popstrukt LD04 User manual

ASSEMBLY INSTRUCTIONS
CODE | LD04
BON BON CHEST OF DRAWERS
Please visit www.popstrukt.com/instructions section for more information Please visit www.popstrukt.com/instructions section for more information
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM FURNITURE TIP-OVER. TO
PREVENT THIS FURNITURE FROM TIPPING OVER IT MUST BE PERMANENTLY FIXED TO THE
WALL. BASIC FIXING DEVICES FOR BRICK WALLS ARE INCLUDED. HOWEVER SINCE DIFFERENT
WALL MATERIALS REQUIRE DIFFERENT TYPES OF FIXING DEVICES USE FIXING DEVICES SUITABLE
FOR THE WALLS IN YOUR HOME. FOR ADVICE ON SUITABLE FIXING SYSTEMS, CONTACT
YOUR LOCAL SPECIALIZED HARDWARE DEALER
WARNING
LEFT BACK PLATE:
1PC
RIGHT BACK PLATE:
1PC
TAILSCREW(4*10):
20PCS
BACK DRAWER SEAL:
4PCS
BRACE BASE:
1PC
DRAWER BOX:
4PCS
FRONT PANEL:
4PCS
PLASTICRIVET:
4PCS
SCREW(M4*6)
FOR FRONT PANEL:
TOP PLATE:
1PC
FRONT
FRONT
BACK
FRONT AND BACK BASE:
2PCS
RIGHT SIDE PLATE:
1PC
LEFT SIDE PLATE:
1PC
16PCS
WALL PLUG
1PC
WALL SCREW
1PC
WALL FIXTURE
WALL FIX
STRIP
1PC
SELF-TAPPING
SCREW 1PC

STEP 3
STEP 4
STEP 1
STEP 2
Please visit www.popstrukt.com/instructions section for more information Please visit www.popstrukt.com/instructions section for more information
Bend tabs in/up.
INSTALL THE FRONT PANEL WITH SCREWS (M4*6).
INSTALL THE BACK DRAWER SEAL
AS SHOWN IN THE PICTURE.
CONNECT THE LEFT AND RIGHT
SIDE PLATES WITH FRONT AND BACK BASE.
FIX THE LEFT & RIGHT SIDE PLATES WITH FRONT AND BACK
BASE BY PLASTIC RIVET. INSTALL THE RIGHT BACK PLATE.

CLICK
STEP 7
INSTALL TOP PLATE
STEP 5
STEP 6
Please visit www.popstrukt.com/instructions section for more information
Please visit www.popstrukt.com/instructions section for more information
INSTALL THE LEFT BACK PLATE, AND FIX THE LEFT AND
RIGHT BACK PLATES BY TAIL SCREWS.
INSTALL TOP AND BASE BRACE AS SHOWN.
Tip: Place unit on its back
Bend tabs in/up on a carpet
for this step.
Use screws tail screws where shown
Tip: Insert drawer all the way
until you hear a click. Pull back out
all the way to make sure drawer is fixed.
STEP 8
INSTALL THE DRAWERS AS SHOWN IN THE PICTURE (RAILS).

Please visit www.popstrukt.com/instructions section for more information
STEP 9 SUPPLIED
WALL
FIX TO WALL
STEP 1
INSERT WALL PLUG INTO
THE WALL USING A DRILL.
STEP 2
FIX THE MATERIAL STRIP TO THE
BACK OF UNIT USING SCREW.
STEP 3
FIX THE UNIT TO THE WALL VIA
MATERIAL STRIP.
DRILL HOLES IN WALL
WALL
WALL
TIP: Blow dirt out of hole.
WALL PLUG
1PC
WALL SCREW
1PC
WALL FIX
STRIP
1PC
SELF-TAPPING
SCREW
1PC
WALL
Please visit
www.popstrukt.com/instructions
section for more detailed information
and assembly videos
POPSTRUKT FURNITURE @POPSTRUKT_COM @POPSTRUKT.FURNITURE POPSTRUKT FURNITURE
Please visit www.popstrukt.com/instructions section for more information
Finish en klaar.