PRASTEL MPSTP2EB User manual

MPSTP2E
B
ENGLISH
MPSTP2EB_V0.doc
Member of: Associated
CAUTION FOR THE USER
Any change or modification of the product is forbidden if not expressly
approved by the manufacturer
0. DESCRIPTION
MPSTP2EBis a radio transmitter used with radio receivers of the Multipass and Roll series. It has two
pushbuttons being capable to activate two different output channels on a radio receiver working with the same
code and the same operating frequency.
It works on 433.920 MHz frequency regulated by a SAW oscillator. It is provided with an integral antenna. It is not
possible to transmit continously with MPSTP2EB.
1. APPLICATIONS
It can be used in remote control applications as door opener and in control access applications.
2. TECHNICAL FEATURES
Transmission frequency 433.92 MHz (radio section) – 125 kHz (transponder section)
Type of code rolling code
No. Of channels 2 (radio) + 1 (transponder)
Power supply 6V (two 3 V lithium battery)
Power consumption Negligible when not operating, 15mA for transmission
Duration of transmission 2 sec (radio transmission)
Signalling devices red LED

MPSTP2E
B
ENGLISH
MPSTP2EB_V0.doc
Member of: Associated
3. HOW TO PROCEED WHEN CHANGING THE BATTERY
HOW TO CHANGE THE BATTERIES:
•Loosen screw «A» as shown in Fig. 1.
•Open the remote control.
•Remove the batteries handling them as shown in Fig. 2.
•Fit new batteries taking care of aligning polarity correctly (see
Fig. 4).
LITHIUM BATTERY
3V
B
FCC ID: ON3MPSDT2
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FIG. 1
FIG. 4
FIG. 2/1
A
FIG. 2