PowerShield PSMBS2K User manual

1. Introduction
The PowerShield Maintenance Bypass Switch (PSMBS) is used as an external power
distribution unit in conjunction with UPS systems or large-scale voltage regulators. It allows
for the manual transfer of connected equipment to utility power via a bypass switch,
permitting scheduled maintenance or UPS replacement without power interruption.
Rack Mount/Wall Mount the Unit
The module can be mounted to a 19” enclosure or wall. Please follow the chart below for
rack/wall mount installation.
Chart 1: Rack mounting Chart 2: Wall mounting
Tower Installation
This module also can be placed on the desk as tower unit. Please follow below steps to install the
module attached to the UPS.
Step 1 Step 2 Step 3
2. Product Overview –PSMBS 2K / PSMBS 3K
PSMBS 2K
Output receptacles Bypass switch
Socket to UPS output AC input
Socket to UPS input Circuit breaker

Wall
PSMBS 3K
UPS
UPS
UPS
Bypass
Module
Bypass
Module

3. Installation and Operation
Inspection
Remove the unit from the shipping package and inspect it for damage that may
occur during transportation. Notify the carrier and place of purchase if any
damage is found.
The shipping package contains:
PowerShield Maintenance Bypass Switch (PSMBS) module x 1
Quick guide x 1
Mains power cord x 1
UPS input power cord (blue) x 1
UPS output power cord (red) x 1
Screws and mounting ears
Connect to the Wall Outlet
Use the power cord provided to connect the AC input socket on the PSMBS module to the utility
wall outlet socket.
Connect UPS
Use the power cord provided (Blue), to connect UPS input to UPS input socket on the PSMBS
module. Use the power cord provided (Red) to connect UPS output to UPS output socket on
the PSMBS module.
Connect Equipment
Connect equipment to the output sockets of the PowerShield Maintenance Bypass Switch
module. Please refer to the chart below for equipment connection.
Switch
4. Operation
Transfer to Maintenance Bypass
Before transferring to maintenance bypass, make sure the utility Power is ON. Transfer the
rotary bypass switch from “Normal” to “Bypass”. At this time, all connected devices are
powered by the utility power directly. Turn off the UPS and disconnect the two power cords
connecting to the UPS. Commence service and maintenance of the UPS.
Transfer to UPS Protection
After maintenance service is done, make sure the UPS operation is normal. Then, reconnect
the UPS to the PowerShield Maintenance Bypass Switch module by following the previous
Installation Section. Then transfer the rotary bypass switch from “Bypass” to “Normal”. Now,
all connected devices are protected by the UPS.
5. Important Safety Warning (SAVE THESE INSTRUCTIONS)
To safely operate this PSMBS module, please read and follow all instructions
carefully. Read this manual thoroughly before attempting to unpack, install, or
operate. Safely store this quick guide for further reference.
CAUTION: The product must be used indoor only.
CAUTION: Do not place the unit near liquid or in an excessively damp environment.
CAUTION: Do not place the product directly in the sun or near a hot source.
CAUTION: Do not let liquid or foreign objects enter the product.
CAUTION: Ground the product using a 2P + ground sockets.
CAUTION: When installing the product, ensure that the sum of the leakage currents of the
product and the devices it supplies not exceed 3.5mA.
Computer
Monitor Printer
Online UPS
16A/16A or
10A/10A