Porter 00265-000 User manual

ASSEMBLY MANUAL
FLOOR HOCKEY GOAL
No. 00265-000
INST 00355 071
ã2001 PORTER ATHLETIC EQUIPMENT COMPANY. ALL RIGHTS RESERVED. 7-1-2001
Upon completion of the assembly/installation of these floor hockey goals, make
sure this instruction manual is in the possession of the owner or facility
manager, to save for future reference, and to order replacement parts.
SIX FRAME BARS MUST BE INSERTED THROUGH
SLEEVES ON THE NET BEFORE ASSEMBLY
6
1
64
5
2
3

2
WARNING
READ ALL INSTRUCTIONS THOROUGHLY BEFORE ATTEMPTING TO ASSEMBLE THIS EQUIPMENT. ASSEMBLY
OF THIS EQUIPMENT MUST BE DONE BY PHYSICALLY CAPABLE ADULTS ONLY.
PARTS LIST
Item No. Qty. Part Number Description Item No. Qty. Part Number Description
1 6 TUBR 00706 0G0 Crossbar – 6'-0" Lg.
2 8 TUBR 00704 0G0 End Frame Bar – 1'-5-3/8" Lg.
3 8 TUBR 00705 0G0 End Frame Bar – 4'-1" Lg.
4 4 TEES 00014 000 Tee – 2-Way
5 12 TEES 00015 000 Tee – 3-Way
6 16 PCAP 00058 002 Tube Plug
7 2 NETS 00035 000 Net
TOOLS REQUIRED: 5/32" Allen Wrench
1. Check all items against Parts List Above to ensure all have been included.
2. Start by pulling the Upper Front Cross Bar (1), Lower Rear Cross Bar (1) and Lower 1'-5 3/8" End Frame Bar (2) support pieces
through the net sleeves. See Detail On Other Side.
3. Assemble the bottom portion of the goal frame into the connector tee's. The front two End Frame Bar supports require one 2-Way
Tee Casting on the front and one 3-Way Tee casting on the rear of the unit. Make sure that all support tubes are flush with the
top's & bottom's of the Connector Tee's.
4. Insert the rear 4'-1" Lg. End Frame supports (3) into bottom of Connector Tee's & attach upper Tee Castings to End Frame
supports.
5. Pull net and supports up and tie the rear of the goal frame together by connecting the Upper Rear Crossbar (1) to the back Vertical
End Frame Tee's.
6. Insert front two 4'-1" Lg. End Frame Bars supports through net sleeve and anchor them into the bottom Tee Castings.
7. Assemble the Upper 1'-5 3/8" End Frame Bar supports (2) to both upper vertical End Frame Bars to tie the unit together.
8. Tighten all set-screws in tee castings to frame supports.
9. Apply cap plugs to all exposed bar ends.
Porter Athletic Equipment Company
2500 South 25th Avenue, Broadview, IL U.S.A., 60155
Toll Free: [phone] ·Phone: [phone] ·Fax: [phone]
www.porter-ath.com
SAVE THESE INSTRUCTIONS FOR FUTURE USE