Prince Castle Bagel Saber 970 Series User manual

Model No. 970 Series
Bagel Saber™
Operating
Instructions
355 East Kehoe Blvd. • Carol Stream, IL 60188 USA
Telephone: [phone] • Fax: [phone]
Toll Free: 1-800-PCASTLE
www.princecastle.com
970-506revB-EN Printed in USA 1/07 © 2007
Prince Castle’s model 970 Series Bagel Saber™ is
designed to give you a perfectly sliced bagel quick and
easy every time. Place a whole bagel in the Bagel
Saber, and with one forward stroke, you get two
perfectly sliced bagel halves. Stainless steel
construction ensures long, reliable service. The sturdy
frame sits flat on any counter for safe and stable
operation. A built-in table stop ensures the unit won’t
budge while in use. Precise, sharp, replaceable
stainless steel blades deliver a clean cut with every
stroke.
TABLE OF CONTENTS
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Replacing Blades. . . . . . . . . . . . . . . . . . . . . . . . . . 3
Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Daily Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . 3
Exploded View. . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
LIMITED WARRANTY
This product is warranted to be free from defects in material
and/or workmanship for a period of 1 year from date of
original installation, not to exceed 18 months from the date
of manufacture.
Any component which proves to be faulty in material and/or
workmanship will be replaced or repaired (at the option of
Prince Castle, Inc.) without cost to the customer for parts
and labor. The equipment is portable; charges for on-
location service (e.g., trip charges, mileage) are not
included in the provisions of this warranty.
This warranty is subject to the following exceptions/conditions:
• Use of any non-genuine Prince Castle parts voids this
warranty.
• All labor to be performed during regular work hours.
Overtime premium (the incremental amount) will be
charged to the customer.
• Damage caused by carelessness, neglect and/or
abuse (e.g., dropping, tampering or altering parts,
equipment damaged in shipment, by fire, flood or an
act of God) is not covered under this warranty.
• All problems due to operation at voltages other than
that specified on equipment nameplates are not
covered by this warranty. Conversion to correct
voltage is the customer’s responsibility.
• This equipment must be serviced by Prince Castle
Authorized Service Agency or a Prince Castle Service
Technician during the warranty period.

Printed in USA 1/07 © 2007 2 970-506revB-EN
INSTALLATION
1. After you have removed the Bagel Saber™ from
the carton, inspect the unit for signs of damage. If
there is damage to the unit:
• Notify carrier within 24 hours after delivery.
• Save carton and packing materials for
inspection purposes.
• Contact your local dealer, or if purchased
directly, the Prince Castle Customer Service
Department at 1-800-722-7853 to arrange for a
replacement to be sent.
2. Verify that all parts have been received.
3. Clean Bagel Saber before using.
4. Prince Castle offers an optional Bagel Catcher
model 970-097 which is designed to work with the
Bagel Saber™ to neatly catch bagel halves. See
figure 1.
figure 1
5. To attach the Bagel Catcher, place it up to the far
end of the unit, and slide the open end of the
catcher against the rear opening of the slicer. See
figure 2.
figure 2
IMPORTANT:
Bagel Catcher is optional and sold
separately.
OPERATION
CAUTION
Blades are extremely sharp. Keep fingers away from
blades.
IMPORTANT:
The Bagel Saber™ is designed to slice
bagels only. Using it to slice other products will
damage the slicer and void the warranty.
1. Place the Bagel Saber™ on a clean, flat prep
table or counter.
2. Set the table stop against the front edge of the
table.
3. Firmly grasp the black stabilizer knob on the
cover, and with your other hand, pull back the
white pusher plate handle. See figure 3.
figure 3
4. Insert the bagel against the pusher plate. See
figure 4.
figure 4

970-506revB-EN 3 Printed in USA 1/07 © 2007
5. Grasp the white pusher plate handle and push the
bagel through the blades with a quick, firm stroke
until it is completely sliced. See figures 5 and 6.
figure 5
figure 6
6. Sliced bagel will exit the unit from the rear
opening. See figure 7.
figure 7
REPLACING BLADES
CAUTION
Blades are extremely sharp. Keep fingers away from
blades.
IMPORTANT:
For safety, it is important to remove and
discard one blade at a time.
1. Turn unit over.
2. Remove first blade by unscrewing the two
thumbscrews holding blade to base assembly.
3. Carefully slide blade out through side slot and
discard blade.
4. Remove second blade by repeating steps 2
and 3.
5. To install first blade, slide sharp edge of blade
through side slot. Align holes and tighten with two
thumbscrews.
6. Repeat step 5 to install second blade.
CLEANING
CAUTION
Blades are extremely sharp. Keep fingers away from
blades.
1. Spray slicer with hot water to remove any bread
crumbs or residue.
2. With hot, soapy water, scrub slicer and blades
using a nylon brush.
3. Rinse slicer with hot water.
4. Let air dry.
DAILY MAINTENANCE
IMPORTANT: After every washing be sure to lubricate
the Guide Rods using Petro-Gel or Taylor Lube.
IMPORTANT: Be sure to check the blade screws for
tightness, if loose use pliers to tighten.

Printed in USA 1/07 © 2007 4 970-506revB-EN
EXPLODED VIEW
PARTS LIST
Item Part Number
1 970-034
2 970-011S
3 970-023S
4970-054S
562-037S
6970-019S
970-068S
*
76-705S
Description
Replacement Blade Set
Guide Rod (Pkg. of 2)
Pusher Bracket w/Hardware Assy. (Includes Item 3)
Cover w/Knob
Bearing Kit (Pkg. of 2)
Adhesive Feet (Pkg. of 4)
Suction Cup (Pkg. of 4)
Blade Retention Thumb Screws (Pkg. of 4)
* Part Not Shown.
1
2
35
4
6