
• S ould you experience any malfunction or damage to t e mains cable, disconnect from t e mains supply
immediately and consult a qualified engineer.
• All parts s ould be replaced wit genuine spare parts and carried out by a qualified engineer.
Contents & Unpacking:
Before beginning your initial setup c eck t e unit as not been damaged in transit. In t e event t ere is
damage to t e ousing, cable or internal components contact your dealer immediately. T e loudspeaker is
supplied wit a remote control and power cable.
Specification:
Code: MP15B
Mains Supply: 230Vac 50Hz
Power: 200 Watts Max
Battery: Internal
Mic Input: Jack/XLR 10mV
Radio Mic: Range 50 Metres Approx Unobstructed
Aux: RCA/3.5mm Jack 100mV
Mix Output: RCA 100mV
EQ: +/- 12dB
Bluetoot : 10 Metres Range Approx
Removable Memory: USB & Standard SD
Dimensions: 440 x 690 x 350mm, Stand Fitting 35mm
Weig t: 17kg
First Time Operation:
• Before you start using t is system, please c eck t ere is no transportation damage, s ould t ere be
any, please do not use t e device and contact your dealer immediately.
• Set all t e level controls to minimum. (2,6)
• Plug in an SD or USB card wit suitable music files in MP3 format. (1)
Alternatively connect a microp one to t e microp one socket (7) or external sound source to one of t e
line input connections. (10,11)
• Connect t e System (s) to t e mains supply (22) and switc on t e power at t e wall socket and on t e
rear of t e loudspeaker. (21)
• Allow a few moments for t e electronics to initialise
• T e power on indicator will illuminate on t e rear control panel (20) and t e battery c arge indicator will
illuminate w en its c arging. If you disconnect t e mains power t e system will work from its internal
battery for around 5 ours under normal use from a fully c arged battery.
• T e PA System is ready to use
• Advance to level control on t e microp one and or auxillary input to a suitable level.
•You can also c oose to use one or bot of t e radio microp ones at t is point, to do so, extend t e
telescopic aerials (16,17), switc t e microp one switc to on (15) and turn on one or bot and mics. T e
RF lig ts will illuminate (12,13) t en advance t e level controls (12,13) to t e desired level.
• T e Ec o control can be advanced to introduce ec o onto t e microp one c annels (5)
• You can turn on Microp one priority wit a separate switc , t is will make t e music sound level reduce
w en speeking t roug t e microp one.
• To start t e MP3 player select t e correct mode, select a track, press t e start button and turn up t e level
control (13) to t e desired level.
• You can can control t e player remotely wit t e small and remote control. Point t e controller at t e
front of t e cabinet for best effect.
• To connect a bluetoot player select BT by pressing t e player mode button and pair t is device wit your
remote bluetoot source, suc as a p one. W en to two devices are connected t e control (2) will set t e
desired volume level.