Polaris Power P1000i User manual

P/N 9926344 Rev 01 01/15 Page 1 of 4
BEFORE YOU BEGIN
Read these instructions thoroughly and make sure all parts and tools are accounted for. Please retain these
installation instructions for future reference and parts ordering information.
P/N 2881433
GENERATOR COLD WEATHER KIT
APPLICATION
P1000i AND P2000i 60 Hz GENERATOR
Ref Qty Part Description Part Number
1 1 Generator Cold Weather Kit 2881433
2Zip Ties -
1 Instructions 9926344
TOOLS NEEDED
Hex Wrench, Inner, M6 (Polaris PN 3410206) (Included in the Generator Package)
Phillips Screwdriver
APPROXIMATE ASSEMBLY TIME
30 min
IMPORTANT
Your Polaris GENERATOR COLD WEATHER KIT is exclusively designed for your machine. Please
read the installation instructions thoroughly before beginning. For your safety, and to ensure a
satisfactory installation, perform all installation steps correctly in the sequence shown.
KIT CONTENTS
1
17” Flat Length Coiled
around a 1/2” Mandrel

P/N 9926344 Rev 01 01/15 Page 2 of 4
INSTALLATION INSTRUCTIONS
1. Polaris Cold Weather Kit (1) is
designed to provide reliable operation
in regions that experience low ambient
temperature.
2. Disconnect all power loads from the
generator, shut down the generator
(please see details from generator
operator’s manual).
3. Remove the generator cover:
a) Four bolts (A) using M6 hex wrench
(B) (Polaris PN 3410206, included in
generator package).
b) Remove fuel ll cap (C) and rubber
fuel ll gasket.
c) Lift off cover.
4. Disconnect the engine breather
tube (D) from the air cleaner/lter cover.
1
D
C
A
17” Flat Length Coiled
around a 1/2” Mandrel
21”
Disconnect the
Tube from Here
A
B

P/N 9926344 Rev 01 01/15 Page 3 of 4
5. Wrap the exible heater (E) onto the
breather tube (D) until it is fully in place.
6. Re-connect the breather tube to the air
cleaner/lter cover.
7. Remove the generator front control
panel (F) with Phillips screw driver.
8. Connect either lead (G) from the Cold
Weather kit wire connector to the 120V,
AC receptacle (H), positive side, from
the back of the generator set front
control panel.
E
F
G
H
D
120V AC Power Wire,
Positive, Red

P/N 9926344 Rev 01 01/15 Page 4 of 4
9. Connect the other lead (J) from the
Cold Weather kit wire connector to the
120V, AC receptacle (H), negative side,
from the back of the generator set front
control panel.
10. Route the Cold Weather kit harness by
using cable zip ties (K) to connect to
the stainless steel support rod (L).
11. Route the harness with another cable
zip tie (K) to the ignition coil wires
(blue and yellow).
12. Install the generator front control panel with Phillips screwdriver.
13. Install the generator cover, fuel ll gasket and fuel ll cap.
K
K
L
H
120V AC Power Wire,
Negative, Black
J