Prem-I-Air Elite 685HEPA User manual

Air Purifier Model: 685HEPA
Please read this instruction manual CAREFULLY & in
FULL before operating and store in a safe place for
future reference

GENERAL INFORMATION
Introduction
Please DO NOT dispose of any packaging until you have checked the
appliance is operational.
After removing the packaging ensure the contents are intact and complete.
In the unlikely event of missing parts; contact your retailer.
DO NOT leave children unattended with any of the packaging since it is a
potential source of danger. Disposal of all packaging must be carried out
responsibly & safely and in accordance with your local authority regulations.
ALWAYS recycle the packaging material where possible.
Thank you for purchasing this Prem~I~Air 685HEPA air purifier. When used
correctly the surrounding air quality in your home or workplace can be
substantially improved & your appliance will help reduce house dust, pet
hairs, bacteria, mold spores, pollen, viruses, odours & V.O.C’s (Volatile
Organic Compounds).
1

Important Safety Instructions
1.Basic safety precautions should always be observed when operating
electrical appliances.
2.Caution should be observed when operating the appliance near
children, the infirm or pets.
3.DO NOT place objects on the appliance or obstruct the air inlet or air
outlet.
4.Operate the appliance on an even & level surface.
5.This appliance is not intended for use in wet or damp areas.
6.ALWAYS operate the appliance from a power source of the same
voltage & frequency in accordance with the identification plate.
7.DO NOT operate the appliance in areas where flammable liquids or
chemicals are used or stored.
8.DO NOT operate the appliance with a damaged power cord or plug or
after the appliance malfunctions or becomes damaged in any way.
9.DO NOT attempt repairs to the appliance; refer to a qualified service
centre.
10.DO NOT attempt to modify the appliance in any way.
11.DO NOT run the power cord under carpet or rugs.
12.DO NOT use mains extension cords.
13.To clean the appliance ensure the power is turned OFF & the plug is
removed from the power outlet socket. Use a soft, damp, lint free cloth.
14.This instruction manual is an integral part of the appliance and should
be stored for safe keeping and must always accompany the appliance
in the event of ownership transfer or for reference to by a service
engineer.
GENERAL INFORMATION
2

ASSEMBLY INSTRUCTIONS
3
WARNING
DO NOT ATTEMPT TO OPERATE THIS APPLIANCE WITHOUT FIRST
SECURELY FITTING THE BASE, USING THE FIXING SCREWS IN THE
BAG PROVIDED.
Please note: on the base plate are
three circular pegs & one semi-
circular peg. (see opposite).
On the underside of the main
appliance are located three circular
holes and one semi-circular hole
(see opposite).
It is important to line up the semi
circular peg with the semi circular
hole for the base plate to be fixed to
the main appliance correctly. Once
located correctly, use the two fixing
screws to secure the base to the
main appliance.

OPERATING INSTRUCTIONS
4
ON/OFF
FAN SPEED
ANION
(IONISER)
TIMER
FAN SPEED
INDICATOR L.E.D’s
TIMER
INDICATOR L.E.D’s
Control Panel Layout
ANION (IONISER)
INDICATOR L.E.D
POWER
INDICATOR L.E.D

OPERATING INSTRUCTIONS
5
Remote Controller layout
POWER ON/OFF
ANION ON/OFF
(IONISER)
FAN SPEED
TIMER
INFRARED RECEIVER

OPERATING INSTRUCTIONS
6
Insert the BS three pin plug into the mains socket outlet.
POWER
Press the ON/OFF to switch the appliance on (the ‘POWER’ L.E.D on the
control panel will illuminate green).
FAN SPEED
The fan will start at low fan speed. Press the fan button for medium fan
speed, press again and the fan will run at high fan speed. At each selection
the corresponding L.E.D will illuminate.
LOW(L) MEDIUM(M) HIGH(H)
TIMER
With the appliance switched ON, Press the TIMER button to select 2
hours(2H). Press the timer button again to select 4 hours(4H). Press again
to select 8 hours(8H). The timer button is a count down to switch the
appliance operation OFF. At each selection the corresponding L.E.D will
illuminate.
2hour (2H) 4hour (4H) 8hour (8H)

7
OPERATING INSTRUCTIONS
ANION (IONISER)
Press the ANION button to switch the negative ion generator ON or OFF.
The ANION L.E.D will illuminate with the function ON.
INFRARED REMOTE CONTROL
All of the functions can be operated via the Infra Red remote control. The
L.E.D function will illuminate on the control panel with each function selected.

