Power-Tronics RM100-FW3P User manual

RM100-FW3P
The RM100-FW3P is a three-phase full wave
rectified DC power supply. It designed to be used
for 250vdc power on DC motors and controls in
place of a DC generator.
Specifications:
Input Voltage 240vac 3 phase
Maximum Output Voltage 250vdc
Internal Fusing 100aac
Rectification Full wave 3 phase
Maximum Amperage 100adc
HZ 50/60
Physical Size 18 x 12 x 10in.
Total Weight 14lbs
For the most up to date information on this and any other product we manufacture,
please visit our web site at:
www.power-tronics.com

Installation Diagram

PRODUCT WARRANTY
Power-Tronics, Inc., assumes no liability for damages due to incorrect voltage or other voltage
related damages resulting from either output of the generator or input to the generator exciter
system. These problems should be protected with external devices provided by the customer
such as fuses, surge suppressors, over/under voltage and frequency controls.
Power-Tronics, Inc.,warranties only parts and workmanship of this product for a period of 2
years from the original date of purchase from Power-Tronics, Inc. Under warranty, Power-
Tronics, Inc. will replace, exchange or repair the defective product without labor or parts cost
to the customer. Remaining warranty of the original product will be transferred to the replaced
or repaired product. To obtain warranty, a copy of the original purchase receipt must be sent in
with the defective product, which clearly shows the purchase date and serial number of the
defective part. A repair request form must be sent in with the product before repairs will begin.
You can obtain this form through contacting Power-Tronics, Inc.. Send repairs to: Power-
Tronics, Inc., 2802 Cobbler Ln., Kerrville Texas USA 78028. Send in repairs only by UPS or
FedEx.
Any one of the following conditions will void the warranty:
!Overheating of the power supply resistor on the printed circuit card.
!Overheating of the SCR or freewheeling diode.
!Physical damage to the printed circuit card, housing or components.
!Unauthorized repair or alteration of printed circuit card.
!Installation by anyone other than a qualified professional generator service technician.
!Conductive or corrosive contamination of the circuit card.
!Removal of our company identification from the product.
!Removal of any conformal coating of the printed circuit card or components.
!Overheating of foil on the printed circuit card.
!Inappropriate or infeasible application
!Use on any external device other than manufactured by Power-Tronics, Inc.
No other warranty is expressed or implied.