Powerlink PL-2301A User manual

Powerlink
IEEE 802.11 b/g/n 2.4GHz Wireless Signal Booster
Quick Installation Guide
Part# : PL-2301A
Model Name : Amplus

Overview:
This device can add strength of the radio signal to increase the effective
range and the coverage area for Wi-Fi communication. Simply remove the
AP/Router RP-SMA antenna and plug it into the booster female RP-SMA
connector. This may even penetrate complex environments with many walls
and obstacles. The benefit for theAmplifier is to save the wiring costs and easy
to build wireless infrastructure for home and business.
Package contents:
Indoor Wireless Amplifier Unit
30cm RG316 cable
Quick Installation Guide
Power Supply
5dBi Antenna
SMA to TNC Adapter (SMA-Male to TNC-Female)
Specifications:
Operating Range
2400-2500MHz
Operating Mode
Bi-directional, hale-duplex, time division
duplex senses RF carrier from transmitter
and automatically switch receiving to
transmitting mode
Connector Type
SMA Receptacle(50 ohm) or TNC
Input power
8~17dBm (Warning: Input power more than
17dBm that power amplifier may breakdown)
Transmit Gain
10-16dB
Output power
1.0W Max
Receiver Gain
≤14dBm
Noise Figure
3.5dB
Frequency Response
±1dB over operating range
Power Adapter
5-6V 1A /DC 105-240V for AC adapter
Operating Temp.
-20 to +70°C
Operating Humidity
Up to 95% relative humidity
Material
Cast Aluminum
ALC Control Limit
30dBm
Transmit indicator LED
Green: downlink active
Red: uplink active
Green and Red flash: downlink and uplink
both are working*
Power and ALC indicator LED
Green on: ALC inactive

Green flash: ALC active (warning)**
Red on: Power is working normally
Red off: No power or device not working
Booster Dimension
8.5cm(L)*5.6cm(W)*2.6cm(H)
Package
22cm(L)*15cm(W)*4cm(H)
* When Transmit indicator LED "Green and Red are flashing", it means the
device is working properly.
**When Power and ALC (Auto Limit Control) indicator LED is "flashing Green",
it is a warning sign for over loading. it might cause overheat and damage of the
device. Please disconnect the device such as Router orAP.

Installation procedures:
Please follow the steps 1~4 to install the device. When disconnect, please
unplug the power adapter first.
For questions, please visit our website www.premiertek.com
Ver. 0712