
position
Check installation position and change if necessary
Model Voltage Power Current Temperature
Range Capacity (litres) Refrigerant Dimensions H x W x D (mm) Weight (kg)
GL001 230V 50Hz 180W 1.3A 2°C to 8°C 138 R600a 900 x 600 x 520 48
GL002 230V 50Hz 230W 1.8A 2°C to 8°C 208 R600a 900 x 900 x 520 62
GL003 230V 50Hz 230W 1.8A 2°C to 8°C 208 R600a 900 x 900 x 520 62
GL004 230V 50Hz 350W 2.4A 2°C to 8°C 330 R600a 900 x 1350 x 520 80
GL006 230V 50Hz 350W 2.4A 2°C to 8°C 330 R134a 900 x 1350 x 520 80
GL007 230V 50Hz 180W 1.3A 2°C to 8°C 138 R600a 900 x 600 x 520 48
GL008 230V 50Hz 230W 1.8A 2°C to 8°C 208 R600a 900 x 900 x 520 62
GL009 230V 50Hz 350W 2.4A 2°C to 8°C 330 R600a 900 x 1350 x 520 80
GL010 230V 50Hz 230W 1.8A 2°C to 8°C 128 R600a 850 X 900 X 520 60
GL011 230V 50Hz 180W 1.3A 2°C to 8°C 198 R600a 850 X 600 X 520 46
GL012 230V 50Hz 230W 1.8A 2°C to 8°C 198 R600a 850 X 900 X 520 60
GL013 230V 50Hz 350W 2.4A 2°C to 8°C 320 R134a 850 X 1350 X 520 78
GL014 230V 50Hz 350W 2.4A 2°C to 8°C 320 R600a 850 X 1350 X 520 78
GL015 230V 50Hz 180W 1.3A 2°C to 8°C 138 R600a 900 x 600 x 520 48
GL016 230V 50Hz 230W 1.8A 2°C to 8°C 208 R600a 900 x 900 x 520 62
GL017 230V 50Hz 350W 2.4A 2°C to 8°C 330 R600a 900 x 1350 x 520 80

6
UK
Telephone Helpline: 0845 146 2887 (United Kingdom)
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 3 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Disposal
EU regulations require refrigeration product to be disposed of by specialist companies who remove or
recycle all gasses, metal and plastic components.
Consult your local waste collection authority regarding disposal of your appliance. Local authorities are not
obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose
of the equipment locally.
Alternatively call the POLAR helpline for details of national disposal companies within the EU.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible
for waste disposal in your area.
POLAR parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal
authorities.
POLAR products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR.
Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserve the right
to change specifications without notice.