Polar Refrigeration CE322-A User manual

Hotel
Refrigerator
Instruction manual
Model
CE322-A

2
Safety Tips
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components or service panels on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
• DO NOT use jet/pressure washers to clean the appliance.
• DO NOT use the appliance outside.
• DO NOT use this appliance to store medical supplies.
• DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean
immediately if contact occurs.
• DO NOT store products on top of the appliance.
• POLAR Hotel Refrigerators are designed for drink chilling and storage and are not recommended for
the storing of foodstuffs.
• Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the
refrigerator.
• Always carry, store and handle the appliance in a vertical position and move by holding the base of the
appliance.
• Always switch off and disconnect the power supply to the unit before cleaning.
• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of
local authorities.
• If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified
technician in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your POLAR product.

3
Telephone Helpline: 1300225960
Pack Contents
The following is included:
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Installation
1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are
thoroughly removed from all surfaces.
2. Maintain a distance of 2cm between the unit and walls or other objects for ventilation.
Reverse the Door
1. Disconnect the appliance from the power supply.
2. Tip the appliance back slightly to gain access to the
lower hinge.
3. Unscrew the lower hinge and pivot pin. Remove from
the door.
4. Carefully lower the door and remove it from the
appliance.
5. Unscrew the upper pivot pin from the appliance and slot
it in to the opposite side. Secure with the two screws.
6. Slot the door back on to the upper pivot pin.
7. Slot the lower hinge and pivot pin back in to the bottom of the door.
8. Screw the lower hinge back on the appliance with the two screws.
Note: If the unit has been moved or not stored in an upright position, let it stand upright
for approximately 12 hours before operation. If in doubt allow the appliance to stand.
Note: Before using the appliance for the first time, clean the shelves and interior with
soapy water.
Note: The fixings must use the holes on the other side of the hinge when switching sides
[Fig. 1].
• POLAR Hotel Refrigerator
•Shelf
•Keysx2
• Instruction manual
Fig. 1

4
Operation
Thermostat
The thermostat is located at the rear of the cabinet [Fig. 2].
Tu r n O n
1. Set the temperature to the desired setting:
1 (8°C) to 6 (0°C).
2. Close the door of the appliance.
3. Connect the appliance to a mains power supply.
Lock/Unlock the Doors
A lock is fitted to the doors of this POLAR appliance.
Use the keys provided to lock/unlock the door.
Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must carry out repairs if required.
• If left unused for any length of time, store the appliance with the door ajar.
Auto Defrost
Periodically the appliance will run an automatic defrost cycle to prevent any ice build-up.
Note: Setting the switch to ‘0’ turns off the
appliance. Fig. 2

5
Telephone Helpline: 1300225960
Tro u b l e s h o o ti n g
If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline.
Technical Specifications
Fault Probable Cause Action
The appliance is not
working
The unit is not switched on Check the unit is plugged in correctly and switched on
Plug and lead are damaged Call POLAR agent or qualified Technician
Fuse in the plug has blown Replace the fuse
Power supply Check power supply
Internal wiring fault Call POLAR agent or qualified Technician
The appliance turns
on, but the
temperature is too
high/low
Too much ice on the evaporator Defrost the appliance
Condenser blocked with dust Call POLAR agent or qualified Technician
Doors are not shut properly Check doors are shut and seals are not damaged
Appliance is located near a heat
source or air flow to the condenser
is being interrupted
Move the refrigerator to a more suitable location
Ambient temperature is too high Increase ventilation or move appliance to a cooler
position
Appliance is overloaded Reduce the amount stored in the appliance
The appliance is
unusually loud
Loose nut/screw Check and tighten all nuts and screws
The appliance has not been
installed in a level or stable
position
Check installation position and change if necessary
Model Voltage Power Current Temperature
Range
Capacity
(litres) Refrigerant
Dimensions
H x W x D
(mm)
Weight
(Kg)
CE322
-A
220V -
240 V
50Hz
60W 0.3A 0°C to 8°C 30 R717
230g
530 x 415 x
400
15

6
Telephone Helpline: 1300225960
Electrical Wiring
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must not be
disposed of as household waste. To help prevent possible harm to human health and/or the
environment, the product must be disposed of in an approved and environmentally safe recycling
process. For further information on how to dispose of this product correctly, contact the product
supplier, or the local authority responsible for waste disposal in your area.
POLAR parts have undergone strict product testing in order to comply with regulatory standards
and specifications set by international, independent, and federal authorities.
POLAR products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form
or by any means, electronic, mechanical, photocopying, recording or otherwise, without the
prior written permission of POLAR.
Every effort is made to ensure all details are correct at the time of going to press, however,
POLAR reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY
I, the undersigned, hereby declare that the equipment specified above
conforms to the above Legislation and Standard(s).
Equipment
Type
Refrigerator
Model CE322-A
Legislation C-Tick
AS/NZ 3820 Essential Safety Requirements for Low
Voltage Electrical Equipment
Standards EN 55014-1:2006+A1+A2, EN 55014-2:1997+A1+A2
EN 61000-3-2:2006+A1+A2,
EN 61000-3-3:2008, EN62233:2008
AS/NZS 60335.2.24, AS/NZS 60335.1
Producer Name POLAR
Producer
Address
15 Badgally Road,
Campbelltown,
NSW 2560
Date 09/07/12
Signature
Full Name Richard Cromwell
Position Marketing Director

CE322-A_ML_A5_v5