Porter Powr-Flex Outdoor Goal User manual

Detail "A" Detail "B"
SHOWN FROM
OUTSIDE
OF GOAL
Detail "C"
SHOWN FROM
OUTSIDE
OF GOAL
ROUTE LOOP BACK THRU TIE-OFF
SLOT, UNDER THE TWO HOOKS
PULL DOWNWARD TO TIGHTEN
THE LOOP AROUND THE HOOKS
Detail "D"
FINISHED NET
ATTACHMENT
SHOWN
NET ATTACHMENT PROCEDURE
GOALS WITH NET TIE-OFF SLOTS
Follow the steps below to secure the net to the tie-off slots on the goal brace.
1. Twist a loop on the net as shown. See
Detail "A".
2. Slip the twisted loop through the net tie-off
slot from the INSIDE of the goal outward,
between the two hooks. See Detail "B".
3. Route the loop
back through the
tie-off slot, under
the two hooks.
See Detail "C".
4. Pull downward on the twisted loop, to tighten the loop
around the hooks in the tie-off slot. See Detail "C".
This loop is now secured to the goal.
5. See Detail "D"
for view of
finished
attachment.
6. Repeat Steps 1
thru 5 for the
other eleven
loops on the
net.
Porter Athletic Equipment Company
2500 South 25th Avenue, Broadview, IL U.S.A., 60155
Toll Free: [phone] ·Phone: [phone] ·Fax: [phone]
www.porter-ath.com
INST 00250 072
ã2002 PORTER ATHLETIC EQUIPMENT COMPANY. ALL RIGHTS RESERVED. 7-1-2002
SAVE THESE INSTRUCTIONS FOR FUTURE USE

WARNING
BOLTS MUST BE INSTALLED AS SHOWN &
EXPOSED BOLT ENDS COVERED AS SHOWN TO
REDUCE POSSIBILITY OF PLAYER INJURY.
GOAL ATTACHMENT
©1994 Porter Athletic Equipment Company. All Rights Reserved. INST 00013 124
12-1-94
FACE MOUNT GOAL ATTACHMENT
REAR MOUNT GOAL ATTACHMENT
3/8” FLATWASHER, LOCKWASHER, HEX NUT & THREAD COVER
3/8” FLATWASHER, LOCKWASHER, HEX NUT & THREAD COVER
BACKBOARD
BACKBOARD
INSTALL THREAD COVER OVER BOLT ENDS AGAINST HEX NUTS AFTER
ALL FINAL HEIGHT AND PLUMBING ADJUSTMENTS HAVE BEEN MADE.