POSIFLEX LM-2108 User manual

Part 1
I. FEATURES
The LM-2108 particularly designed for Posiflex PB POS terminals
8” LCD monitor with tilt adjust for industrial and commercial use
High quality TFT LCD panel
Easy maintenance structure allowing easy cleaning
Super VGA monitor resolution up to 800 x 600 pixels
Support power supply through LCD cable from Posiflex PB POS systems
to operate without power adaptor
II. CARTON CONTENTS
1. LCD Monitor (Main unit assembled with Stand)
2. User’s Manual
3. PB top cover particular designed for LM-2108
4. LCD Cable particular designed for LM-2108: 21861055101
5. CD for PB BIOS update
III. PARTS IDENTIFICATION
A. FRONT VIEW
B. REAR VIEW
LM-2108
LCD Monitor
User’s Manual
Rev. Original
Display Screen
Power LED
Main Unit
Stand
Hinge
Main Unit
Base Stand
P/N: 19670901110

Part 2
C. POWER LED INDICATION
Orange: standby (no signal)
Blue: operating
IV. INSTALLATION
Please follow steps 1 to 8 sequentially with reference to pictures below for
LM-2108 installation.
1. It is recommended to update the BIOS in PB system according to the
readme file in the CD delivered with this monitor prior to any
modification so that you won’t have to reconnect the original monitor
after the modification for BIOS update purpose.
2. Remove the 2 screws on top cover of PB system to
remove the plastic top cover (circled in right picture).
3. Press inward both plastic buttons at
lower rear corners on both sides of
the PB system unit (circled in left picture) to release the
lower part of back cable cover and there are 2 plastic
hooks on top cover holding the back cable cover as
marked on upper part of the picture. Carefully release
the back cable cover from the hooks (rectangle marked).
4. Push in the triangle marked spring buttons in the left picture above on
both sides of chassis and raise the rear edge of the top cover.
5. Connect the none shielding covered end of the attached LCD cable to
LCD port in main board of PB system (rectangle marked in leftmost
picture below) and route the shielding covered end through cable passage
on the top cover of PB system to top of the PB system (as show in middle
and rightmost picture below) and route the LCD cable into the cable
routing trough as indicated by hollow arrow in the middle picture then
put the top cover and cable cover back.
LCD cable passage
Shielded end of LCD cable

Part 3
6. Take out the attached special PB top cover
and have the LCD cable to come through
the cable passage in the PB top cover
(arrowed in right picture) and screw the PB
top cover fixing screws back (circled in
right picture).
7. Connect the shielded end of the LCD cable
to the LCD port of LM-2108 monitor.
8. Place the LM-2108 on top cover of PB
system. The main unit and the stand are
joined with a hinge structure that allows the
LCD panel tilt angle adjustment between 20°
and 90° for best viewing effect in application.