PowerTraveller SOLARMONKEY ADVENTURER User manual

SOLARMONKEY
ADVENTURER
USER GUIDE
™
IN THE BOX:
PROTECTIVE
STORAGE CASE
USB TO
DC CABLE
SOLAR PANELS WITH
MPPT TECHNOLOGY
HOT/COLD
BATTERY
INSULATION
-10°C TO 90°C
3500MAH SOLAR
COMPATIBLE
INTERNAL
BATTERY
CARABINER
MICRO USB
TO DC TIP
4 COLOUR LED
LIGHT INDICATOR
DC INPUT
USB OUT
POWERTRAVELLER LIMITED
Ceratech House, Omega Park,
Wilsom Road, Alton,
Hampshire GU34 2QE, UK
t [phone]
[e-mail]
[e-mail]
www.powertraveller.com
/powermonkeys @powermonkeys
PowertravellerLtd powertraveller

QUICK START
CHARGE DEVICE
RECHARGING
SOLAR
RECHARGING
USB
Connect the included USB cable to the solarmonkey
adventurer attach the correct tip and connect to a device.
If the connector for your device is not included,use the
device’s own USB charging/sync cable to connect to the
solarmonkey adventurer. The unit will automatically detect
the device and start charging. The unit can charge a
device open whilst being charged by the sun or closed
not in sunlight from the internal battery.
LED LIGHT INDICATORS
Open up the solarmonkey adventurer and place in direct
sunlight. The unit features low voltage battery protection
meaning it will charge devices whilst being charged,
providing there is adequate sunlight and internal battery
reserve. If the unit doesn’t charge your device, leave it
connected as the solarmonkey adventurer will
automatically start charging your device when sunlight
and internal battery reserve improves. Alternatively, leave
just the adventurer unit out to solar charge and collect
power in the internal battery which you can then use to
charge your devices when you need it.
Attach the USB charging cable into any 5V USB
output device (e.g. smartphone AC mains with USB,
in-car USB or laptop USB). Connect the other end of the
USB cable into the solarmonkey adventurer (see image
below).You can charge your devices from the solarmonkey
adventurer while the unit is being recharged from the USB.
The solarmonkey adventurer features a 4-colour LED
light to show the level of charge left in the internal battery.
0-25% 25-50% 50-75% 75-100%
When solar charging, the LED will scroll through all 4
colours in succession. The light will then flash in the
colour indicating the level of power stored in the battery
reserve.
When charging from the solarmonkey adventurer to a
device, all 4 colours will show in succession. The light
will then become static and stay on the colour to show
how much power is held in the internal battery.
TECHNICAL SPECIFICATIONS
�3500 mAh internal battery(12.95Wh)
�Solar/DC input: 5V
�Solar panel output: USBport: 5V 600mA
�Internal battery output: 5V 2A
�Weight: 265g (unit only)
�Dimensions when folded: 170 x 96 x 22.75mm
with 2mmsafety gap between solar panels
Othertipsare
available to buy at
powertraveller.com
“Made for iPod,” “Made for iPhone,” and
“Made for iPad” mean that an electronic
accessory has been designed to connect
specifically to iPod, iPhone and iPad,
respectively, and has been certified by
the developer to meet Apple performance
standards. Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards. Please note
that the use of this accessory with iPod or
iPhone may affect wireless performance.
iPad, iPhone, iPod, iPod nano and iPod touch
are trademarks of Apple Inc., registered in the
U.S. and other countries.