FILTRATION SYSTEM
8
Filter system
Stage 1 – Prefilter
The Prefilter removes large particle contaminates
& helps to extend the life of the HEPA filter.
Stage 2 – HEPA (High Efficiency Particulate Air) filter
Your HM685 HEPA uses an absolute HEPA filter
which captures 99.97% of contaminates as small
as 0.3microns. These include dust & dust mites,
pollen, animal dander & smoke etc.
Stage 3 – Active Carbon
Active carbon is charcoal that has been treated
with oxygen to open millions of pores between the
carbon atoms. These pores absorb harmful gases
and odours.
ANION
An ioniser is a device that adds a negative charge
to molecules of air. A negatively charged ION that
has more electrons than protons in its nuclei is
known as an ANION and these help to reduce
airborne contaminates. Virtually all particles in the
air have a positive charge and therefore attract the
negative ions which become attached. As more &
more negative ions attach themselves to the
particles they become too heavy to remain
airborne & fall out of the air, preventing inhalation
into the respiratory system.

9
MAINTENANCE INSTRUCTIONS
Access & removal of the filter cartridge
Pressing the button marked ‘OPEN’
on the front face of the appliance
makes access to the filtration
cartridge (see opposite).
The control panel will lift up and the
filter cartridge will be visible.
Take hold of the handle & lift in an
upward direction until the filter
cartridge is completely removed
from the appliance (see opposite).
Please note the INSTALLATION
ADVICE that identifies the correct
installation of the filter cartridge (see
opposite).

TECHNICAL DATA
10
POWER SUPPLY: 230volts 50Hz
POWER CONSUMPTION: 48watts
WORKING TEMPERATURE: 0°C ~ 40°C
WORKING HUMIDITY: ≤95%RH
MAX NOISE LEVEL: 30dB
MAX AIRFLOW RATE: 200m³h / 117.8 c.f.m
PROTECTION CLASS: II
EFFECTIVE AREA: 40m²/ 430ft²
NETT WEIGHT: 8kg / 17.64lbs
DIMENSIONS: 679mm x 184mm x 185mm
BASE DIMENSIONS: 260mm diameter
The HM-685 air purifier has a built-in anti-tilt mechanism that will disrupt
the power to the appliance if it is tilted or turned on its side.

TECHNICAL DATA
11

12
SERVICE & WARRANTY
•Do not operate the unit with a damaged cord or plug, after the unit malfunctions, has been
dropped or damaged.
•For your convenience, record the complete model number and product name (located on the
Product Identification Plate), the date you purchased the product, and attach your purchase
receipt as proof of purchase.
•To ensure your product is covered by warranty, the complete faulty product together with your
purchase receipt should be returned to your retailer.
TWO (2) YEAR LIMITED WARRANTY
Save This Warranty Information
EHS (International) Ltd. Guarantees this product free from defects in materials and
workmanship for a period of two (2) years.
Should this unit be operated under conditions other than those recommended, at voltages
other than the voltage indicated on the unit, or any attempts made to service or modify the unit,
will render this WARRANTY VOID. The product you buy may sometimes differ slightly from
illustration. This warranty is in addition to, and does not affect, your statutory rights.
Should you have a problem with this product, please call our Help Desk on: [phone]
This product has been manufactured to comply with EEC Directives 2006/95/EG and 89/336/EEC
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist.
Check with your Local Authority or retailer for recycling advice.
EHS, Manchester, M17 1RN EHS04/08